Mercedes-Benz GLE 350 stalling problems

Filed Sep 23, 2026 · Acceleration, Brakes · NJ

On 8/28/2026, my Mercedes-Benz GLE 350 (W166, M276 engine) experienced a sudden, catastrophic engine stall while driving in active traffic. There was no Check Engine Light (CEL), dashboard warning, or mechanical hesitation prior to the failure. The vehicle instantly lost all propulsion, power steering, and power braking assist, creating an extreme crash hazard and requiring immense physical effort to maneuver the dead vehicle off the roadway. Independent diagnostic teardown by a module specialist confirmed the root cause: an unrepairable internal short circuit between the internal PCB layers of the Engine Control Unit (ECU). Because Mercedes-Benz chose to mount this sensitive electronic module directly to the top of the hot engine block, it is subjected to extreme thermal cycling and vibration. This predictable thermal degradation causes the internal board layers to delaminate and short out. When this internal short occurs, the ECU instantly dies and shuts down the entire vehicle without warning. This is a severe, life-threatening engineering defect. A safety investigation is urgently needed to address the mounting location and thermal failure rate of M276 ECUs before a sudden high-speed stall results in a fatal collision.

Filed Sep 23, 2026 · Acceleration, Brakes · NJ

On 8/28/2026, my Mercedes-Benz GLE 350 (W166, M276 engine) experienced a sudden, catastrophic engine stall while driving in active traffic. There was no Check Engine Light (CEL), dashboard warning, or mechanical hesitation prior to the failure. The vehicle instantly lost all propulsion, power steering, and power braking assist, creating an extreme crash hazard and requiring immense physical effort to maneuver the dead vehicle off the roadway. Independent diagnostic teardown by a module specialist confirmed the root cause: an unrepairable internal short circuit between the internal PCB layers of the Engine Control Unit (ECU). Because Mercedes-Benz chose to mount this sensitive electronic module directly to the top of the hot engine block, it is subjected to extreme thermal cycling and vibration. This predictable thermal degradation causes the internal board layers to delaminate and short out. When this internal short occurs, the ECU instantly dies and shuts down the entire vehicle without warning. This is a severe, life-threatening engineering defect. A safety investigation is urgently needed to address the mounting location and thermal failure rate of M276 ECUs before a sudden high-speed stall results in a fatal collision.

Filed Jun 3, 2026 · Engine · CA

At approximately 87,000 miles, my 2021 GLE350 (M264 2.0T engine) experienced a severe engine misfire resulting in a flashing check engine light, rough idle, engine shaking, significant loss of power, and near-stall condition. The vehicle was taken to Speedhaus Automotive (Newbury Park, CA) where all four ignition coils and spark plugs were replaced. Total repair cost was approximately $635. This failure pattern is consistent with the documented M264 exhaust valve seat wear issue acknowledged by Mercedes-Benz technicians. A Mercedes dealer service report on an identical 2021 GLE350 explicitly states: "COMMON ISSUE FOR EXHAUST VALVE SEATS TO WEAR — KNOWN ISSUE WITH 260 AND 264 MOTORS." Mercedes-Benz has extended the warranty on the M260 engine (transverse variant) for this identical failure mode but has not extended it for the longitudinally-mounted M264 despite the same defect being present. Repair costs for full cylinder head failure on the M264 are being quoted at $6,000–$13,000. I am requesting the federal safety agency investigate whether a safety recall is warranted for the M264 engine across all affected GLE350, GLC300, C300, and E350 vehicles.

Filed May 28, 2026 · Engine · CA

The engine in my 2020 Mercedes-Benz GLE 350 experienced catastrophic internal failure while driving. No warning lights or check engine indicators came on. Prior to failure, the vehicle began making a loud metallic knocking/rattling sound during acceleration, similar to “rocks shaking in a box.” Shortly afterward, the engine suddenly stalled while driving and would no longer run. The vehicle still had electrical power but the engine would not restart. The vehicle was towed to Mercedes-Benz of Las Vegas for inspection. The dealer diagnosed the engine as seized and documented metal debris in the oil filter and oil/metal debris underneath the vehicle, indicating catastrophic internal engine damage. The dealer stated that the engine replacement was required.The failed engine and vehicle are currently located at Mercedes-Benz of Las Vegas and are available for inspection upon request.The vehicle stalled unexpectedly while being driven on a public roadway, causing sudden loss of engine power and creating a potentially dangerous traffic situation. The violent shaking and knocking before failure also caused concern that the vehicle could lose control or stop operating completely in traffic, which it ultimately did. A sudden engine seizure and stall while driving creates a significant safety hazard because the driver may lose the ability to accelerate, maneuver safely, or clear traffic. This could increase the risk of collision, especially at highway speeds or in heavy traffic conditions. Mercedes-Benz of Las Vegas inspected the vehicle and confirmed catastrophic engine failure. The dealer documented that the engine was seized and that metal debris was found in the oil filter and underneath the vehicle. The dealer advised that the engine required replacement and provided an estimated repair cost exceeding $27,000. The dealer has not yet identified the root cause of the failure. No dashboard warning lights, oil pressure warnings, or check engine lights illuminated.

