The vacuum pump has been recalled on same year, make and model vehicle, yet my particular VIN is falling to the wayside. IT HAS A VACUUM PUMP issue, causing the brakes to malfunction at slower rates of speed. A "computer programming recall" was applied to my VIN however it is the ACTUAL Vacuum pump that is the problem. This should have been covered in all year, make and models. BRAKES ARE IMPORTANT! Reprogramming did not solve the vacuum pump issue that is causing the brakes to fail! This is absolute negligence on behalf of General Motors.
2014 GMC Sierra 1500 brakes problems
144 complaints (19% of all complaints for this car). Typical mileage when it fails: 71,500. 10 crashes reported.
- owner complaints
- 144
- of this car's complaints
- 19%
- typical mileage
- 71,500
- crashes
- 10
- recalls
- 1
Which part fails
- Power assist: vacuum1
At what mileage
Complaints by mileage at the time of the problem.
0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+
GMC Sierra 1500 brakes problems in other years
Specific symptoms reported on the 2014 GMC Sierra 1500 brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: power assist: vacuum
- What is wrong
- General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.
- Risk
- As the vacuum level drops, the brake assist decreases, increasing braking effort, extending the distance required to stop the vehicle, thereby increasing the risk of a crash.
- Remedy
- GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began October 8, 2019. Owners may contact Chevrolet customer service at 1‑800‑630‑2438, Cadillac customer service at 1‑800‑458‑8006 or GMC customer service at 1‑800‑462‑8782. GM's number for this recall is N192268490.
Recall number 19V645000 · Recall details
Related investigations
Brake Vacuum Pump Failure
On November 20, 2018, the Office of Defects Investigations (ODI) opened PE18-012 to investigate instances of sudden onset of a hard brake pedal that could result in extended stopping distance due to an issue with the brake assist vacuum pump in model year (MY) 2014 through 2016 GMC Sierra 1500 and Chevrolet Silverado 1500 series pickup trucks and MY 2015 through 2016 Cadillac Escalade, Chevrolet Suburban, Chevrolet Tahoe, and GMC Yukon SUVs.If the brake assist vacuum pump fails to operate as intended, the amount of brake power assist supplied to the driver can be significantly reduced, extending the subject vehicle stopping distance. GM stated that the root cause of pump failures was due to foreign debris such as oil sludge in the engine oil. GM stated that this debris can become trapped by the oil inlet filter screen. Under normal operation, this screen allows a small amount of oil into the brake vacuum pump. The foreign debris can, over time, clog the pump which can cause a loss of lubrication and a reduction in the amount of vacuum produced leading to a hard pedal and extended stopping distance.On December 13, 2018, GM issued a Special Coverage (N182202780) for the brake vacuum pump issue in MY 2014-2017 trucks and 2015-2017 SUVs on the K2XX platform for 6 years or 72,000 miles. Special Coverage repair includes the replacement of the vacuum pump and vacuum pump belt. Consumers received notification of the coverage via mail. On September 6, 2019, GM notified the federal safety agency that it was conducting safety recall 19V‑645 which reprograms the electronic brake control module (EBCM) and included approximately 3.5 million trucks and SUVs. In October 2019, GM extended the terms of special coverage N182202780 to 10 years or 150,000 miles as well as now including the entire scope of recall 19V‑645. In October 2020, GM expanded the scope of coverage N182202780 to include the MY 2018 Escalade and 2019 Tahoe.The remedy implemented in GM recall 19V‑645 appears to be sufficient in addressing the safety-related concerns of this issue. Loss of vacuum assist now occurs at a progressive rate as well as there being a more timely warning of a brake problem to the driver through the driver information center (DIC). In view of the recall action and revision to the special coverage, this Preliminary Evaluation is closed. The agency reserves the right to take additional action if warranted by new circumstances. The ODI reports cited above are available for review online at under the identification numbers in the attached document.
PE18012
What 2014 GMC Sierra 1500 owners say
Most recent owner complaints, unedited.
