The engine light came on, later while driving the car shuts down engine reduced speed, engine power reduced. I have to restart the car and sometimes that dont help. Also the (ABS) light came on service stabilitrak, my anti brakes went out
2013 Chevrolet Malibu: ABS light or ABS activating
13 of the 837 complaints about the 2013 Chevrolet Malibu describe ABS light or ABS activating.
- owner complaints
- 13
- of this car's complaints
- 2%
- typical mileage
- 62,000
- recalls
- 0
ABS light or ABS activating by model year
What owners say
The contact owns a 2013 Chevrolet Malibu. While driving at 55 MPH, the "Service Battery Charging System" message was displayed, followed by the battery warning being illuminated. Simultaneously, the Service Stabili-trak, power steering, and ABS messages were displayed. The vehicle immediately lost steering assist, and the steering wheel became firm, and while depressing the brake pedal, the vehicle failed to slow down as intended. The vehicle was steered to the side of the road. Subsequently, the headlights turned off, the interface shut off, and the vehicle stalled. The vehicle was towed to an independent mechanic, who diagnosed that the alternator was running at 11 volts instead of 13 volts. The mechanic determined that both the alternator and the GCM (Generator Control Module) needed to be replaced; however, the vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 260,000.
Stablitrac: ABS and traction control errors
The reluctor ring which sends the signal to the abs and stability control system has delaminated from the wheel bearing to which it is attached. First it happened on the right rear wheel and necessitated replacement of the wheel bearing because the abs system is non functional. Now it has happened in the right front wheel. The abs and stability control are non functioning until I replace the front wheel bearing. The wheel bearing is fine, it’s the magnetic reluctor ring which has failed and no longer sends a signal to the abs sensor. This shouldn’t be happening on a 9 year old car. It is a very common problem and a danger on our roads as many people will drive it like this due to lack of funds.
ALL ELECTRICAL INSIDE CAR GOES OUT OR ON AND OFF WHILE DRIVING. ALL DASH GAUGES, SPEEDOMETER, GAS GAUGE, RADIO, HEAT/AC, TURN SIGNALS, ETC. CAR STILL RUNS BUT NOTHING ON INSIDE WORKS. I do not know if this control outage effects the ABS or Steering. It only last for a few seconds. It has happened several time will drive 50 to 70 MPH. I've let off the gas and try not to panic. Everything comes back on and I continue home. I'm scared to drive my car
I was traveling on 294 south using cruise control at 70 MPH when the car started losing power but all internal app lights like the radio remained on and the steering wheel was still functional. Once the vehicle was put in parked it shut off. Only issue lights that appeared 1 week prior was the ABS sensor had malfunctioned on the front left tire. I attempted to jump the battery but it did not respond. Car had been parked and a friend who works on cars believes the engine is dead even though there shows 23% of oil left and no other symptoms of a blown engine. I have been goodland 2013 chevy malibu eco issues and other than potentially the starter it could be the computer that has died. I changed out the battery and it turns everything on, but struggles to crank and remain on. I came across several links regarding a recall due to computer, but honestly don't know if its even that. Mechanic friend believes it could also be the ECM.
