Part # 69300-08011 rear left door latch with power sliding door malfunction causing a safety problem door remained opening and closing could cause passenger or items transporting to fall out of vehicle .it also caused battery to drain vehicle wouldn't start without being jumped even replaced battery with a new battery same thing happened . This part has become a problem in many of these 2004 toyota sienna mini vans . A safety recall need to be concidered .
2004 Toyota Sienna: won't start
6 of the 2,062 complaints about the 2004 Toyota Sienna describe won't start.
- owner complaints
- 6
- of this car's complaints
- 0%
- typical mileage
- 57,000
- recalls
- 1
Won't start by model year
- 20171
- 20153
- 20132
- 20121
- 20114
- 20064
- 20052
- 20046
- 20032
- 20021
- 20005
- 19992
What owners say
Tl*the contact owns a 2004 toyota sienna. The contact received the federal safety agency campaign number: 13v429000 (power train). The contact stated the vehicle was seen by the dealer for repairs. The contact stated that when attempting to start the ignition, the vehicle would not start. The vehicle was eventually able to start and taken to the dealer. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 57,000.
Most recently, passenger side automatic door stopped mid-way, I closed it manually, drove a couple of feet and turned off the car. Then the car would not start. Door is not working automatically only manually. Started easily with jumper cables but continues to not start on its own most of the time, usually when engine is cold it won't start on its won. This happened about 8 months ago and dealer said it needed a starter even though I showed printout from tow truck showing it wasn't the starter. This also happened some time before that and dealer said I needed a new battery and that seemed to fix the problem temporarily. This has been a problem since I first purchased the car and the dealer did not fix the problem.
2004 sienna xle power sliding door fell off. The power sliding function has been a troublesome issue with this door for over 2 years but since it did not start to fail until just after the warranty period ended toyota insists that there is no issue for them to address. We having been using this door in manual opening mode with power assisted closing for 2 years. Last week the cable became snagged in the mechanism but the door still worked in full manual mode. 3 days ago my wife placed our daughter in the vehicle and went to close the door. When the door was nearly closed the top and center rollers came out of their tracks and the door fell off the vehicle in her hand. The sharp bottom edge of the door nearly hit her toes and could easily have severed the end of her foot. The bottom hinge bracket is now bent and the back corner of the door is damaged from striking the ground. Dealer quote for the repairs is over $4000. From reading various posts on the internet this would appear to be a common defect with this vehicle which I consider to be a serious safety issue. I count us fortunate that neither my wife nor my daughter were seriously injured by this occurrence. Had she not caught the door before it struck the vehicle beside her or swung inwards toward my daughter who was sitting right beside it, the situation could have been much worse.
On 5/29/2004 I purchased my toyota sienna. I started having "mysterious" lights coming on at all different times. On 7/15/2004, I went out to my car and it wouldn't start. This was the beginning of a nightmare. Since then my car has been in the shop at least 6 times for this problem. I have not had my car start at least once a month since I purchased it. I would usually just jump the battery but they could never tell me the reason why it kept on happening. There were times that I couldn't even leave my doors open for 5 minutes without it wearing the battery down. When the battery is checked it is always fine. When the battery is fully charged I have the interior lights turn on for no reason. They have put in a new battery and replaced the jbl audio switch because that had been shown to turn on intermittently and drain the battery/engine. Neither of these solutions have worked. They finally told me that my car had too many "bells and whistles" (which all are factory installed) and that I need to connect to a car charger when I come home or to go on long drives at least once a week.
Battery saver feature discussed in owner's manual for 2004 sienna does not work. Sliding door inadvertently left open for 3 hours while visiting country friends. Battery drained to point engine would not turn over. Had to connect battery charger in cold rain to crank. Owners camping out with this vehicle may find themselves stranded and could possibly result in loss of life.
Service bulletins that may apply
- This is to advise of various price adjustments that will affect Toyota Genuine Motor Oil and Long Life...
- Revision notice
- Supersession Notice
- Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration...
- Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor...
- Summary to be provided on a future date.
- Toyota: techstream ECU flash reprogramming procedure
- Engine pinging or knocking noise
Related recalls
Engine and engine cooling
- What is wrong
- Toyota is recalling certain model year 2004 avalon vehicles; 2004 and 2005 camry, camry solara, highlander, and sienna vehicles, 2006 highlander hybrid; 2004 and 2005 lexus es330 and rx330; and 2006 lexus rx400h vehicles manufactured from june 1, 2004 through march 31, 2005, equipped with the 1mz-fe or 3mz-fe engine. The amount of adhesive agent applied between the outer ring and the torsional rubber damper (inner ring) in the crankshaft pulley may be inadequate. If the adhesive is insufficient, there is a possibility that the outer ring may become misaligned and it may not properly rotate with the inner ring, causing noise and/or illumination of the battery discharge indicator light.
- Risk
- In some cases, the belt for the power steering pump may become detached from the pulley which could result in a loss of power steering and a sudden increase in steering effort, increasing the risk of a crash.
- Remedy
- Toyota will notify owners, and dealers will check the crankshaft pulley to identify whether it was produced by the u.s. Supplier. If so, the dealer will replace the pulley with a new one at no charge. The safety recall is expected to begin during early january 2012. Owners may contact toyota at 1‑800‑331‑4331.
Recall number 11V539000 · Recall details
Questions about the 2004 Toyota Sienna won't start
Is won't start a common problem on the 2004 Toyota Sienna?
6 of 2,062 owner complaints about the 2004 Toyota Sienna (0%) mention won't start. The model year with the most reports is 2004.
Is there a recall or service bulletin for this on the 2004 Toyota Sienna?
There is 1 recall and 23 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2004 Toyota Sienna
Door locks 150Seat belt 43Hesitation 41Grinding brakes 37Jerking 36Headlights 28Tire blowout 28ABS 22Sudden acceleration 22Power steering loss 20Adaptive cruise 15Loss of power 15Key fob 13Engine failure 12Check engine light 11Stalling 10Pulling 10Battery drain 9Harsh shifting 9Overheating 9Ball joint 8Brake failure 8Airbag light 7No deployment 7Power windows 7Steering lock-up 7Fire or smoke 6Transmission failure 6Knocking 5Fuel leak 5Premature wear 5Steering noise 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2004 Toyota Sienna?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history