The car stalls and began to jerk then shuts down the crash symbols comes on and goes off.
2020 Nissan Altima: engine stalls while driving
6 of the 162 complaints about the 2020 Nissan Altima describe engine stalls while driving.
- owner complaints
- 6
- of this car's complaints
- 4%
- recalls
- 1
Engine stalls while driving by model year
What owners say
The contact owns a 2020 Nissan Altima. The contact stated that while driving at 55 MPH, the vehicle stalled in the middle of the expressway. The contact turned off and restarted the vehicle, and the engine started knocking significantly. There was no warning light illuminated. The contact was able to slowly pull over to the side of the road. The vehicle was towed to the residence. The vehicle was later driven to the dealer, where it was test-driven. The dealer informed the contact that there was smoke coming from the vehicle, and the engine needed to be replaced. The vehicle was not repaired and remained at the dealer. The contact related the failure to the federal safety agency Campaign Number: 25V437000 (Engine and Engine Cooling); however, the VIN was not included. The manufacturer was notified of the failure, and a case was filed. The failure mileage was unknown.
I been having issues with my car stalling out and not wanting to start I got the spark plugs replaced by a mechanic and then my car starts over heating I have my car looked at by a mechanic again and I’m told the engine is corrupt by oil and the fuel pump is bad my car can be inspected for this issue as it is having a lot more issues due to the Nissan recalls but my vin doesn’t cover it
While accelerating from a complete stop, the car stalled with tires, powertrain, and steering wheel all locked. For 15 seconds, the steering wheel, tires, and car was unable to be manipulated. During acceleration, the speed was less than 15mph when it came to an abrupt stop. Another car behind me almost hit me when my car came to a stop. Car was just serviced for another warranty issue a few months ago by Nissan dealership.
Unpredictably vehicle acceleration is delayed by approximately 3-4 seconds. Car then proceeds to take off after transmission kicks in. I almost got hit by a semi during a left turn. And similar near miss incidents have occurred. Car also fails to accelerate in a predictable manner when needed rpm goes up but vehicle will stall/hesitate. The vehicle is under warranty and has been to the dealer 3 times. They will not perform any maintenance on the vehicle. Saying it needs to be replicated in person. The Issue is not easily replicated, but when the issue presents itself, it poses a great safety risk to occupants in the vehicle and all drivers/pedestrians on the road around the vehicle. This seems to be a known issue by Nissan but they fail to implement a recall or any other corrective action. I can provide invoices/Statements of work but will have to retrieve them from the dealer. I also have video evidence of the issues occurring. Dealer has seen the videos but refuses to repair, replace, or recompensate for the issues listed above off the videos alone.
I was driving the car at about 70 mph on the expressway and it just randomly de-accelerated dripping from 70-34 mph and would not allow me to accelerate and then proceeded to shut down stating engine stall I almost got hit from the back when the car de-accelerated and couldn’t do anything about it after about 10-15 seconds I pressed the gas again and it took off abruptly. I’m scared to drive my car anywhere that I’ll get hit if my car de-accelerates again. Nissan can’t replicate the issue to come up with a conclusion.
Service bulletins that may apply
- DTC P0404 stored in the ECM at temperatures below 32°F
- MIL on with DTC P11A7 stored in the ECM
- MIL on with DTC P062F and/or P0603 stored if you confirm
- MIL on with P0101 stored
- Altima with PR25DD engine; DTC P0015 stored
- MIL on with P0101 stored if you confirm
- Engine and engine cooling
- VCR Engine Inspection – Expiration Notice UPDATE November 11, 2019 Please discard earlier versions of
Related recalls
Engine and engine cooling: engine: hard parts internal/mechanical
- What is wrong
- Nissan North America, Inc. (Nissan) is recalling certain 2021-2024 Rogue, 2019-2020 Altima, 2019-2022 Infiniti QX50, and 2022 Infiniti QX55 vehicles equipped with 3-cylinder 1.5L or 4-cylinder 2.0L variable compression turbo (VC-Turbo) engines. The engine bearings may have manufacturing defects that can lead to engine failure.
- Risk
- Engine failure increases the risk of a crash. A bearing failure may cause a breach in the engine block, allowing hot oil to be discharged, increasing the risk of an engine fire.
- Remedy
- Dealers will reprogram the engine control module (ECM) software, free of charge. Owner letters were mailed April 8, 2026. Owners may contact Nissan's customer service at 800‑647‑7261 or Infiniti's customer service at 1‑800‑662‑6200. Nissan's numbers for this recall are R25A8/A9 and R25B1/B2.
Recall number 25V437000 · Recall details
Questions about the 2020 Nissan Altima stalling
Is engine stalls while driving a common problem on the 2020 Nissan Altima?
6 of 162 owner complaints about the 2020 Nissan Altima (4%) mention engine stalls while driving. The model year with the most reports is 2003.
Is there a recall or service bulletin for this on the 2020 Nissan Altima?
There is 1 recall and 8 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2020 Nissan Altima
Check engine light 14Door locks 13Loss of power 9Engine failure 8Jerking 8Backup camera 7Hesitation 7Key fob 7Collision warning 6Fire or smoke 6Adaptive cruise 5No deployment 5Windshield crack 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 Nissan Altima?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history