The contact owns a 2020 Nissan Altima. The contact stated that while driving at 55 MPH, the vehicle stalled in the middle of the expressway. The contact turned off and restarted the vehicle, and the engine started knocking significantly. There was no warning light illuminated. The contact was able to slowly pull over to the side of the road. The vehicle was towed to the residence. The vehicle was later driven to the dealer, where it was test-driven. The dealer informed the contact that there was smoke coming from the vehicle, and the engine needed to be replaced. The vehicle was not repaired and remained at the dealer. The contact related the failure to the federal safety agency Campaign Number: 25V437000 (Engine and Engine Cooling); however, the VIN was not included. The manufacturer was notified of the failure, and a case was filed. The failure mileage was unknown.
Nissan Altima knocking problems
89 of the 15,494 owner complaints about the Nissan Altima describe engine knocking or ticking, most of them for the 2002 model year.
- owner complaints
- 89
- worst model year
- 2002
- typical repair cost reported
- $3,000
- typical mileage
- 76,119
By model year
Often reported together
Check engine light 16Engine failure 11Stalling 10Oil consumption 8Ball joint 6Won't start 5Steering noise 4Transmission failure 3
What owners say
The contact owns a 2013 Nissan Altima. The contact stated that the dealer had previously repaired the vehicle under Voluntary Service Campaign: P9324 (Rear Lower Link); however, the failure recurred after the repair. The contact stated that while driving at an undisclosed speed, the steering wheel became loose. The contact experienced a loss of vehicle control, causing the vehicle to sway from left to right. Additionally, there was a knocking sound coming from the rear of the vehicle while driving. The vehicle was taken back to the dealer, but no cause of failure was found. The vehicle was then taken to several independent mechanics who replaced the U-joint, steering column, calipers, shocks, and rear brakes, but the failure persisted. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 91,000.
Nissan needs to do a recall on their rear suspensions. My 2013 Nissan Altima suspension has had some issue AFTER Nissan service bulletin for rear suspension was checked. I believe that the service bulletin that Nissan “did” or “checked“ was replaced with the same faulty parts or not checked correctly. Giving the same issue with the suspension. Prior to the rear suspension bulletin services, l had a control arm snap in half while driving. There was no knocking/ clunking sounds. Just one day it snapped and broke. While my car was being serviced to be fixed, it was at this time I was informed about the rear suspension links. After leaving Nissan that day, my car has STILL not been right to drive. Loose sterling , pulling, drifting- making it impossible to control vehicle. The rear suspension- links/ control arm/ ball joints need to be recalled and replaced.
While driving, my transmission stopped accelerating, and started making a scraping/ticking noise. The car almost cut out in traffic, nearly causing a rear end collision!
I bought the car at 48, 750 miles at 71,000, transmission was sputtering and stalling. Extended warranty from Zurich paid for new parts in an old transmission. Now, car is at 106,000, transmission is shot, it is banging and knocking while driving.
Was driving and heard a knocking sound similar to taps coming from the engine. Pulled over turned car off and turned it back on and knocking sound stopped. Drive about another mile and black smoke came out the vents. Pulled over and got out of vehicle. By the time I was out of the vehicle the car was on fire. By the time the fire department arrived car was completely engulfed. No check engine light was on and car gave no previous warning as to what could have happened.
When parked letting the car warm up constant shaking kinda a rough ideal at times. From park to reverse it shifts hard the to drive its ok I guess then on the go it's like driving a boat on land loud knocking sounds seems like the tires are flat or about to explode off the car really nerve-wracking
On 7/22/2022, our 2015 Nissan Altima began to shake heavily while being driven at approximately 30 mph. Please note that our 16 year old newly licensed son was driving the vehicle when this occurred. The traction control light came on and the vehicle was unable to be driven safely. Thankfully, he was able to get to the side of the road and we were able to have the car towed to our mechanic. It was determined that the driver side left rear lower control arm had completely broken off due to corrosion. Pictures attached. The left rear control arm was replaced by our mechanic. On 2/3/2023, our 2015 Nissan Altima was being driven at approximately 30mph by our 16 year old son when he reported a knocking sound and the car began to shake. He reported the traction control light came on and he had to maneuver the car to the side of the road. Photos attached. The car needed to be towed to our mechanic as it was unsafe and unable to be driven. It was determined that that the passenger side right rear lower control arm had completely broken off due to corrosion. The car is currently waiting to be repaired.
The contact owns a 2016 Nissan Altima. The contact stated that while driving at an undisclosed speed, the vehicle failed to accelerate and instead decelerated. On another occasion while driving approximately 20-30 MPH, the vehicle was jerking with an abnormal ticking sound. The check engine warning light illuminated. The vehicle was taken to the local dealer but the vehicle was not diagnosed or repaired. The vehicle was taken to an independent mechanic and diagnosed with transmission failure. The manufacturer was not notified of the failure. The failure mileage was approximately 84,000.
