The driver door started making a popping/creaking sound when I opened and closed it. The sound was quiet at first, like I wasn't even sure I heard it right, then it got really loud and stopped altogether and my window wouldn't roll down properly. The sound only lasted a week or two fron when it started to when it stopped. I took it to the Ford dealership where I bought it, and they told me the door check became UNWELDED inside the door.
2020 Ford Escape body complaints
Page 19 of 24: complaints 521 to 550 of 671, newest first, as owners wrote them.
The contact owns a 2020 Ford Escape. The contact stated that while attempting to exit the vehicle from the driver's side, the door made an abnormal sound and was difficult to open. The vehicle was taken to the dealer, who determined a structural failure of the door well. The vehicle was not repaired. The manufacturer was notified of the failure but was unable to assist. The failure mileage was 56,000.
The contact owns a 2020 Ford Escape. The contact stated while opening the driver's side door, he heard an abnormal popping sound. The contact stated that the popping sound was intermittent at first but had become a recurring failure. Additionally, the driver's side window failed to open and close normally. The contact observed four missing spot welds on the door hinge. The contact also stated that the passenger’s side door had started making the popping sound while opening the door. There were several spot welds missing. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that the driver's side door needed to be replaced, but at the owner’s expense. The vehicle had not been repaired. The manufacturer had been informed of the failure. The contact researched online and related the failure to the federal safety agency Action Number: PE23013 (Structure). The failure mileage was approximately 61,000.
My driver door hinge has come apart from door due to welding, which has impacted my window from going down and although i lock the doors they are still able to come unlock by pulling door handle which leaves my car vunerable to vandelism or theft. i made an appointment and got the first date available. My vehicle is a lease and out of warranty although I paid for extra miles and after showing them all the data from the federal safety agency they want me to pay $450-$500 and be without a vehicle for a minimum of 4 days with a max of 5 without a loaner and for me to pay for a rental car on top of paying monthly note along with repair and rental which already has inflated rates. They need to fix and have a recall. This is dangerous and can be costly considering your car door is unlock in the "lock position".
Driver side door is making a clanking noise when opening and closing. I also had difficulty closing and keeping the door closed. The window will not open more than 6 inches. Door hinge or door stop on the interior of the door has some welding part that my mechanic says has broken within the door's frame. He identifies this as a manufacturing problem, not something my mechanic will attempt to fix.
The door limiter is ripped free of its mounting [inside the door] and makes keeping the door closed and/or opening it impossible at times. In addition, the broken pieces in the door damaged the window regulator, making egress through the window equally impossible. Our safety is put at risk due to the possibility of the door opening while driving as well as the safety of oncoming traffic. Both Ford dealer and independent body shop confirmed that they have seen this problem on many other Ford vehicles, and the only remedy is a complete door replacement. Prior to door failure, there was a lot of creaking and difficulty closing the door. When we first bought the car [new], the door was not closing correctly, and the dealer claimed that the weatherstripping was the issue. Now that the car is OUT of warranty, Dealer mechanic confirmed this door limiter breaking from the spot welds is a common occurance, yet not yet under recall for my VIN number.
Driver's door hinge limit opening check-arm mechanism failure. First awareness when popping noise occurred when opening and closing the door. Internet search found this and related hinge failure experiences by many other Escape owners. The factory welds attaching the mechanism housing to the interior of the door body are failing. Ford has not made a recall. While this is a primary vehicle function, our car is slightly out of warranty and the Indianapolis Skillman Ford dealer offered no help after presenting the vehicle in-person as soon as the problem occurred. Our check arm has not completely failed. Complete failure reports include interference with power window operation and inability to safely open and close the door. We contacted Ford Motor Company direct; the person on the phone checked and said there was no recall and no assistance due to our vehicle being past warranty but they did create a case#: SSM 51553.
The left front drivers door is difficult to open and close due to broken factory spot welds on the door where it attaches to a factory mechanism. This causes the door to make a popping sound and makes it periodically difficult to both open and securely close the door.
Door welds have broken and door arm is not attached to door any longer. Door has been inspected by Ford and are unwilling to fix due to it being weeks out of warranty.
The contact owns a 2020 Ford Escape. The contact stated that when he opened the front driver’s side door, he heard a cracking sound. Upon inspecting the door, he noticed that the hinge had loosened and that the spot welds had cracked. The vehicle was taken to the dealer where the contact was advised by the technician to take the vehicle to an auto repair shop. The contact was informed that the front driver's side door might need to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and the contact was informed that the VIN was not included in a recall and advised to call the federal safety agency Hotline. The failure mileage was approximately 73,000.
The contact owns a 2020 Ford Escape. The contact stated while opening the driver's side door, she heard an abnormal popping sound. The contact stated that the failure had become constant. Additionally, the driver's side window failed to roll down. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed and had not been repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 44,000.
Door mechanical issue could become a future safety issue where failed/poor spot welds on a doors check arm bracket could cause the door to swing too far when opened or it could open while driving because of the spot weld failure. Current popping sound when opening and closing the door indicates spot welds on the check arm bracket, internal to the door, have failed, making the door difficult to open and close. A secondary failure is the inability to open and close the window.
My front drivers door started squeaking and yesterday it started making this crunching noise. I noticed that I have three holes on the inside front door panel where the hinges are. I was told by a mechanic that the door check arm on the interior of the door the weld did not hold and that was the noise I was hearing it braking. I can not open my door all the way and it gets stuck open sometimes. I called Ford and because my car is 2800 miles over warranty they will do nothing. Upon investigation I have found you have an investigation into this problem SSM 50150. I have a Ford 2020 Escape. How is it that the weld on a 3 year old car breaks? I have not had it repaired because of the cost involved. I feel this should be escalated to a recall.
