I was driving on the freeway at 65mph and I felt the car jump and it felt like it was losing power and kicking me at the same time. It wanted to stall out. So I had to pull over to the far right lane and it continued to make a screaming noise when I would push on the had and not want to accelerate.
Nissan Altima stalling problems
1,284 of the 15,494 owner complaints about the Nissan Altima describe engine stalls while driving, most of them for the 2003 model year.
- owner complaints
- 1,284
- worst model year
- 2003
- typical repair cost reported
- $800
- typical mileage
- 79,000
Is there a fix? There are 7 recalls for this area of the car. See below
By model year
Often reported together
Check engine light 293Jerking 104CVT failure 89Transmission failure 77Loss of power 76Won't start 69Hesitation 67Engine failure 41
Trouble codes mentioned
P0335 9P0776 8P0725 6P0965 4P2813 3P0420 2P0340 2U1001 1U1000 1P2004 1
What owners say
The contact owns a 2021 Nissan Altima. The contact stated that the rear seat belt failed to latch securely. The instrument panel illuminated, and the seat belt warning light remained displayed with a beeping sound during and after the failure. The battery was replaced twice within one year, and the vehicle needed to be jumpstarted by AAA due to an issue associated with a sensor. The contact stated that while the accelerator pedal was depressed, the RPC became extremely elevated. The contact stated that the vehicle occasionally stalled and shut off unexpectedly. There was an abnormal odor coming from the vehicle which was associated with the radiator. Additionally, Bluetooth calls were dropped, a key fob failed to be recognized by the vehicle, and the TPMS readings were incorrect. The contact also stated that the windshield wiper malfunctioned, and that the remote control needed a battery replacement at the time of purchase, and that the vehicle was pulling to one side whenever the brake pedal was depressed. The vehicle was taken to the dealer, but the dealer was unable to determine the cause of the failure. The dealer associated the failure with a sensor caused by the rain. The corporate office was contacted by phone about a buyback. The approximate failure mileage was 44,011.
I am a senior citizen that owns a 2008 Nissan Altima, 2.5, two door vehicle. I have spent thousands trying to fix a power condition on this car that has become chronic. One mechanic told me what my car has a a known symptom by Nissan and that there has been recalls for it, therefore, I went in the internet and search recalls for 2008 Nissan cars and found out its been known this mechanical problem is known manufacturer. Sadly i never received a notice of recall and I wonder how i was missed! Another issue of this car is that the dashboard is melting for several years and its also a known issue. Now, I will describe the symptoms of the car. 1. I bout this car with Mossy Nissan dealer, San Diego, CA. in July, 2010. Since i bout the car, i used to feel a burst of power when when starting to drive. I'd press the gas and it would take a second or two to move with power, I thought this is the way the car was and I liked it. unfortunately, this burst of power got more delayed as the car became older to the point that I am in a red light and the car does not move although I am pressing the gas. now the car stalls sometimes but not often. 2. I recognize this is a safety issue because for me because i can be hit by other car from the back when the car loses power. last weekend, I was on an intersection exiting the highway and made a left just when the car staled and another car almost collided with me. According to the internet report on this car, this is a known issue to Nissan. 3. Unfortunately, the car does not give me an alarm or safety warning on the dashboard when this happens, so its hard for the mechanics to troubleshoot.
My daughter was driving down the road and came to a 2-wayy stop. Went to pull out and the car stalled and started shuddering. On down the road leaving a red light it did the same thing and not wanting to really go.
The car stalls and began to jerk then shuts down the crash symbols comes on and goes off.
While driving my 2005 Nissan Altima in active traffic with my [XXX] child, the vehicle suddenly stalled without any warning. The engine completely shut off while in motion, creating an immediately safety hazard in live traffic conditions. Immediately after the stall, I observed oil leakage and smoke entering the cabin. The vehicle became inoperable and we were stranded roadside. This failure is consistent with a known defect involving the crankshaft position sensor and engine control system addressed in the federal safety agency Campaign 07V‑527, which describes sudden engine stall without warning due to sensor signal interruption. Although my vehicle previously received recall-related service, this incident suggests the prior remedy did not prevent recurrence of the defect. Sudden engine shutdown while driving in traffic Loss of vehicle power without warning Smoke entering passenger cabin Risk of crash involving child passenger Request: I am requesting that the federal safety agency: Review this incident for potential recall remedy failure Investigate whether this represents recurrence of a known defect Determine whether additional corrective action is needed for this vehicle population INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Vehicle: 2005 Nissan Altima | VIN: [XXX] To the Executive Team and Legal Counsel, I am writing this under extreme duress following a catastrophic, life-threatening vehicle failure on April 23, 2026, in Ripley, WV. While transporting my [XXX] son, my 2005 Nissan Altima suffered a sudden engine stall, followed by the engine bay becoming saturated with oil and emitting heavy smoke. This event is the direct result of Nissan’s failure to remediate known federal safety defects, specifically the federal safety agency Recall 07V527000 (Crankshaft Sensor/Stalling) and the federal safety agency Recall 06V223000 (Oil Consumption/Fire Risk). INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The system malfunctioning is the front sensor braking. My safety and others were put at risk with this because multiple times my car has braked me and or completely stopped me because it’s malfunctioning , it happens while I am on a busy street and someone even almost rear ended me because my car braked out of nowhere. It’s called “Phantom Braking”. No, the problem has not been confirmed by dealer became they stopped answering. I took it to the manufacture but they want to charge me too much. Yes and it first appeared Feb 2nd , a day after I bought the car. So at first it will aggressively brake me and I can tell when it’s going to start braking me because this loud scratching/grinding noise appear .. the noise sounds like it’s coming from the bottom and I can feel it vibrating my car when I relax my feet on the brakes or the floor. But as soon as that noise comes on then the car starts braking me and sometimes it will cause the engine to stall and then the car will stop driving completely while im on the middle of traffic.
