The consumer experienced a brake problem. The rotors rusted which caused the brake pads to wear prematurely. *jb the rotors rusted and pitted causing the three inside pads to be ground away.
1999 Chevrolet Silverado: rotors or pads wearing out early
5 of the 1,659 complaints about the 1999 Chevrolet Silverado describe rotors or pads wearing out early.
- owner complaints
- 5
- of this car's complaints
- 0%
- recalls
- 3
Rotors or pads wearing out early by model year
What owners say
The consumer stated the brake rotors experienced premature wear. When the brakes were applied, the vehicle experienced extended stopping distance and there was a heavy vibration. *ak four rotors were replaced along with the brake pads. Gm did not offer any assistance. *scc
Emergency brake adjustment problem has caused excessive brake rotor wear, affecting brake operation. Ts....
Brake pads wear down abnormally, brake pedal is spongy(hard).
When vehicle is driven on a wet surface it begins to slide. Tires were replaced due to premature wear. Dealer has been contacted.*ak
Service bulletins that may apply
- Service brakes, hydraulic: pedals and linkages
- Chevrolet/gmc/cadillac: anytime hydraulic brake pipes assembly need replacing, pre-formed and pre-flared...
- Antilock brake (ABS) activation at low speeds (clean wheel speed sensor mounting surface)
- ABS light on, dtc's C0265, C0201, U1041 set and/or loss of communication with brake module
- Antilock brake (ABS) activation at low speeds
- Anti-lock brake system (ABS) light on, diagnostic trouble codes (DTCS) C0265, C0201, U1041 set and/or loss...
- Supplement to 04094 front wheel speed sensor corrosion
- Product safety recall regarding front wheel speed sensor corrosion
Related recalls
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
- Risk
- This can cause increased stopping distances during low-speed brake applications, which could result in a crash.
- Remedy
- Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet at 1‑800‑630‑2438 or gmc at 1‑866‑996‑9463.
Recall number 05V379000 · Recall details
Parking brake
- What is wrong
- On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle.
- Risk
- If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
- Remedy
- Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet at 1‑800‑630‑2438 or gmc at 1‑866‑996‑9463.
Recall number 05V161000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there can be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
- Risk
- During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
- Remedy
- Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.
Recall number 00V345000 · Recall details
Questions about the 1999 Chevrolet Silverado premature wear
Is rotors or pads wearing out early a common problem on the 1999 Chevrolet Silverado?
5 of 1,659 owner complaints about the 1999 Chevrolet Silverado (0%) mention rotors or pads wearing out early. The model year with the most reports is 2000.
Is there a recall or service bulletin for this on the 1999 Chevrolet Silverado?
There are 3 recalls and 26 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1999 Chevrolet Silverado
ABS 582Brake failure 124Tire blowout 31Grinding brakes 26Seat belt 21No deployment 20Knocking 19Harsh shifting 18Fuel gauge 17Stalling 16Jerking 15Pulling 11Headlights 10Steering noise 10Sudden acceleration 10Power steering loss 9Battery drain 8Loss of power 8Spongy pedal 8Fuel pump 7Water leak 7Ball joint 6Fire or smoke 6Power windows 6Slipping 6Won't shift 6Whining noise 6
VIN decoder
See the problems and recalls for an exact car
Buying a used 1999 Chevrolet Silverado?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history