The contact owns a 2013 Nissan Altima. The contact stated while driving 35 MPH, he heard an abnormally loud knocking sound coming from the rear passenger’s side brakes. The contact stated that the check engine warning light was illuminated. The contact was able to pull over and the vehicle was towed to an independent mechanic. The vehicle was diagnosed and the contact was informed that the rear control arms and the bolts attached to the frame need to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 165,000. Consumer wanted to include a link to Nissan’s website where they say this is an issue but only in Canada due to high volume of salt being used. Wisconsin which is a state they say uses a high volume of salt.
Related recalls
Engine and engine cooling: engine: hard parts internal/mechanical
- What is wrong
- Nissan North America, Inc. (Nissan) is recalling certain 2021-2024 Rogue, 2019-2020 Altima, 2019-2022 Infiniti QX50, and 2022 Infiniti QX55 vehicles equipped with 3-cylinder 1.5L or 4-cylinder 2.0L variable compression turbo (VC-Turbo) engines. The engine bearings may have manufacturing defects that can lead to engine failure.
- Risk
- Engine failure increases the risk of a crash. A bearing failure may cause a breach in the engine block, allowing hot oil to be discharged, increasing the risk of an engine fire.
- Remedy
- Dealers will reprogram the engine control module (ECM) software, free of charge. Owner letters were mailed April 8, 2026. Owners may contact Nissan's customer service at 800‑647‑7261 or Infiniti's customer service at 1‑800‑662‑6200. Nissan's numbers for this recall are R25A8/A9 and R25B1/B2.
Recall number 25V437000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crankshaft position sensor can overheat causing a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the crankshaft position sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. Certain my 2006 altimas which have been previously remedied under recall campaign 06v223 (nissan r0606) are not included in this recall since the reprogramming for 06v223 also included this reprogramming. The recall began on december 31, 2007. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 07V527000 · Recall details
Engine and engine cooling
- What is wrong
- On certain vehicles, if a sufficiently hot object enters the air filter housing through the engine fresh air intake system and contacts the engine air filter, the flammability characteristics of the air filter material are such that the filter may ignite.
- Risk
- If the air filter material ignites, a fire may occur.
- Remedy
- Dealers will replace the air filter with a new one that has improved anti-flammability material characteristics. The recall began on july 3, 2007, and will continue through october 1, 2007. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 07V267000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crank angle sensor is affected by temperature variations. Under certain driving conditions, these variations in temperature can be large enough to cause a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. The recall began on august 21, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V242000 · Recall details
Engine and engine cooling
- What is wrong
- Certain passenger vehicles equipped with 2.5l engines may experience excessive engine oil consumption as a result of improper performance of the piston rings.
- Risk
- If the oil is not maintained at least at the minimum level, engine damage can occur and in extreme cases result in an engine fire.
- Remedy
- Dealers will reprogram the electronic control module (ECM or engine computer). Your vehicle will also be inspected to determine if it has been consuming engine oil at a higher than normal rate. In a small percentage of vehicles, engine replacement will be needed. On june 9, 2006, nissan notified owners of the possibility of excessive oil consumption and the importance of maintaining the oil at a proper level. Follow-up letter to owners advising them of the status of the recall was sent during august 2006. Followup letter to owners was sent on november 15, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V223000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
- Risk
- This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
- Remedy
- Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan at 1‑800‑647‑7261 or infiniti at 1‑800‑662‑6200.
Recall number 03V455000 · Recall details
Engine and engine cooling: exhaust system: manifold/header/muffler/tail pipe
- What is wrong
- On certain vehicles equipped with the 2.5 liter engine, the exhaust pipe hanger pin may catch debris from the road that could be ignited by contact with the main catalyst. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate.
- Risk
- Either of these two conditions could result in a fire.
- Remedy
- Dealers will remove the protruding portion of the exhaust pipe hanger pin. In addition to the corrective action, in order to reduce the risk of fire in the event of poor or improper maintenance that could result in oil spillage, heat shield(s) will be installed on the pre-catalyst and exhaust tube. Owner notification began on july 28, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1‑800‑647‑7261. Nissan recall nos. R3007, r3014, r3015, r3016, r3017. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate. If substrate particles enter the combustion chamber, they could score the cylinder walls, resulting in increased oil consumption. If the engine oil level is not checked on a periodic basis and drops below the low level, and the driver continues to operate the vehicle ignoring noticeable engine noise, engine damage may occur which could result in a fire. The pre-catalyst will be tested to ensure it is working properly and replaced if necessary. If damage is found inside the pre-catalyst, it will be necessary to replace the engine.
Recall number 03V084000 · Recall details
Questions about the Nissan Altima knocking
Which Nissan Altima years have engine knocking or ticking problems?
The model years with the most reports are 2002 (15 complaints), 2003 (12 complaints) and 2013 (12 complaints).
How much does it cost to fix engine knocking or ticking on the Nissan Altima?
Owners who mentioned a price put the repair at about $3,000 (median of 8 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Nissan Altima?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history