1993 cutlass ciera. Consumer writes in regards to air conditioner conversion kit upgrade and power steering issues. *ld the consumer stated the manufacturer was notified, but declined assistance due to the vehicle's age and mileage. Also, the A/C conversion kit was not installed at a gmc dealer.
The worst 1993 Oldsmobile Cutlass problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Brakes48
- Electrical21
- Transmission14
- Body9
- Engine9
- Fuel system8
- Seats8
- Suspension8
- Steering7
- Acceleration6
- Airbags3
- Seat belts3
- Wheels3
- Lights2
- Locks2
- Tires2
- Visibility2
Specific symptoms reported on the 1993 Oldsmobile Cutlass
Recalls 4
Seat belts: front: anchorage
- What is wrong
- These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages."
- Risk
- Consequence of non-compliance: in a collison, stress can cause the attachment metal to tear and allow the anchorage to separate from the body of the vehicle. The safety belt may not protect an occupant in the event of a vehicle crash.
- Remedy
- Dealers will replace the existing anchor bolts with a new shoulder bolt and thread locking adhesive. Additionally, noise control patches will be applied at each anchorage.
Recall number 95V173000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The brake lines can contact the transmission mounting bracket of the frame side rail. The lines can wear through resulting in loss of brake fluid, and eventual loss of half the vehicle braking system.
- Risk
- A leak in the hydraulic brake line will cause a loss of one half the vehicle braking system and extended braking distances which can result in an accident.
- Remedy
- Dealers will inspect for proper brake line clearance and reposition the brake lines. Brake lines found to have indentations will be replaced.
Recall number 94V211000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The brake hoses were manufactured incorrectly, and do not comply with fmvss 106, "brake hoses."
- Risk
- The improperly manufactured brake hoses can causereduced brake effectiveness and/or uneven braking, which could result in anaccident.
- Remedy
- Replace the right front brake hose assembly on ciera and century models, and both rear brake hoses on cavalier and sunbird models.
Recall number 93V121000 · Recall details
Seats
- What is wrong
- The driver and passenger front seat manual reclining mechanisms do not comply with the requirements of fmvss 207, "seating systems." the seat back mechanisms will not latch under certain conditions.
- Risk
- The seats may recline without prior warning, resultingin a hazard to seat occupants and possible loss of vehicle control.
- Remedy
- Replace the manual seat recliner mechanism with a mechanism that complies with fmvss 207.
Recall number 93V035000 · Recall details
See all 4 recalls for the 1993 Oldsmobile Cutlass
Defect investigations
Corroded rear disk brakes
There is no summary currently available
PE94063
Technical service bulletins for the 1993 Oldsmobile Cutlass 29
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Expanded Availability for Remanufacture and Return (R&R) Electronic Control Modules
- Owners of some vehicles equipped with hydra-matic 3T40, 4T60, 4T60-E or 4T65-E transaxles may comment on a...
- Some vehicles equipped with hydra-matic 3T40, 4T60 or 4T60-E transxales may comment on a grinding and / or...
- Customers may complain of grinding / scraping / groaning noise from rear suspension
- Evaporative emission canister purge solenoid vlave replacement and convertible only, prom replacement
- Voluntary emission campaign involving the evaporative emission canister purge solenoid valve replacement...
- Voluntary emission recall campaign - evaporative emission conister purge solenoid valve replacement and,...
- Some V6 engines may, on a very infrequent basis, have an oil odor condition that is generally encountered...
- Comments on a ticking type noise that begins shortly after cold engine start-up and gradually diminishes...
- Some vehicles experience difficulties to depress accelerator pedal and/or an accelerator cable separation
1993 Oldsmobile Cutlass fuel economy
Official EPA estimates in miles per gallon (MPGe for electric). Ranges cover trims that share the same engine.
| Engine | Drive | City | Highway | Combined |
|---|---|---|---|---|
| 2.2L 4‑cyl | FWD | 18-21 | 26-28 | 21-23 |
| 3.3L 6‑cyl | FWD | 17-18 | 24-26 | 19-21 |
What 1993 Oldsmobile Cutlass owners say
Most recent owner complaints, unedited.
