2008 Mercedes Benz C350 technical service bulletins
132 technical service bulletins and manufacturer communications cover the 2008 Mercedes Benz C350, including one warranty extension.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Visibility/wiper
- Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is...
- Clanking noise from the area of the speakers in the doors
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Creaking noise, in irregular sequence when driving slowly in combination with slight steering movements...
- There are several types of complaint about noises or poor windshield wiper wiping performance: A: Wiper...
- Potential corrosion on the rear axle carrier
- Headlamp, front fog lamp leaky or fogged
- Headlamp, front fog lamp leaky or fogged
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Headlamp, front fog lamp leaky or fogged
- Headlamps leaking or fogged
- A popup is seen on the HU with the message "data connection temporarily not available". Potentially...
- Potential corrosion on the rear axle carrier
- Vehicle with atypical reduced heat output
- During a phone call, the called party has difficulty understanding/cannot understand the driver, or...
- Creaking noise, in irregular sequence when driving slowly in combination with slight steering movements
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Rear lamps fogged up/not leaktight
- Washer fluid system leaks
- Headlamp or front fog lamp leaky or fogged
- Headlamps fogged or droplets forming
- As previously reported, to enhance the satisfaction of our customers, avoid further costs of litigation...
- Crease formation on genuine leather seat covers in vehicles with low mileage ⢠Objects left on the seats...
- Mercedes-Benz USA, LLC (MBUSA) has extended the warranty for the rear subframe on the vehicles listed...
- The garage door hand transmitter cannot be initialized with the integrated garage door opener in the...
- The range of the integrated garage door opener (GTO) is too short
- After starting the engine, the instrument cluster shows the "EBD not available, diagnosis/test stand"...
- To enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its...
- NTG5.5
- If the customer brakes sharply from a speed of > 30mph, without ABS intervention, there is a single...
- Harsh engagement when changing gear range from P to D or R
- Lamp unit fogged or droplets forming
- To enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its...
- Throttle lift-off clunking noises at drive shafts of front axle
- Throttle lift-off clunking noises at drive shafts of rear axle
- Seat belt extender toothed rack sluggish or makes noises
- Check Engine Light is on with DTC P030185/ P030685 for misfire cylinder 1 and 6.
- Oil in engine wiring harness
- Replace Driver-Side and (if applicable) Front Passenger Air Bag
- Replace Driver-Side and Front Passenger Air Bag
- Ticking or pulsing noise from high-pressure pump and/or fuel injectors.
- Headlamps fogged.
- Anti-theft protection activated".
- Equipment
- Recall Campaign announcement for Takata driver airbags.
- Clunking noise from front axle suspension strut or rear axle shock absorber on short strokes of the damper
- The pneumatic 4-way lumbar support fails
- Noises from flat spring core in backrest
- Pneumatic comfort systems with insufficient performance, entirely inoperative or leaky.
- Noise: A rattling noise may be heard from the area of the chain drive for approx
- A production fault means that the telematics DVD A 166 827 14 00 cannot be used
- Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control...
- The vehicle cannot be started The vehicle may start by itself shortly after the startup attempt with a...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Creaking noise when making vertical or longitudinal adjustment to electrical steering column
- Engine diagnosis warning lamp active
- Battery discharged, vehicle does not start.
- Fault code U41600 logged in 'ES' (electric steering) control unit after software update or steering gear...
- This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by...
- Traces of oil in area of oil cooler (inner V) on engine 642
- The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the...
- Engine diagnosis warning lamp lights up
- This Service Campaign has been initiated because Daimler AG (DAG), manufacturer of Mercedes-Benz vehicles,...
- This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz...
- The Parktronic system switches to malfunction
- Xentry (mercedes): message will appear indicating high beam assist is activated and is inoperative
- Software update of COMAND Online control unit.
- Mobile phone cotacts are not transferred completely.
- The COMAND unit does not start or the display remains dark.
