2018 Mercedes-Benz SLC 300 technical service bulletins
88 technical service bulletins and manufacturer communications cover the 2018 Mercedes-Benz SLC 300, including 2 warranty extensions.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Engine
- Engine
- Customer complaints relating to automatic transmission 725.0 (NAG3 Classic /9G‑TRONIC automatic...
- Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is...
- Only vehicles with a variable transfer case are affected
- Clanking noise from the area of the speakers in the doors
- Customer complaints relating to automatic transmission 725.0 (NAG3 Classic / 9G‑TRONIC automatic...
- During part of the steering movement, it feels heavier or more difficult to steer in the same spot every time
- This document is intended as a pre-case diagnostic reference for transmission related concerns
- Mercedes-Benz USA is currently experiencing limited availability of transmission fluid specification ATF...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- The customer requests deactivation of the N112/9 HERMES communication module Note: Deactivation of the...
- After successful commissioning of the HERMES control unit (N112/9) with XENTRY Diagnosis DVD 03/2026, the...
- Dear Mercedes-Benz USA Dealers, The part numbers listed in the chart below should no longer be installed,...
- There are several types of complaint about noises or poor windshield wiper wiping performance: A: Wiper...
- The part numbers listed in the chart below should no longer be installed, and any existing stock must be...
- Headlamp, front fog lamp leaky or fogged
- Headlamp, front fog lamp leaky or fogged
- Headlamps leaking or fogged
- Check engine light on with the following fault is current in the VGS Control Unit: P084300 Oil pressure...
- (Original LI document #: LI27.35-P-079039) Clicking noises from the electro-hydraulic control unit (EHS)...
- Possible complaints about shift quality, issues with learning the park lock, and slipping/rinse entries in...
- After a software update of HERMES communication module N112/9 has been performed on a gray import vehicle,...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Check engine light illuminated Fault code stored in N3/10 control unit- P052E71 – Positive Crankcase...
- Headlamp, front fog lamp leaky or fogged
- Potential corrosion on the rear axle carrier
- Vehicle with atypical reduced heat output
- A clicking/ticking/taping noise from underneath the vehicle with engine off during ECO stop event or after...
- During a phone call, the called party has difficulty understanding/cannot understand the driver, or...
- Fuel door may require several attempts to open
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- After a control unit replacement of "N112/9
- Transmission control unit Y3/8n4 (fully integrated transmission control unit (VGS)) not listed in quick...
- Only vehicles with a variable transfer case are affected
- Washer fluid system leaks
- Check engine light on. One of the below fault codes is current in the engine control module (N3/10)
- Headlamp or front fog lamp leaky or fogged
- Headlamps fogged or droplets forming
- To insure vehicle down time is kept at a minimum and all required information is available when case is...
- Headlamps fogged or droplets forming
- In our continuing efforts to assure the proper performance of Mercedes-Benz products and to enhance the...
- Rear lamps fogged up/not leaktight
- Customer complaints relating to automatic transmission 725.0 (NAG3 Classic / 9G-TRONIC automatic...
- Check engine light illuminated Fault code stored in N3/10 control unit- P052E71 Positive Crankcase...
- Electrical system
- Crease formation on genuine leather seat covers in vehicles with low mileage ⢠Objects left on the seats...
- Fault code P06DA00 is found current or stored in engine control unit
- The "SOS nonfunctional" message appears sporadically in the instrument cluster of the vehicle
- In our continuing efforts to assure the proper performance of Mercedes-Benz products and to enhance the...
- Check engine light illuminated Fault code stored in N3/10 control unit- P052E71 – Positive Crankcase...
- Electrical system
- In our continuing efforts to assure the proper performance of Mercedes-Benz products and to enhance the...
- The garage door hand transmitter cannot be initialized with the integrated garage door opener in the...
- The range of the integrated garage door opener (GTO) is too short
- MY15+ M278 and M157 Equipped Vehicles with Fault Code ""P023400 – Boost Pressure is Too High"" "
- Launch EW NCU
- Incorrect time and/or instrument cluster message "SOS, service not activated" and/or Mercedes Me connect...
- Lamp unit fogged or droplets forming
- Headlamps fogged
- Event memory in the instrument cluster mileage readings intermittently inaccurate
- Information Label on Tire Sealant
- Update engine electronics (ME-SFI) control unit software
- Update Engine Control Unit Software
- Outside mirror folding out/in nonfunctional
- Audio 20: Apple CarPlay displays pixelated image
- Vehicle does not start, battery discharged.
- LED light on thermal cup holder in rear passenger compartment of BR 222 flickers
- Partial operation of interior ambient lighting
- Traffic information service and posibly the voice control, nonfunctional after navigation software update.
- Gasket may settle causing a slight oil leak.
- IPhone mobile phone: Various complaints after software update to iOS8
- Damage to roof frame seal above windshield in area of mounts.
- Outside mirror fogged.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 Mercedes-Benz SLC 300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history