My 2021 Jeep Wrangler Rubicon (3.6L eTorque, automatic transmission) has had recurring drivetrain instability since about 2,000 miles while under factory warranty. It intermittently has high RPM flare during acceleration, delayed shifting, shuddering under load, and abrupt engagement. At low speeds (about 10–5 mph), it harshly downshifts, grabs suddenly, RPMs jump up and down, and it can feel like it will stall; it has stalled intermittently. Braking feels inconsistent, and at times it feels like the vehicle resists braking or surges before slowing. The forward collision warning/automatic emergency braking has activated with no obstacle present, and the power steering assist has been lost intermittently. There is also an engine tick and a high-pitched whining noise from the engine/drivetrain area. In January 2026, the transmission catastrophically failed and required replacement of the transmission, torque converter, cooler, and control module. The vehicle was out of service for over 24 days. After installation of a new Mopar remanufactured transmission and torque converter, the same symptoms returned. AAMCO has now found that the new torque converter failed, with metal shavings throughout the transmission, in the fluid, and at the bottom of the pan. I was advised that the vehicle should be sent to a Jeep dealership because no codes are currently present. I was also advised that the dealership may replace only the torque converter rather than the entire transmission, despite recurring failure and metal contamination. This presents a safety concern due to loss of acceleration, unpredictable torque engagement, stalling, unintended braking activation, power steering loss, engine/drivetrain noise, and repeated drivetrain failure. I have all the records if requested, file is too large to send in the upload area.
2021 Jeep Wrangler: false forward collision warnings
5 of the 962 complaints about the 2021 Jeep Wrangler describe false forward collision warnings.
- owner complaints
- 5
- of this car's complaints
- 1%
- recalls
- 2
False forward collision warnings by model year
- 20246
- 20215
- 20202
- 20192
What owners say
My 2021 Jeep Wrangler Rubicon (3.6L eTorque, automatic transmission) has experienced recurring drivetrain instability beginning at approximately 2,000 miles while under factory warranty. The vehicle intermittently exhibits a high-RPM flare during acceleration, where the engine speed increases without a commensurate increase in vehicle acceleration. The transmission then abruptly engages, causing sudden jerking. At low speeds (approximately 10–5 mph), the vehicle shudders and harshly downshifts, creating a sudden grabbing sensation. Engine RPMs fluctuate during deceleration as if the transmission cannot smoothly match engine speed. Braking feels inconsistent, and at times it feels as though the vehicle is accelerating or resisting braking input before abruptly slowing. The vehicle has felt as though it would stall at low speeds and has stalled intermittently. Additionally, the forward collision warning / automatic emergency braking system has activated without an obstacle present. There have also been intermittent instances of loss of power steering assist. The engine has developed a ticking noise and a high-pitched ringing/whining sound from the engine area during operation. In January 2026, the transmission catastrophically failed and required replacement of the transmission, torque converter, cooler, and control module. The vehicle was out of service for over 24 days. Following installation of a Mopar remanufactured transmission and torque converter, the same symptoms have recurred, including RPM flare, delayed shifting, shuddering, harsh downshifts, unstable deceleration, and abnormal engine noises. These conditions present a safety concern due to loss of expected acceleration, unpredictable torque engagement, unintended braking activation, intermittent power steering loss, stalling behavior, and drivetrain instability. The vehicle is currently under further diagnostic evaluation. I have multiple documents, but the file is too large to upload
I had the most recent incident driving Westbound in the evening hours shortly before Sunset around October 10, 2024. It appears the sunlight from the setting sun triggered my adaptive cruise control and forward collision alert and triggered an alarm sound and activated emergency braking at the same time. I have had two previous incidents like this. One at the exact same location on my commute home at around the same time and maybe a week before. A third occurrence was on an Eastbound morning drive with the rising sun. All three incidents triggered emergency braking from a speed of ca. 65mph. I was able to react fast enough to deactivate the ACC by lightly pushing the brake pedal and could avoid serving or complete stopping of the vehicle. Luckily during all incidents I had no close traffic behind me, otherwise the incidents could have caused a rear end collision.
