2024 Toyota Grand Highlander: shudder or vibration when accelerating

Filed Aug 3, 2026 · Brakes · 39,000 miles · FL

The contact owns a 2024 Toyota Grand Highlander. The contact stated that the vehicle unexpectedly lurched forward while depressing the brake pedal. There was no warning light illuminated. The contact stated that excessive pressure was needed on the brake pedal to prevent the failure. The contact stated that a service appointment was scheduled with the dealer. While conducting independent research, the contact identified Technical Service Bulletin: T-SB-0028-25, which was associated with the vehicle shuddering while at a complete stop, and believed that the failure was associated with the technical service bulletin. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 39,000.

Filed Jun 23, 2026 · Engine, Transmission · IL

Vehicle: 2024 Toyota Grand Highlander Hybrid Max The vehicle intermittently experiences a severe hesitation and shudder during acceleration from approximately 0-40 mph. The condition occurs only under specific circumstances: -The vehicle has been parked long enough for the engine, transmission, and related systems to cool to ambient air temperature. -The vehicle is started and driven shortly thereafter. -Engine oil and transmission temperatures are below approximately 160°F. -The air conditioning system is operating at maximum cooling with Eco Air Mode enabled. -The hybrid battery indicator displays approximately three bars of charge. When these precise conditions are present, the vehicle may hesitate, shudder, and fail to respond normally to accelerator pedal input during acceleration. Even with the accelerator pedal fully depressed, repeatedly, there is a noticeable delay in power delivery and vehicle acceleration. This creates a situation where the vehicle does not accelerate as expected when entering traffic or attempting to increase speed. The vehicle has previously received Toyota Technical Service Bulletin T-SB-0017-24; however, the condition continues to occur intermittently. No warning lights, diagnostic messages, or system faults are displayed when the event occurs. The condition typically occurs only once during the initial drive cycle after a cold start and has not been observed after the vehicle reaches normal operating temperature. The issue is most common in the warmer months and has never been encountered at freezing or below temperatures.

Filed May 27, 2026 · CA

My 2024 Used Toyota Grand Highlander Hybrid Platinum Max was at a slight decline stopped at a stop sign in Echo mode. The whole car began to violently shake and lurching forward. No one was in front of me and my foot was on the brake or I probably would have run into a car in front of me. The dashboard then flashed a warning about the hybrid system overheating. The only way to stop it was to turn off the engine, then turn it back on. The car then began driving normally. I have also had an issue with hesitation felt while accelerating 0-40 mph with study throttle. Upon researching both issues, they should be resolved with TSB calibrations to my car of T-SB-0028-25 and T-SB-0017-24. This is not an error that would come up when doing a diagnostic check on my car's computer per research I have done. I took my car to get the updates at Toyota of Redlands, CA, and they refused to do them unless they could recreate them themselves. I called Toyota to report this, and they said that each Toyota dealership/service is privately owned at their own discretion. I was basically told to return if I experience it again. I do not want to experience this again and they wouldn't take my word on it anyways. I feel like next time I could injure myself or someone else if this glitch happened again. I therefore would like to implore to make this a mandatory preventative TSB calibration for cars that have had this reported/models/year which mine has. This goes for any TSB calibrations should be done preventatively, but especially ones that can cause a potential accident like T-SB-0028-25 and T-SB-0017-24. Here is information on why this would not show up on a diagnostic test: Your Toyota didn't generate an error code because the shudder is a software calibration issue rather than a component failure. The onboard computer (ECU) only triggers a check engine light or throws a Diagnostic Trouble Code (DTC) when sensors detect a hard mechanical or electrical failure.

Filed May 6, 2026 · Body · MD

It was noted that the drivers door weather strip deteriorated even though the car is less than 3 years old/ 47,000 miles. The dealer and the Toyota customer care said it is likely related to external factors and not covered under warranty. I keep the car in a garage. We have had other cars that are well over 10 years old but do/did not have this problem. This can potentially lead to damage of other components. I see on the internet that other owners of this car have encountered this same issue . There have been 3 safety recalls on this model, related to air bag, instrument panel and rear view camera. These have been fixed. There have been at least 5 Toyota technical service bulletins ( TSBs) published on this model. These were fixed after I brought it up with the dealer/ manufacturer. I was not contacted by the manufacturer proactively. TSB 0017-24 : hesitation felt while accelerating from stop. A software update was performed. TSB 0060-25 : Fuel level logic enhancement. A software update was made. TSB 0028-25 : Shudder sensation at stop. A software update was performed. ​T-SB-0082-24: CV axle issue: it was fixed T-SB-0111-24: vibrating hood.I notice the issue but did not fix it since the fix involves placing a foam under the hood, which may not fix the underlying issue and might cause other issues. I believe these issues are related to the manufacturing oversight and especially more frequent because it is a first year model .

Filed Feb 23, 2026 · Electrical, Transmission · 9,000 miles · FL

The contact owns a 2024 Toyota Grand Highlander. The contact received notification of the federal safety agency Campaign Number: 25V595000 (Electrical System), and the vehicle was taken to the dealer on several occasions, but the dealer informed the contact that the part to do the recall repair was not yet available. The contact stated that the instrument panel had failed. Additionally, the contact stated that the vehicle was not driving properly, and the vehicle was shuddering while exceeding 70 MPH. The vehicle was taken to the dealer, where it was diagnosed with an axle leak, and the contact was informed that there was no warning light illuminated for the failure due to the instrument panel failure. The axle leak was repaired; however, the failure persisted. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the failure, and a case was filed; however, no assistance was provided. The failure mileage was approximately 9,000.