1. Vanos Bolts recall. the federal safety agency Recall 23V‑707. Cause the car the have a rough idle, check engine light, car to stall, and cut off in traffic all with seconds. Dealership says it was not the Vanos Bolts that cause the shutdown, but it is the DME and ICM. 2. The safety of myself and my 15 year old daughter was at risk, along with the drivers on the highway. The car stopped in traffic, and would not release out of park to go in neutral. 3. State Trooper came to call a tow truck, the car was inspected by BMW of Irondale. 4. No warning lamps, messages or other symptoms prior to the failure. The car was driving as normal, a sudden rough idle, light came on, and the car cut off in ongoing traffic, with not warning before.
BMW 528I stalling problems
82 of the 833 owner complaints about the BMW 528I describe engine stalls while driving, most of them for the 2012 model year.
- owner complaints
- 82
- worst model year
- 2012
- typical mileage
- 91,000
Is there a fix? There are 2 recalls for this area of the car. See below
By model year
Often reported together
Check engine light 20Fuel pump 11Engine failure 8Loss of power 7Won't start 5Misfire 4Jerking 4Hesitation 4
What owners say
The contact owns a 2011 BMW 528I. The contact stated while driving approximately 35 MPH, the check engine warning light illuminated, and the vehicle stalled. The contact pulled over, and after several attempts, the vehicle restarted. The contact was able to restart the vehicle, and the message "Drivetrain Malfunction" was displayed. The contact stated that the failure started recently and had occurred several times. Additionally, the vehicle was vibrating intermittently and lost motive power. The contact stated that occasionally the vehicle failed to accelerate above 15 MPH. The contact smelled the odor of gasoline inside the vehicle. The contact stated that the check engine warning light was illuminated. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 80,000.
The contact owns a 2012 BMW 528I. The contact stated while the vehicle was parked, the vehicle failed to start. The contact attempted to restart the vehicle. After several attempts, the vehicle failed to start. Several unknown warning lights were illuminated. The vehicle was towed to an independent mechanic; however, no cause for the failure was found. The vehicle was not repaired. The contact stated that on another occasion, while driving 60 MPH, the vehicle lost motive power and stalled. There was no warning light illuminated. The contact was able to coast to the side of the road. No warning lights were illuminated. The vehicle was towed to the residence. The vehicle was then towed to the contact's office. An independent mechanic arrived and diagnosed the vehicle with engine failure. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 160,000.
The contact owns a 2015 BMW 528I. The contact stated that while driving at various speeds, the vehicle stalled with the check engine warning light illuminated. The vehicle was initially taken to a dealer where a diagnostic test was performed, and the diagnostic test showed that the fuel rail system was defective and needed to be replaced. The contact had the vehicle repaired; however, several days later, the failure returned while traveling at highway speeds; the drivetrain maintenance message was displayed, and the check engine warning light was illuminated. The vehicle was taken to an independent mechanic and was diagnosed with a defective fuel pump. The vehicle was towed to another independent mechanic, and it was discovered that the vehicle was leaking oil and the valve cover gasket needed to be repaired. The vehicle had received a valve cover gasket repair, but the failure persisted. In addition, the manufacturer was notified about the failure, and the contact was informed that the vehicle was included in the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact was informed by the manufacturer that issue was not related to the recall. The manufacturer referred the contact to the federal safety agency Hotline to report the failure. The vehicle was not repaired. The failure mileage was approximately 98,000. VIN tool confirms parts not available.
The contact owns a 2012 BMW 528I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The contact stated that while the vehicle was parked, there was condensation underneath the vehicle. The contact stated that while driving approximately 50 MPH, the "Engine Malfunction" message was displayed, and the vehicle stalled. The vehicle was restarted 20 minutes later after several attempts. The failure reoccurred several times until the vehicle was taken to the residence and parked. The vehicle was towed to a dealer where it was diagnosed that the control unit seal pump needed to be replaced. The vehicle was repaired but the failure persisted. The vehicle was taken to the same independent mechanic on several occasions where it was diagnosed that the ignition coil and timing chain had fractured into the oil pan valve cover, and the oil pan gasket, oil pan, and spark plugs needed to be replaced. The manufacturer was notified of the failure. The failure mileage was 136,898.
The contact owns a 2011 BMW 528i. The contact stated that the vehicle was repaired under the federal safety agency Campaign Number: 23V707000 (Engine and Engine Cooling); however, following the recall repair, the vehicle was stalling with the check engine warning light illuminated. The contact stated that the vehicle was towed back to the same dealer. The contact stated that the dealer had diagnosed the vehicle and determined that the VANOS solenoids had failed and needed to be replaced. The vehicle was not repaired. The contact related the failure of the VANOS solenoids to the recall repair of the federal safety agency Campaign Number: 23V707000 (Engine and Engine Cooling). The manufacturer was informed of the failure. The failure mileage was approximately 112,000.