The contact owns a 2021 Jeep Wrangler. The contact stated that while driving at various speeds, the vehicle stalled with the output control and collision warning lights illuminated. The contact had taken the vehicle to the dealer on numerous occasions; however, the mechanic was unable to determine the cause of the failure. The manufacturer was not notified of the failure. The vehicle was not yet repaired. The failure mileage was 23,915.
There is an option to engage "Full Regen Mode" to recharge the battery while driving in Hybrid mode. As I was driving with this on, i took my foot off the accelerator, so the vehicle slowed down under "Full Regen Mode" as it is supposed to. But then the front tires went over a pothole/break in the road, and the vehicle sped up instantly. This happened two more times, and in both instances the vehicle sped up on its own when it encountered a break in the road while on "Full Regen Mode" with my foot off of the accelerator. The third time was in a parking lot of a strip mall, where I would have crashed into the car in front of me if my foot was not already hovering over the brake pedal. The Advance Collision Warning system also went off, scaring everyone nearby, and I managed to brake hard. Now I have stopped using the "Full Regen Mode" option while driving in Hybrid mode.
Service bulletins that may apply
- Customer complaints regarding rear view camera inoperative or flickering blue radio screen display while...
- Front and Rear Axle Sensor Kit Customers may experience a Malfunction Indicator Lamp (MIL) illumination
- Squeak Noise From Dash Area When Turning The Steering Wheel.
- Rocker arm assy - roller rocker
- Radio Over The Air Updating to QR40.12 Software Version Mobile Wi-Fi inoperative upon start up. ? Hotspot...
- Adapter
- Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates Customers may...
- Radio Over The Air Updating to 40.12 Software Version Mobile Wi-Fi inoperative upon start up. Hotspot...
Related recalls
Back over prevention: sensing system: camera
- What is wrong
- Chrysler (FCA US, LLC) is recalling certain 2018-2024 Jeep Wrangler vehicles. The wiring harness for the rearview camera and the center brake light may short circuit, which can disable the rearview camera image and center brake light. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard numbers 111, "Rear Visibility" and 108, "Lamps, Reflective Devices, and Associated Equipment."
- Risk
- A rearview camera image that does not display decreases the driver's visibility, increasing the risk of a crash. Additionally, a center brake light that fails to illuminate can fail to indicate to other drivers that the vehicle is slowing down, increasing the risk of a crash.
- Remedy
- Dealers replaced the harness for the center brake light and rearview camera and/or the spare tire carrier/harness assembly, as necessary, free of charge. All vehicles were repaired by January 15, 2024. Owner notification letters were mailed September 26, 2024. Owners may contact FCA US, LLC customer service at 1‑800‑853‑1403. FCA US, LLC's number for this recall is 77B.
Recall number 24V676000 · Recall details
Back over prevention: display function
- What is wrong
- Chrysler (FCA US, LLC) is recalling certain 2020-2021 Jeep Wrangler, RAM 1500 and 2021 Jeep Gladiator vehicles. A radio software error may prevent the rearview image from displaying. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
- Risk
- A rearview camera that does not display an image reduces the driver's rear view, increasing the risk of a crash.
- Remedy
- Dealers will update the radio software, free of charge. Owner notification letters were mailed October 6, 2022. Owners may contact FCA US, LLC customer service at 1‑800‑853‑1403. FCA, LLC's number for this recall is Z86.
Recall number 22V638000 · Recall details
Questions about the 2021 Jeep Wrangler collision warning
Is false forward collision warnings a common problem on the 2021 Jeep Wrangler?
5 of 962 owner complaints about the 2021 Jeep Wrangler (1%) mention false forward collision warnings. The model year with the most reports is 2024.
Is there a recall or service bulletin for this on the 2021 Jeep Wrangler?
There are 2 recalls and 62 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2021 Jeep Wrangler
Check engine light 82Loss of power 75Stalling 43Fire or smoke 34Overheating 32Warning lights 26Jerking 24Pulling 23Power steering loss 21Won't start 21Fuel pump 17Backup camera 16Ball joint 16Adaptive cruise 12Hesitation 12Engine failure 11Shudder 10Won't shift 10ABS 8No deployment 8Grinding brakes 7Steering lock-up 6Sudden acceleration 6Knocking 5Fuel gauge 5Fuel leak 5Harsh shifting 5Seat belt 5Start-stop 5Wipers 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2021 Jeep Wrangler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history