The contact owns a 2014 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. No warning lights were illuminated. The contact stated that the brake pedal was depressed to the floorboard. The failure also persisted while driving downhill. The vehicle was taken to an independent mechanic. The contact was provided information for the federal safety agency Campaign Number: 19V645000 (SERVICE BRAKES, HYDRAULIC). The vehicle was taken to the dealer; however, the vehicle was not diagnosed or repaired. The contact was informed that the manufacturer had closed the warranty, because the vehicle exceeded 100,000 miles. The manufacturer was not made aware of the failure. The failure mileage was approximately 156,000.
Pressing the brakes more than once locks the brakes up multiple times this has happened. Not an isolated event
The brakes on my GMC Sierra 1500 lose braking power when operating at slow speeds. The brake pedal will lose braking power, causing the vehicle to not stop at slow speeds. This is particularly troubling when pulling into and out of parking spots, driveways, crosswalks, and other areas. I use my truck to pull a boat and when I back my boat into the water at a boat launch, the brakes will lose power when I am in reverse causing the truck to slid into the water.
I am experiencing an issue with a hard brake pedal on my 2014 GMC Sierra 1500. This same issue was previously addressed through a recall and special coverage program by GM, which I had performed. However, the hard brake pedal condition has returned, significantly impairing stopping power at low speeds. This poses a serious safety risk, especially when towing or parking. I can no longer park my trailer safely. The vehicle is difficult to stop, and braking distance has increased substantially. This is a known issue with this model and year. It appears the prior recall may not have adequately resolved the root cause. I am requesting that the federal safety agency investigate whether additional action or recall extensions are warranted.
This vehicle has the same issue as other recalled GMC Sierra vehicles - the brake booster pump is failing, causing braking difficulty, particularly at low RPM and after repeated presses of the brake pedal.
I was backing my boat down the ramp and the brakes were giving out. I know this was a recall issue, in the past, that I had repaired. Clearly, they repaired it with the same faulty part because it has happened again. When I took it to be repaired they said I had to pay for it this time. The issue wasn't resolved but only deferred until later, with a temporary fix. I could have ended up in the river and drowned. Paying the dealership to fix a safety issue caused by their defective parts is ridiculous.
The contact owns a 2014 GMC Sierra 1500. The contact received notification of the federal safety agency Campaign Number: 19V645000 (Service Brakes, Hydraulic) however; the contact disregarded the letter. The contact stated that while attempting to parallel park, the brakes failed to operate properly. The contact stated that the brake pedal became abnormally stiff. The contact was able to operate the brake pedal and park the vehicle. The vehicle was then taken to a dealer for a routine oil change, and the vehicle was diagnosed with a non-functional vacuum pump. The vehicle was not repaired. The manufacturer was made aware of the failure; however, the contact was informed that the recall had expired. The failure mileage was approximately 135,000.
Power steering was going in and out then all of a sudden completely went out.
When I am braking at low speed my brakes start locking up and eventually do not work. This has happened on multiple occasions. I have almost wrecked multiple times I rarely drive my truck now cause it is unsafe. There is a recall on the brake booster 2014 to 2018 gmc seria but my truck vin is not included on that recall and it’s doing the exact same thing. GM recalls 3.4 million pickups and SUVs over brake pump Sept. 12, 2019 1 The recall includes the Chevy Silverado and GMC Sierra (model years 2014-2018), and affects a vacuum pump defect that may make it more difficult to brake at low speeds.
Questions about the 2014 GMC Sierra 1500 brakes
Does the 2014 GMC Sierra 1500 have brakes problems?
Owners have filed 144 complaints about the brakes of the 2014 GMC Sierra 1500, 19% of all its complaints.
At what mileage do 2014 GMC Sierra 1500 brakes problems start?
The typical (median) mileage in owner complaints is 71,500 miles.
Was there a recall on the 2014 GMC Sierra 1500 brakes?
Yes, 1 recall: 19V645000. Check your VIN to see if your car still needs the free repair.
What year does the GMC Sierra 1500 have bad brakes?
The GMC Sierra 1500 model years with the most brakes complaints are 2015 (229 complaints), 2014 (144 complaints) and 2000 (131 complaints).
Other 2014 GMC Sierra 1500 problems
Steering 156Lights 148Electrical 129Engine 72Transmission 69Driver assistance 61Body 31Airbags 26Suspension 24Visibility 21Seat belts 19Fuel system 16Acceleration 12Wheels 7Seats 5Tires 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2014 GMC Sierra 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history