My 2018 Toyota Camry LE went into Limp mode while drive on the highway causing jerking while driving and tons of error codes on the dash, and issues with safety systems shutting off and accelration. After towing to a dealership, dealership gave me the following description of the defect: Coolant is coming through the cylinder walls due to a hairline fracture in the cylinder causing 2 of the 4 cylinders to misfire and coolant to mix with usual contents. We aren't able to identify where the cause of this problem is but it makes the most economical sense to replace the engine with a lower mileage engine and replace the neighboring parts to support the less old engine. I was quoted $8300 approximately. the same vehicle just a few years older are recalled already for the exact same thing - the federal safety agency Recall 20V064000. the federal safety agency Recall states: "The subject vehicles are equipped with a 2.5L 4 Cylinder engine (A25A) and may have been produced with engine blocks containing higher porosity levels. Higher levels of porosity could create cracks in the cooling passages, resulting in coolant leaking internally and/or externally. This may lead to engine noise, engine smoke, warning lights/malfunction indicator illumination, an audible chime sounding, and/or, in some cases, engine overheating and possible internal mechanical engine damage (e.g. seizing of internal engine components). If engine overheating or internal mechanical engine damage were to occur on involved conventional gasoline vehicles, a vehicle stall while driving at higher speeds could occur without prior warning to the driver, increasing the risk of crash."
2018 Toyota Camry: engine overheating
6 of the 757 complaints about the 2018 Toyota Camry describe engine overheating.
- owner complaints
- 6
- of this car's complaints
- 1%
- recalls
- 1
Engine overheating by model year
What owners say
ICS malfunction error light and check engine light came on. I received a recall notice that this was being looked into but now the water pump has went out. The car is overheating.
2018 TOYOTA CAMRY at times vehicle engine will run under engine Temperature, and other times, Vehicle will overheat. This is intermittent issue and is Not all the time. When vehicle is shut down. For 5, 10 minutes, It seems to work fine again for a week or two, and then starts to act up again. Toyota is aware of this issue with a defective Electronic water valve part that control the flow of water into the engine. Toyota did send notice out should this issue happen they will do a free Voluntary repair to replace that defective Electronic water valve even after the original initial warranty expires. Bringing to dealer to check and I will update after the fix was made that is suppose to fix this over heating issue with engine code reading P26cb. If you have same issue with vehicle years in question with code P26cb you might want to contact Toyota. This is a safety issue should engine start to overheat while driving.
Check engine light came on one day. Ignored it. The next morning was driving on the highway and noticed the car had some trouble accelerating, tried to switch lanes at ~40-60mph (don’t remember) and the car started to kick back and almost felt like it was coming to a complete stop. I was so scared the car would just stop in the middle of the highway because i couldn’t even change lanes without it kicking back/not accelerating enough. There was not a lot of traffic around so i was lucky enough to get the car into the far right lane and coast. An alert came on, almost immediately after, on the dash and was told to pull over due to the engine overheating. Looked at the heat gauge and noticed it was all the way to HOT. Got off the highway and tried to take local roads back home, the car started to kick back almost like it was about to come to a complete stop but was able to keep going local roads, didn’t pull over (was close enough to home that I didn’t want to leave my car on the side of the road if it didn’t start back up again) and the engine eventually cooled down. Got back home to put in more coolant (there was ZERO coolant, never noticed a leak) Car ran fine for about a week, then check engine light came back on. Took it to autozone for a scan, code came out as P26CB. Took it to Toyota for diagnostic and repair, the code they found was P26CB71. Was told by the service advisor that the car should’ve turned off automatically and I shouldn’t have been able to drive it so far with the engine over heating like that. Also was told that the engine was very close to “blowing up”.
Upon leaving my home the “check engine” light turned on suddenly after only less than 2 minutes of driving . The “ICS malfunction” light also turned on. The car pulled and stalled when pushing the gas and velocity stalled. Engine light turned said something similar to “engine overheating park in a safe place” . Not sure exact words. I was able drive less then one mile to get the car to Toyota Penske of Downey. I had the diagnostic done and the service provider stated the car needed an electrician water pump replacement. My car has very little mileage and was not running for long for it to over heat.
Braking Malfunction OVERHEATING shut the whole car down. Drained my battery starter, window module, blind spotting warning,
Service bulletins that may apply
- Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or...
- Customer support program 24TE04
- Engine
- Frequently Asked Questions CUSTOMER SUPPORT PROGRAM 24TE04 Multiple Model & Model Year Toyota Vehicles...
- This Customer Support Program provides coverage as it applies to Flow Shut-off Valve Coolant Leak on...
- Obsolete notice
- The specific condition covered by this program is for a small engine coolant leak that can occur from the...
- Condition in which an “Engine Maintenance Required” message is displayed in the Multi-Information Display...
Related recalls
Engine and engine cooling: engine
- What is wrong
- Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018 Toyota Camry vehicles equipped with a 2.5L, four-cylinder engine. The pistons on these vehicles may be larger than specified, possibly causing the engine to stall.
- Risk
- An engine stall can increase the risk of a crash.
- Remedy
- Toyota will notify owners, and dealers will inspect the production date codes of the pistons and, if an engine contains a piston from the affected production period, the engine assembly will be replaced, free of charge. The recall is expected to begin May 25, 2018. Owners may contact Toyota customer service at 1‑888‑270‑9371. Toyota's number for this recall is J1M/J0M.
Recall number 18V200000 · Recall details
Questions about the 2018 Toyota Camry overheating
Is engine overheating a common problem on the 2018 Toyota Camry?
6 of 757 owner complaints about the 2018 Toyota Camry (1%) mention engine overheating. The model year with the most reports is 2003.
Is there a recall or service bulletin for this on the 2018 Toyota Camry?
There is 1 recall and 46 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2018 Toyota Camry
Jerking 82Stalling 65Check engine light 58Hesitation 54Fuel pump 44Transmission failure 43Loss of power 27Harsh shifting 21Collision warning 20Slipping 18Adaptive cruise 17Whining noise 17Brake failure 14Won't shift 14No deployment 13Knocking 13Sudden acceleration 11Wipers 11Grinding brakes 9Lane assist 9Airbag light 8Engine failure 8Power steering loss 8Spongy pedal 8Headlights 7Misfire 7Tire blowout 6Warning lights 6ABS 5Fire or smoke 5Won't start 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 Toyota Camry?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history