- FC 2783 (Friction power of torque converter lockup clutch is too high) or FC 0741 (Actuation of torque...
- Single, throttle lift-off, clunking noise from the side shaft when starting off (audible at the wheel)
- Customer experiences low battery conditions, resulting in jump starts, and eventually requiring battery...
- Engine diagnosis warning lamp activated
- Fault message in display
- The COMAND unit does not start or the COMAND display remains dark
- Model X204 (GLK 250 BT) with AMG Styling Package 321
- Combination message: "Clean fuel filter" is displayed
- Engine does not start, or various fault messages in instrument cluster immediately after engine start and...
- Mercedes-benz: water and dirt CAN enter the wheel hub causing a grinding noise of the front axle and...
- Mercedes: camshaft adjustment solenoid may leak oil due to settling properties of seal and the engine...
- Xentry (mercedes): an internal issue with electronic steering lock is causing a failure of no cranking,...
- Xentry (mercedes): after ignition is off, rotary light switch sends wrong signal due to battery discharged...
- Xentry (mercedes): the signal light for right rear turn is inoperative
- Mercedes-benz: the malfunction light is on with multiple possible trouble codes stored
- Mercedes benz: engine light is on with stored trouble codes
- Mercedes benz: the turn signal light on the mirror fogs up due to temperature differences
- Mercedes-benz: warning light is on with a stored engine code, because of a software problem
- Mercedez-benz: auto lights inoperative mesage is displayed
- Mercedes-benz: on rough roads there is a knocking noise in the liftgate area
- Mercedes-benz: shock absorber procedure
- Mercedes: check fuel information label
- Mercedes: airbag durability and reliability
- Xentry: exterior lights constantly on. possible components: low beams; front fog lamp; high beams; washer...
- Xentry: steering leaky at internal oil lines. connector of internal oil line or sealing washers/o-rings...
- Mercedes benz: adjust rear lift gate stops
- Mercedes benz: reprogram mbrace (N123/4) dialed numbers to hughes
- Xentry (mercedes benz): replacing exterior light bulbs
- Mercedes: seat belts, emergency tensioning retractors
- Mercedes: fault message in instrument cluster (pre-safe inactive) and fault code 530630 is current and...
- Daimler ag: grinding noises from area of front axle-wheel bearing corroded
- Mercedes: the fuel level indicated in the instrument cluster does not match the actual fill level
- Mercedes: the instrument cluster displaying tire pressure monitor inoperative and there is a corresponding...
- Mercedes: it has been determined that the tele aid may not function properly as a result of a hardware...
- Mercedes vehicle: headlamp is nonfunctional with at least one of the fault codes and/or there is moisture...
- Mercedes vehicle: vehicles fluid leaking from power steering system, may be due to damaged low pressure...
- Mercedes vehicle: the anti-lock brake system (ABS) return flow pump running without control with...
- Mercedes: esp indicator light illuminates in the instrument cluster
- Play in the rack and pinion steering system
- Mercedes: a crack may occur at an underbody cross brace support(s) due to irregularities in the forming...
- Mercedes benz: model 171.454, 456 (2005-2008) slk class; 204.054, 056, 081 (2008) c class; 211.022, 056,...
- Mercedes benz: model 204.054, 056, 081; vehicle does not start, no communication with star diagnosis,...
- Mercedes-benz: headlamp non-functional, possible moisture penetration.
- Mercedes-benz: vehicle does not start, no communication with star diagnosis.
- Mercedes benz model C300, C350 - thumping/knocking noise form the area of the rear axle over bumps
- Check engine light on / fault codes FC1200 / FC1208 stored in me-sfi control unit
- Model C300 & C350, model year 2008 - replace electronic ignition switch
- Fuel gauge reads empty, turn signal lamps pulse quicker, central locking inoperative using key, no...
- SRS light illuminated/DTC 9CFE on model 204 (C300, C350).
- Model C300, C350, model year 2008 - check cross member at rear axle carrier
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Mercedes Benz C350?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history