2013 Mercedes Benz Sprinter 2500 problems

Filed Jun 14, 2025 · Acceleration, Brakes · FL

The right rear axle shaft assembly wheel bearing seal failed. The right rear ABS Sensor, aka (rotational Speed Sensor, wheel speed sensor) failed. These parts are available for inspection. The vehicle unexpectedly accelerated without me pressing the accelerator as I approached a red light at an intersection, putting my safety and others at risk. I had to slam on the brakes with all my might to get the vehicle to stop from going through the intersection. The road was wet, and the front wheels locked while the rear wheels continued to be driven by the engine without any input from the accelerator pedal. Eventually, the vehicle stopped, and the engine acceleration went back to normal operation. The problem has not been reproduced or confirmed by a dealer or independent service center. The vehicle and parts have been inspected by me, as the vehicle owner. The warning lamps suddenly illuminated on the instrument panel just prior to the incident. The warning lamps came on as I was approaching the intersection. The warning lamps that came on were the engine diagnostic indicator lamp aka Malfunction indicator lamp, the Anti-lock brake system warning light, the brake assist system warning light, the electronic stability program warning light. I also hear what sounded like the ABS Control Unit rapidly cycling just prior to the uncontrolled acceleration while nearing the intersection. I used diagnostic equipment and performed a visual inspection of the components, concluding that they needed replacement. Grease from the leaking right rear wheel bearing seal fouled the right rear wheel speed sensor. The wheel speed sensor cable develops cracks near the wheel hub. I believe these parts are defective and can cause erratic, uncontrollable, unsafe driving risks that could lead to accidents and injuries. The symptoms and warning indications went away after the parts were replaced. I still have these parts as I feel they should be inspected by the federal safety agency personnel to make a safety recall.

Filed Nov 7, 2023 · Engine · 180,000 miles · GA

The contact owns a 2013 Mercedes-Benz Sprinter 2500. The contact stated that the vehicle was leaking engine oil with the oil warning light flashing on the instrument panel. The manufacturer was notified of the failure and the contact was informed that there were no recalls on the VIN regarding the issue. The vehicle was not diagnosed or repaired. The failure mileage was approximately 180,000.

Filed Jan 11, 2023 · Steering · WA

The electronic steering lock "jams". The only way to get the ignition to turn is to jack up the front tires to release the pressure on the wheels and jiggle the steering wheel while trying to start the car. Even doing this isn't instantaneous. Sometimes you have to physically wiggle the tires left/right while jiggling the wheel. This is well documented on Youtube/other internet sites. This has happened at least 6 or more times and has been taken into the Sprinter Dealer for repair. They couldn't replicate the issue and therefore did nothing.

Filed May 10, 2019 · Body, Electrical · 29,000 miles · NV

Tl* the contact owns a 2013 mercedes benz sprinter 2500. The contact stated that the vehicle failed to engage in reverse. The vehicle was taken to local dealer mercedes-benz of reno (11500 s virginia st, reno, nv 89511, (855) 661-9151) where it was diagnosed that the vehicle was operating as designed. The vehicle was not repaired and the failure continued. The manufacturer had been informed of the failure. The consumer stated after checking the oil and oil filter, the engine froze while driving. It was discovered that the failure was due to a lack of oil. There were no warning lights indicating the vehicle needed oil. The vehicle also lacks enough power to reverse up an incline, such as a driveway.*js the consumer stated the vehicle's have persisted since purchasing the vehicle. The consumer was informed it seems as if the computer was not communicating with the other electrical components in the vehicle such as lighting, torque converter and transmission.

Filed Apr 13, 2018 · Brakes, Engine · 49,092 miles · NY

Tl* the contact owns a 2013 mercedes-benz sprinter 2500. The contact stated that the check engine and tire pressure monitoring indicators illuminated. Additionally, while the emergency brake was engaged, the vehicle moved without warning. The vehicle was taken to mercedes-benz of massapequa (101 east sunrise highway, amityville, ny 11701, (631) 213-2023) where it was diagnosed that the sensors needed to be replaced and the tires needed air. The dealer informed the contact that the emergency brake was working as intended. The vehicle was repaired. The manufacturer was not notified of the failures. The failure mileage was 49,092.

Filed May 12, 2017 · Airbags · IL

Takata recall - it appears that mercedes, like many, remains convinced that they can evade the cost of appropriate repairs by simply stating there is no remedy yet available. However, as a consumer I find this unacceptable. They are side stepping their responsibility and my family is one bearing it. They need to find a solution and implement it. Not only is there an issue of safety, but their lack of a timely solution has economic impacts. I was recently told that I could not receive fair value for a trade a the mercedes dealership due to this recall. The dealer indicated they could not sell the car on their lot due to the airbag issue.

Filed May 2, 2016 · Airbags · MA

Tl* the contact owns a 2013 mercedes-benz sprinter 2500. The contact stated that the recall notice for the federal safety agency campaign number: 16v077000 (air bags) was received in april of 2016. After contacting the dealer and the manufacturer, the contact was informed that the parts needed to repair the vehicle were not available and no estimated time for receiving the parts could be given. The contact had not experienced a failure.

Filed Jul 7, 2015 · Wheels · LA

I have replaced as of today 7/7/2015 -4 rims on my vehicle because they keep cracking/ splitting 1 even had pin holes. Not only is this dangerous to me and wife. But costly as well for the price and sitting 2 days waiting for rim. My entire life I have never of steel rims doing this.