The contact owns a 2017 Chrysler Pacifica. The contact stated that while driving at various speeds and while driving 70 MPH on a toll road, the steering wheel unintendedly pulled to the right, nearly causing the vehicle to drift out of the intended lane. The contact was able to pull the steering wheel back to center after each failure, and the steering wheel was moderately difficult to turn. The vehicle was taken to a dealer, where it was test-driven, but the failure could not be reproduced; however, the failure persisted. The failure mileage was approximately 58,000.
Chrysler Pacifica pulling problems
21 of the 7,086 owner complaints about the Chrysler Pacifica describe pulls to one side, most of them for the 2018 model year.
- owner complaints
- 21
- worst model year
- 2018
- typical mileage
- 71,000
Is there a fix? No recall or service bulletin covers this area of the car yet.
By model year
Often reported together
Power steering loss 2Ball joint 2Stalling 1Shudder 1Seat belt 1Key fob 1Headlights 1Harsh shifting 1
What owners say
While driving my 2018 Chrysler Pacifica FWD with approximately 86,000 miles, I have noticed abnormal steering behavior when going around gradual curves. The steering does not feel smooth and natural through the turn, and I feel like I have to pull/force the steering wheel to continue through the curve. The steering can feel like it is sticking or resisting rather than smoothly following the turn. This is concerning because it affects the vehicle’s steering response while driving. I brought the vehicle to a mechanic, who inspected it and diagnosed a problem with the steering rack assembly. I was quoted approximately $3,400 to replace the steering rack assembly. I am reporting this because I understand the federal safety agency is investigating steering problems involving 2017–2018 Chrysler Pacifica vehicles, including reports of steering sticking during gradual turns. The steering wheel does not simply pull to one side; rather, it feels as though the steering itself is resisting or sticking while I am making the turn.
When driving at higher speeds, around 50 mph +, the steering wheel gets stuck into position. You have to over correct it out of the stuck position to stay in the lane. When in a turn, it get stuck around 1 or 11 o'clock and you have to pull hard to the left or right to get it out of the stuck position, which makes you drift into the wrong lane in the stuck position, then swerve towards the wrong lane to fix it. It seems to be getting worse over time. When driving at low speeds, 5mp +, when in a turn, the whole steering wheel column shudders when going back to the straight position. It happens when turning into driveways and parking lots, and can be very startling. The vehicle has been taken to Chrysler service centers multiple times but they always say they can't recreate the problems.
The contact owns a 2018 Chrysler Pacifica. While driving at an undisclosed speed on the highway, the vehicle suddenly veered to the left on its own. The contact continued driving for a short distance before the vehicle pulled hard to the left a second time. The contact pulled over safely and contacted law enforcement, and the vehicle was subsequently escorted off the highway. The contact then observed multiple warning indicators illuminated on the instrument cluster panel, including the power steering warning light, but could not recall the remaining indicators. The contact referenced the federal safety agency Campaign Number: 19V348000 (Electrical System) to be the cause of the incident however, the VIN was not included in the recall. The vehicle was towed to a independent where it was diagnosed to have a loss of communication Mod A. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 166,303.
The contact owns a 2017 Chrysler Pacifica. The contact stated that while driving at an undisclosed speed, the steering wheel failed to turn in the intended direction. In addition, the contact stated that the transmission slammed into gear while shifting. No warning lights were illuminated. The contact stated that the steering wheel pulled to the left while the contact was attempting to go to the right. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The contact referenced an unknown recall; however, the VIN was not under recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 125,000.
When i put van in park ,shut off,it moves a little even on flat surface.When i back up in grass or out of a sloped driveway the van acts like something is preventing it from going backwards.The van,when going from the right lane to the left will act like it pulls to the right,hard to explain.Also when going down a road with slight bumps it makes a noise like something is loose,a rattle like.
There is a loud clicking and popping noise from the front drivers side suspension when turning or going over bumpy ground. The car also pulls to one side unexpectedly when going around corners Sometimes while driving the car will shut down and restart as if rebooting a computer.
When I first purchased my 2021 Pacifica Hybrid Pinnacle in January 2021, randomly when pressing the lift gate button in the top left of the trunk it would beep multiple times and the lift gate would not move. The key fob, front button, and rear button would not engage the lift gate motor. You had to manually shut the lift gate and it would latch. Then in November 2021 I had the Y50 2021 RU Power Lift gate recall done on my vehicle and since then three times while driving the lift gate has popped up on its own. When you pull over all buttons are unresponsive and when you manually close the lift gate the locking mechanism does not engage. It just pulls right back open by hand or while driving. To resolve you must try over and over shutting the door, pressing the buttons, turning the vehicle on and off multiple times, letting it sleep and turn it back on and eventually the locking mechanism will engage. Have brought it multiple times to the dealer and every time they cannot recreate. Poses a dangerous safety issue while driving for the lift gate to open as you don't realize its not latched.
1st time on highway kept pulling to right on my oil change told dealer. He said he couldnt find anything and no warning light came on. 7/2020 I believed it was a safety issue to have no control and car was pulling and locking Havent traveled to far with pandemic. Went away for awhile upstate and driving home it worse so bad just driving and changing lanes it locked up and was hard to get it back in my control to turn to right it just shaked shimmed. i was really scared not to be able to drive my car smoothly. no inspection just the dealer the first time no warning or light came on
The power steering assist is not working properly, the car pulls to the right and it's hard to get it back on the road, there is a recall v053 to address a power steering issue, but the dealer states that recall is not causing my problem and to fix the issue will cost $3400.00. How do I know if the recall is the problem or troncalli's diagnostic test results?
Related recalls
No recalls on record for this model year.
Questions about the Chrysler Pacifica pulling
Which Chrysler Pacifica years have pulls to one side problems?
The model years with the most reports are 2018 (6 complaints), 2017 (5 complaints) and 2004 (4 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Chrysler Pacifica?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history