Service parking brake......can not rest code repair shop...what do you do...the parking brake is fine...the light will not turn off amber color.... Help tsb with no solutions....I would like this fixed also come one after ABS whas reset with wheel bearing code/replaced
*takata recall* while driving on highway steering became difficult to handle car began to shake in a jerking motion felt like wheels were going to fall off. On top of that took car to dealer ship and they didn't handle issue until my second visit to see if it would be covered under warranty I had to pay 100$ and find out my stability service light, and light and traction control light are on due to a rear bearing hub being broke and the sensor not being able to detect speed causing my RPM to be as the technician called it drive erratic and transmission is not shifting until 4-6,000 rpms. Also needs a fuel injection, and they mention a front turn signal being out which I never had any indication or knowledge of my headlights not working properly. Also, began talking to chevrolet as I was on their sight and seen recalls which I hadn't been notified and wonder if some issues that are occurring are from previous recalls that were believed to have not affected me? Is that possible? I am a full time student, in debt with loans and car payments as I don't get any support from family. The steering issue occurred very badly and suddenly on 3/13/2017. Stabilitrac service warning light ABS and traction lights have been on since february 15 went to dealership on 20th they said they would look when I mentioned it, the issue wasn't looked at or even noted just may need 2 front tires. Currently at 75,259 miles I got the car in 2015 with about 45,000 miles. Do have documents from the two visits to the dealership and one visit from another mechanic. Also didn't realize a recall or issue has occured with a solenoid as my engine light went on and after taking it to a mechanic shop versus the dealership I paid 400$ and found out that was recalled at one point prior to me owning the vehicle.
The ABS light has come on stating that I did not have stabil track control anymore. This happened when I was entering a busy road when I spun tires on some gravel on pavement road surface. It happened when I spun tires on a icy road driving at about 35 miles an hour due to road conditions. It happened when I was driving down a dry pavement state highway at 65 miles an hour. A total of three times. Every time it was the same problem but different wheels. It has happened with lr, rr and rf wheels part replaced was 13589507w-(s) wheel bearing assembly. The problem is the encoder ring which is part of this assembly is cracked, pieces gone or the whole thing gone. There was not a problem with earlier versions of this encoder ring. I understand that this part will be on the new 2017 models and that it will affect the computer even more than the 2013 version with some features such as cruise control.
Tl* the contact owns a 2013 chevrolet malibu. The contact stated that the electrical system intermittently stopped functioning, which resulted in a loss of power steering, ABS functionality, and the windshield wipers operated independently. The failure occurred without warning. The failure occurred approximately eight times. The vehicle was taken to the dealer where it was diagnosed that the solenoids needed to be replaced. The vehicle was repaired, but the failure recurred. The vehicle was taken to the dealer, but not repaired due to the manufacturer's denial of the claim. The manufacturer was notified of the failure. The VIN was unknown. The failure mileage was approximately 60,000.
Stabilitrac light and ABS light came on. Diagnosed both the left rear and right rear encoder ring for wheel speed sensor broken. Both rear wheel hubs had to be replaced.
Abs warning light came on along with message to service stabilitrak.
Service bulletins that may apply
- This bulletin advises the dealers to maintain the vehicle stock on hand by doing a full inspection on the...
- This service bulletin provides information for tire pressure monitoring (TPM) system concerns.
- Service brakes, hydraulic: pedals and linkages
- Parking brake
- This informational bulletin provides information on installing the correct tires for vehicles with the...
- This preliminary information communication provides information to the technician on how to diagnose and...
- This preliminary information communication provides information to the technician on the steps needed to...
- This informational bulletin provides technicians with a brake lathe calibration procedure.
Related recalls
No recalls on record for this model year.
Questions about the 2013 Chevrolet Malibu abs
Is ABS light or ABS activating a common problem on the 2013 Chevrolet Malibu?
13 of 837 owner complaints about the 2013 Chevrolet Malibu (2%) mention ABS light or ABS activating. The model year with the most reports is 1998.
Is there a recall or service bulletin for this on the 2013 Chevrolet Malibu?
There are 0 recalls and 35 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2013 Chevrolet Malibu
Stalling 105Check engine light 101Loss of power 82Power steering loss 43Steering lock-up 41Jerking 37Airbag light 28Engine failure 23Screen failure 23Won't start 23Overheating 21Warning lights 20Fire or smoke 16Headlights 16No deployment 11Hesitation 9Adaptive cruise 8Battery drain 8Brake failure 8Fuel gauge 8Key fob 6Wipers 6Backup camera 5Door locks 5Fuel pump 5Pulling 5Won't shift 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 Chevrolet Malibu?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history