Tl* the contact owns a 1993 oldsmobile cutlass. The consumer stated the driver's side sun visor has a decal on the underside stating that the vehicle is equipped with a driver's side air bag. A fuse is in the box, where it indicated an air bag fuse. However, there is no air bag. The consumer stated gm failed to notify consumers that some of the vehicles produced could have an erroneous driver side sun visor decal stating that the vehicle is equipped with a driver side air bag. Updated 04/18/13
Dt*: the contact stated while the vehicle was parked, a puddle of brake fluid was observed on the ground underneath the driver's side seat. Upon further inspection it was determined that the brake lines had rusted along the fittings. The contact confirmed that the vehicle had not been driven in poor weather conditions and that the vehicle was stored in a garage. The manufacturer was alerted but the vehicle was not taken to a dealer for inspection. There is a the federal safety agency recall # 93v121000 regarding the service brakes lines, piping, and fittings. The vehicles VIN was not included in the recall. Updated 6/23/2006 - the vehicle's oil pan, transmission pan and gas tank also rusted. .
Consumer stated that while his friend was driving she heard a noise, got out, and discovered that the sub frame on the passenger's side broke. Also, another crack started on the a frame on the other side.
On june 10th, two days ago, I totaled my 93 oldsmobile cutlass supreme on I-93 in new hampshire. While my year (93) has not been recalled, 88 -91 were all recalled for separation of the steering intermediate shaft from the steering gear as a result of corrosion of 2 bolts where road salt use is high, including in massachusetts. I have been commuting from boston to hanover nh to teach for the past 10 weeks. A couple weeks ago I started worrying about steering. Had two rear tires replaced last week and on the day of the crash a ball joint and a tie rod replaced and an alignment. But on 93 south in londonderry I started to move into the passing lane, saw a car that had been in my blind spot so swerved a bit to the right. But I could not straighten my car out - it just kept going right, then it swerved to the left, I crashed into the guard rail, bounced backwards and stopped horizontally to the traffic blocking both lines of traffic. At first I assumed I was at fault for losing control of the car. Then on the way to the tow lot, the driver asked me if a tie rod had snapped. I said I didn't know but had just had one replaced. At the tow yard, he and a car dealer (both inspectors) checked - the work I had done looked fine but upon further investigation, the steering wheel shaft had separated from the steering wheel gear which they said should never happen - they should be bolted together. Given my description of loss of control and the bizarre skid marks, they are quite sure this caused the accident. And now I'm thinking this may have had something to do with the first skid-out but I talked myself into thinking it was tires and rain and alignment, not steering. On the recommendation of the tow guys mentioned above, I left a phone message with the federal safety agency but havent heard. The tow lot owner needs to know if any parts should be saved before crushing it. This was a harrowing experience I would not want anyone else to experience.
My dig. Dash work half the time and not the rest. I can not see my speed, gas or mileage. Also every now and then smoke come out from my steering column.
Door handles no longer work from the outside. Children trying to open them after they are broken get their fingers pinched .
Air bag split 1 1/2 inches. *mr the vinyl which covered the air bag split. *scc
My 1993 olds cutlass sl has had brake calipers replaced twice in a year in the rear with gm parts once in the front. All rotors replaced, twice in the front. The hop I take the car for service says the cutlass has problems with brake components on this car. I wasn't notified of any recall. Any information on this you could give to me would be great. I feel I should be able to recoup some of the cost from gm. The shop told me there was a class action lawsuit on the brake problems. Please let me know who to contact. Thanks.
I attempted to brake for a turning car and was unable to slow down. My mechanic said that the rear brake calipers were seized.
Compare the 1993 Oldsmobile Cutlass
Other model years
Questions about the 1993 Oldsmobile Cutlass
Is the 1993 Oldsmobile Cutlass reliable?
Owners have filed 139 complaints about the 1993 Oldsmobile Cutlass, close to a typical Cutlass model year.
What is the most common problem with the 1993 Oldsmobile Cutlass?
Brakes, with 48 complaints. Next is electrical (21).
How many recalls does the 1993 Oldsmobile Cutlass have?
4 recalls, covering seat belts, service brakes, hydraulic and seats.
Was there a recall on the 1993 Oldsmobile Cutlass brakes?
Yes, 2 recalls: 94V211000, 93V121000. Check your VIN to see if your car still needs the free repair.
What year does the Oldsmobile Cutlass have bad brakes?
The Oldsmobile Cutlass model years with the most brakes complaints are 1991 (59 complaints), 1992 (53 complaints) and 1990 (51 complaints).
What gas mileage does the 1993 Oldsmobile Cutlass get?
Official estimates for the 1993 Oldsmobile Cutlass range from 19 to 23 mpg combined. The most efficient version (2.2L 4-cyl, FWD) gets 18-21 city and 26-28 highway.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1993 Oldsmobile Cutlass?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history