Filed Feb 12, 2026 · Engine · FL

Cooling system failure due to cracked coolant line beneath intake manifold at 57,000 miles. Part # 264-200-42-01. Sudden coolant loss can cause engine overheating and potential engine stall while driving, posing safety risks. The original part was plastic and has been superseded by manufacturer to metal, suggesting design inadequacy. This was confirmed by Mercedes Benz dealership and also by MB USA. There have been multiple reports by other owners online, indicating this has been a common problem on a 2020 GLE 350. There was also an article in Jan 2022 stating that Mercedes had sent a letter to 800,000 owners informing them of a defect, but no there was no recall due to part shortage. https://www.insurancejournal.com/news/international/2022/01/05/648140.htm Yes, dealership has diagnosed it and confirmed this is the problem. There was a warning lamp/message stating low coolant level, which prompted me to take the vehicle to the dealership. Car has been serviced regularly at the Mercedes dealership. Strong risk of overheating.

Filed Jan 8, 2026 · Engine · FL

There is a known issue with the Cylinder Heads on specific models of Mercedes vehicles. Symptoms of M264 Cylinder Head Failure If your GLE 350 is experiencing these symptoms, it may be covered under the extension: Check Engine Light (MIL): Often triggered by misfire codes. Rough Idle: Noticeable shaking or uneven idling when stopped. Loss of Power: Potential stalling or significant power reduction during acceleration. Low Compression: Diagnostic tests often reveal low pressure in one or more cylinders. This is not being addressed my Mercedes USA where Mercedes Canada has offered an extended warranty. Using social media I have comprised a list of over a hundred impacted owners. Many more exist. What this does is cost catastrophic failure of the engine leaving the driver stranded in whatever lanes they were traveling in. I am disabled and for me this created a life threatening situation. When reaching out to MBUSA the answer is simply "not warranty exists" where MB Canada has extended the warranty to an additional 15k miles from notice. My engine blew. The replacement cost is near $20,000 dollars. The mileage on my engine was 65k. Many others are impacted and a class action lawsuit is the only other course of action it seems. Regards, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Oct 24, 2025 · Engine · 69,100 miles · GA

The contact owns a 2021 Mercedes-Benz GLE350. The contact stated that while driving 65-70 MPH, the vehicle was skipping. The contact immediately veered towards an exit ramp. The contact noticed knocking sounds coming from the engine, and the vehicle stalled on the exit ramp. There was smoke coming from underneath the hood. The vehicle failed to restart and was towed to the dealer, where it was diagnosed that the engine had imploded and sustained a hole. The dealer determined that the engine needed to be replaced. Additionally, the dealer took the engine apart and informed the contact that the cause of the engine implosion could not be determined even with the assistance of the engineers. The vehicle was not repaired due to the cost. The contact then brought an independent mechanic to the dealer to inspect the vehicle. The mechanic inspected the engine and informed the contact that the failure had occurred due to a lack of engine oil; however, the contact stated that the dealer had performed an oil change on the vehicle 27 days prior to the failure. The manufacturer was notified of the failure but denied assistance in covering the repair. The manufacturer informed the contact that the engineers had not yet determined the cause of the engine implosion. The failure mileage was 69,100.

Filed Oct 14, 2025 · Transmission · TX

Location: Dallas, TX – Woodall Rodgers Freeway near North Hall Street exit Mercedes-Benz USA Case #: 18469650 What component or system failed or malfunctioned, and is it available for inspection upon request? The vehicle’s 48-volt electrical architecture appears to have failed, specifically the DC/DC converter or Integrated Starter-Generator (ISG) that provides 12-volt power to all control modules. When this component failed, it caused a total loss of propulsion and electrical power. The vehicle is currently at a Mercedes-Benz dealership in Dallas and available for inspection upon request by the federal safety agency or Mercedes-Benz USA (case #18469650). How was your safety or the safety of others put at risk? While driving approximately 50 mph on the Woodall Rodgers Freeway with my family in the car, the vehicle suddenly lost all engine power and throttle response without warning. The accelerator stopped responding, and the engine stalled completely within seconds. I was able to coast partially onto an exit ramp, but once stopped, the car would not restart and could not be shifted into Neutral. We were stranded in live traffic with limited steering assist and no way to move the vehicle, placing my family and other motorists at serious risk of collision. Has the problem been reproduced or confirmed by a dealer or independent service center? The vehicle is currently at a Mercedes-Benz authorized dealer, and the failure has been logged with Mercedes-Benz USA under case #18469650. Initial findings point to a malfunction of the DC/DC converter or 48-volt system. Full STAR diagnostic data and fault codes are pending. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives, or others? Mercedes-Benz USA has been notified and opened case #18469650. The vehicle has been inspected by the dealership’s certified technicians and is awaiting official diagnostic reporting and possible engineering review through Mercedes’ Technical Assistance

Filed Sep 10, 2025 · Engine · NY

My 2020 Mercedes-Benz GLE 350 experienced a complete engine seizure at approximately 60,000 miles without any warning signs. The vehicle shut down and would not restart. The engine is completely inoperable. I am aware of recalls involving engine stalling and fuel system issues in this model, and I believe this may be related to a broader defect. Mercedes-Benz has not offered support as of this writing.

Filed Sep 4, 2025 · Electrical, Fuel system · FL

The fuel pump has been failing and shutting off and has been hesitant when taking off. It can leave you stranded in the middle of the road or if you turn left in front of people the car may stall and can cause a crash. Yes and independent dealer and the dealer both know it’s a problem. I took the vehicle into a Mercedes dealer and the fuel pump had a recall on it and the dealer refused to replace it although I had a engine code that they could pull up referring them to the fuel pump and the fuel pump not priming as it should in every start up. The failure happened a few months ago and I took it in and the dealer drilled a home in the rear of my car and failed to replace the fuel pump, which was covered under the warranty. And the dealer admitted there was water in the trunk area which corroded the fuel pump.