Driver’s door started to make a loud popping sound. Found that weld spots on the door had failed. Local dealer removed the door check so now the sound is gone but need to be careful opening door in the wind. They have quoted $2,235 to replace the door! Already charged me $52 to remove the door check. I don’t feel safe driving this car being unsure if the door will stay latched. I hope there is a recall by Ford to fix this problem.
The welding spots on the fort broke off.
My drivers side door makes a creaking noise and window doesn’t roll down
The component or system that is failing/malfunctioning is the opening and closing of the driver side door. Yes, it is available for inspection upon request. My safety/the safety of others are put at risk should the door opens during driving or at any time without a physical being opening it. No, the problem hasn’t been reproduced or confirmed by a dealer or independent service center not to my knowledge. The vehicle or component has not been inspected by the manufacturer, police, or insurance representatives but has been inspected by myself and others. No, there was not any warning lamps, or messages of the problem prior to the failure. However, there was other symptoms which included a mild sounding popping noise coming from the driver door when opening it to enter and exit the vehicle. This first appeared about two days prior to the component or system complete failure/malfunction.
Driver side door the door spot weld that is for the door arm that opens has broken on 07/28/2023. Took it to local ford dealership not covered past 3 year 36000 mile warrantty. This is a defect from ford and should be covered
Door is making popping sound when open. Both driver side and passenger front doors. The driver side window won't roll down.
Drivers side check arm broke resulting in 3 rivet joints to break where it’s attached to the inside door skin. SSM 50150 for fleet vehicles addresses this. This was purchased from Enterprise. Was told a new door skin was required along with the check arm replacement. Over $1200. This should be a recall.
Driver's side door not closing completely, making loud cracking noise. Unable to roll window down. Door not closing completely is a safety hazard while traveling, concerned the door might open while moving. Because the door isn't closing all the way, it's messing up the electronics as well. The door welds where the bracket attaches has come detached.
Spot weld on door may exhibit cracks or broken spot welds in the left front door at the check arm attachment point in the door assembly. Door pops and cracks when it is opened or closed due to welds failing. We took it to the ford dealer and they told us there is not a recall on it so we will have to pay for the repair and IF there is a recall on it they will pay us back for the repair cost. Will that be the dealer price or the price we had to pay at another garage? We have a repair scheduled at another garage. It will be $400. IF YOU DON'T OWN A FORD, DON'T BUY ONE. This model already has had 10 recalls! Ford don't build cars, they build junk! DOES ANYONE KNOW IF THERE IS A CLASS ACTION LAWSUIT YET?
The front left drivers door check guide bracket spot welds have separated from the door frame resulting in the door not opening and closing properly,the window will not roll down or up with the door closed .The door can only open about half way and doesn't shut properly without using unexcusable force .The spot-welds are clearly broken because there are 3 holes in the door where the door check mounting bracket is spot welded to the door shell .If I need to get in or out of the vehicle very fast in an emergency,the door may not open enough for me to get in or out or may not even open at all.If I need to roll down the window with the door shut in an emergency situation I will not be able to,I would have to break the window to escape danger.Ford needs to be responsible for fixing this problem that is clearly a manufacturing defect .A recall by Ford is due immediately to fix this dangerous issue.
When opening and shutting the drivers door it makes a terrible popping noise and is hard to shut.
The contact owns a 2020 Ford Escape. The contact stated there was a clicking sound while opening and closing the front driver's side door. The contact stated that the front driver's side window failed to roll down completely. The contact stated that eventually the front driver's side door failed to close as needed. Upon inspection it was discovered that the front driver's side door middle weld had separated. The cause of the failure was not yet determined. The vehicle was taken to the local dealer who indicated that the door needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure but no assistance was provided. The failure mileage was 11,000.
My check arm broke at the welding sites and has now affected my locks, window, and the door staying open/shut. I am worried about my window shattering and my door not closing or opening while I am driving. My locks are no longer working which leaves me to be worried about someone getting into my car, since there is not way for me to lock my door. They don’t even work with the key fob. The outside manual lock will not turn. The problem was confirmed by the dealership Ken Stoepel Ford In Kerrville, TX. But they will not fix it because it is out of warranty due to mileage. There was no warning of this. I was parked when it happened. I simply opened my door to get in and it snapped.
The contact owns a 2020 Ford Escape. The contact stated while attempting to open the front driver’s side door, the door failed to open all the way. Additionally, there was a cracking sound coming from the door. The vehicle was taken to the dealer and the contact was informed that the door weld on the front driver’s side door had fractured, and that the door needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and stated that assistance would be provided with the cost of the door replacement. The failure mileage was 30,000. The VIN was not available.
In February 2023, we noticed a popping/ snapping sound coming from the driver's door and it would not stay open on its own. Over the next couple weeks the power window began having trouble staying up and then it simply would not stay up at all. In March I took it to the dealership it was purchased from and had it looked it. After a couple hours I was told that the spot welds had failed and that the only way to fix it was to replace the entire door at my expense (approx $2k). The gentleman in charge told me it was not the first he had seen with this issue and if I got it repaired anywhere to keep my receipt for any issues recalls. The only solution I had was to have my husband get the window into place and disconnect the electrical to the window buttons. I have also had to deal with many bruises on my legs due to the door randomly closing on me while getting in and out. I'm disabled and this is a major problem for me. I have personally inspected the door and there are three holes next to the interior door panel that I believe are the location of some of the broken welds.
My car is displaying similar symptom found on a fleet version of the car - SSM 50150 - 2020-2021 Escape - Cracked Or Broken Spot Welds In The Left Front Door At The Check Arm Attachment Points In The Door Assembly.
The door started popping when it was opened and closed. After one day the weld completely busted loose and the window no longer rolls down either.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 Ford Escape?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history