Subject: Complaint Regarding Transmission Malfunction and Potential Safety Hazard To Whom It May Concern, I am writing to formally lodge a complaint regarding a recurring issue with the transmission system of my vehicle. The vehicle has been displaying a transmission error code related to the shift pedal; however, no corresponding error message appears on the dashboard. This lack of clear diagnostic messaging significantly complicates the identification and resolution of the issue. The situation escalates in severity as the transmission malfunction light intermittently illuminates while driving. This behavior is alarming, as it poses a serious safety risk. The malfunction light often appears during traffic, raising concerns about the potential for stalling while the vehicle is in motion. Such an occurrence could lead to hazardous conditions for both the driver and surrounding traffic. I strongly urge the appropriate department to address this matter immediately. Given the critical nature of the transmission system, any malfunctions must be treated as safety-related defects. Please prioritize the investigation and resolution of this issue to ensure driver safety and vehicle reliability. I expect a prompt response outlining the steps being taken to rectify this situation and prevent further risks. [XXX] [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2016 BMW 528I. The contact stated while driving 50-60 MPH, there was smoke coming from underneath the hood and out of the exhaust pipes. The coolant temperature warning light and several other unknown warning lights were illuminated. The vehicle sputtered and stalled. The contact was able to pull to the side of the road. The vehicle failed to restart and was towed to the dealer, where it was diagnosed that the water pump had failed, causing several damages to the vehicle, including engine failure. The vehicle had not been repaired due to the cost. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure, but no assistance was provided. The failure mileage was approximately 80,000. VIN tool confirms parts not available.
The contact owns a 2011 BMW 528I. The contact stated that while her husband was driving at or above 50 MPH on several occasions, the vehicle began shaking and running rough. The check engine warning light flashed on and off during one occasion and then remained illuminated. Additionally, on two occasions while stopped at a red light and a stop sign, the accelerator pedal was depressed, and the vehicle stalled. After two failed attempts to restart the vehicle, the vehicle was restarted several hours later. The vehicle was taken to the dealer and repaired under the federal safety agency Campaign Number: 23V707000 (Engine and Engine Cooling). The contact was then advised by the dealer that the vehicle would not start. The manufacturer was notified of the failure but provided no assistance. The failure mileage was unknown.
The contact owns a 2013 BMV 528I. The contact received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that while driving 75 MPH, the vehicle stalled with the check engine warning light illuminated. The vehicle was towed to an independent mechanic where it was diagnosed with fuel pump failure. The contact was informed that the fuel pump needed to be replaced. The vehicle was repaired; however, the failure recurred. The contact stated that while driving at an undisclosed speed, the vehicle lost motive power with the check engine warning light illuminated. The vehicle was towed to the dealer where it was diagnosed that the water pump had failed and needed to be replaced. The vehicle was not repaired due to the parts not being available. The manufacturer was made aware of the failure. The failure mileage was approximately 96,000. VIN tool confirms parts not available.
Related recalls
Engine and engine cooling: exhaust system: emission control: crankcase (PCV)
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain 2008-2011 128i and 2007-2011 328i, 328xi, 328i xDrive, 525i, 525xi, 528i, 528xi, 530i, 530xi, X3 3.0si, X3 xDrive30i, X5 xDrive30i, Z4 3.0i, Z4 3.0si and Z4 sDrive30i vehicles. The heater for the positive crankcase ventilation (PCV) valve may short circuit.
- Risk
- An electrical short can cause the parts within the PCV valve to melt, increasing the risk of a fire, even when the vehicle is not in use.
- Remedy
- BMW will notify owners, and dealers will replace the PCV valve heater, free of charge. Interim letters were mailed on November 27, 2017. Owners will receive a second notification by the end of October 2018. Owners may contact BMW customer service at 1‑800‑525‑7417.
Recall number 17V683000 · Recall details
Engine and engine cooling: engine
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain model year 2010-2011 128i Coupe, 128i Convertible, 328i Sedan, 328i xDrive Sedan, 328i Coupe, 328i Convertible, 328i Sports Wagon and Z4 sDrive 30i, 2011-2012 135i Coupe, 135i Convertible, 335i Sedan, X5 xDrive 35i, and X6 xDrive 35i, 2011 335i xDrive Sedan, 335i Coupe, 335i Convertible, 528i Sedan, 535i Sedan, 535i xDrive Sedan, X3 xDrive 28i, and X3 xDrive 35i, 2010 X3 xDrive 30i, and X5 xDrive 30i, 2012 640i Coupe, and 640i Convertible and 2010-2012 535i Gran Turismo vehicles. In the affected vehicles, the bolts that secure the housing for the variable camshaft timing adjustment (VANOS) unit can loosen over time and may possibly break.
- Risk
- If the bolts loosen or break the engine may have reduced power or stall. An engine stall increases the risk of a crash.
- Remedy
- BMW will notify owners, and dealers will replace the four VANOS housing bolts for both VANOS units (intake and exhaust), free of charge. In addition, owners of approximately 170,172 model year 2010-2012 BMW vehicles equipped with inline 6 cylinder engines not covered by this recall, will receive an extended warranty to address this condition. The recall began on September 24, 2014. Owners may contact BMW at 1‑800‑525‑7417.
Recall number 14V176000 · Recall details
Questions about the BMW 528I stalling
Which BMW 528I years have engine stalls while driving problems?
The model years with the most reports are 2012 (27 complaints), 2011 (23 complaints) and 2008 (8 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used BMW 528I?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history