The contact owns a 2013 Nissan Altima. The contact stated that while attempting to accelerate from a stop sign, the vehicle accelerated to approximately 15 MPH and then unexpectedly decelerated. The contact attempted to depress the accelerator; however, the vehicle lost automotive power and stalled. The vehicle was towed to the residence. There were no warning lights illuminated. The vehicle was taken to the dealer to be diagnosed. The contact was informed that the transmission needed to be repaired. The vehicle was not yet repaired. The manufacturer was informed of the failure and confirmed that the VIN was not under recall. The manufacturer referred the contact to the federal safety agency Hotline to report the failure. The failure mileage was approximately 100,000.
Vvt valve has failed twice now despite timely oil changes. This is a safety risk because vehicle will stall at low speeds like when starting at an intersection from a stopped position
Related recalls
Engine and engine cooling: engine: hard parts internal/mechanical
- What is wrong
- Nissan North America, Inc. (Nissan) is recalling certain 2021-2024 Rogue, 2019-2020 Altima, 2019-2022 Infiniti QX50, and 2022 Infiniti QX55 vehicles equipped with 3-cylinder 1.5L or 4-cylinder 2.0L variable compression turbo (VC-Turbo) engines. The engine bearings may have manufacturing defects that can lead to engine failure.
- Risk
- Engine failure increases the risk of a crash. A bearing failure may cause a breach in the engine block, allowing hot oil to be discharged, increasing the risk of an engine fire.
- Remedy
- Dealers will reprogram the engine control module (ECM) software, free of charge. Owner letters were mailed April 8, 2026. Owners may contact Nissan's customer service at 800‑647‑7261 or Infiniti's customer service at 1‑800‑662‑6200. Nissan's numbers for this recall are R25A8/A9 and R25B1/B2.
Recall number 25V437000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crankshaft position sensor can overheat causing a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the crankshaft position sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. Certain my 2006 altimas which have been previously remedied under recall campaign 06v223 (nissan r0606) are not included in this recall since the reprogramming for 06v223 also included this reprogramming. The recall began on december 31, 2007. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 07V527000 · Recall details
Engine and engine cooling
- What is wrong
- On certain vehicles, if a sufficiently hot object enters the air filter housing through the engine fresh air intake system and contacts the engine air filter, the flammability characteristics of the air filter material are such that the filter may ignite.
- Risk
- If the air filter material ignites, a fire may occur.
- Remedy
- Dealers will replace the air filter with a new one that has improved anti-flammability material characteristics. The recall began on july 3, 2007, and will continue through october 1, 2007. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 07V267000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crank angle sensor is affected by temperature variations. Under certain driving conditions, these variations in temperature can be large enough to cause a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. The recall began on august 21, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V242000 · Recall details
Engine and engine cooling
- What is wrong
- Certain passenger vehicles equipped with 2.5l engines may experience excessive engine oil consumption as a result of improper performance of the piston rings.
- Risk
- If the oil is not maintained at least at the minimum level, engine damage can occur and in extreme cases result in an engine fire.
- Remedy
- Dealers will reprogram the electronic control module (ECM or engine computer). Your vehicle will also be inspected to determine if it has been consuming engine oil at a higher than normal rate. In a small percentage of vehicles, engine replacement will be needed. On june 9, 2006, nissan notified owners of the possibility of excessive oil consumption and the importance of maintaining the oil at a proper level. Follow-up letter to owners advising them of the status of the recall was sent during august 2006. Followup letter to owners was sent on november 15, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V223000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
- Risk
- This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
- Remedy
- Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan at 1‑800‑647‑7261 or infiniti at 1‑800‑662‑6200.
Recall number 03V455000 · Recall details
Engine and engine cooling: exhaust system: manifold/header/muffler/tail pipe
- What is wrong
- On certain vehicles equipped with the 2.5 liter engine, the exhaust pipe hanger pin may catch debris from the road that could be ignited by contact with the main catalyst. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate.
- Risk
- Either of these two conditions could result in a fire.
- Remedy
- Dealers will remove the protruding portion of the exhaust pipe hanger pin. In addition to the corrective action, in order to reduce the risk of fire in the event of poor or improper maintenance that could result in oil spillage, heat shield(s) will be installed on the pre-catalyst and exhaust tube. Owner notification began on july 28, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1‑800‑647‑7261. Nissan recall nos. R3007, r3014, r3015, r3016, r3017. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate. If substrate particles enter the combustion chamber, they could score the cylinder walls, resulting in increased oil consumption. If the engine oil level is not checked on a periodic basis and drops below the low level, and the driver continues to operate the vehicle ignoring noticeable engine noise, engine damage may occur which could result in a fire. The pre-catalyst will be tested to ensure it is working properly and replaced if necessary. If damage is found inside the pre-catalyst, it will be necessary to replace the engine.
Recall number 03V084000 · Recall details
Questions about the Nissan Altima stalling
Which Nissan Altima years have engine stalls while driving problems?
The model years with the most reports are 2003 (246 complaints), 2005 (188 complaints) and 2013 (158 complaints).
How much does it cost to fix engine stalls while driving on the Nissan Altima?
Owners who mentioned a price put the repair at about $800 (median of 120 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Nissan Altima?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history