I had the L87 recall completed, and the vehicle passed inspection. The dealership completed the required protocol and replaced the engine oil with 0W-40. Approximately 6,000 miles later, while traveling at about 75 mph and six hours from home, I experienced a brief loss of power followed by an immediate return of power. My wife and I noticed it but, with no warning lights or alerts, continued driving while monitoring the vehicle. About 10 miles later, we began hearing a faint squealing noise that progressively became worse. I was able to exit the highway safely, but once I came to a complete stop, the engine shut off and would not restart. I had the vehicle towed to the nearest dealership, where it was determined that I had suffered a catastrophic engine failure. No loaner vehicle was available, leaving my family stranded six hours from home with an inoperable vehicle. It took approximately seven to eight weeks for the repair to be completed. When I received the vehicle back, I immediately noticed something still was not right. At around 40 mph and 1,000 RPM, the truck would shudder or hesitate. My local dealership diagnosed a poor spark plug connection on cylinder #3, which was causing arcing and a misfire. After the connection was repaired, the issue was resolved. My local dealership is currently working with the repairing dealership to address several minor workmanship issues, including wire clips, fittings, and missing bolts. This entire event was unexpected. There were no warning lights, alerts, or unusual noises before the initial loss of power. The only indication of a problem was the sudden power loss followed shortly thereafter by a horrific screeching noise. Thankfully, I was able to safely exit the highway and bring the vehicle to a stop. Considering I was traveling at 75 mph, the situation could have been much worse.
2021 GMC Sierra 1500: grinding or squealing brakes
9 of the 603 complaints about the 2021 GMC Sierra 1500 describe grinding or squealing brakes.
- owner complaints
- 9
- of this car's complaints
- 1%
- recalls
- 0
Grinding or squealing brakes by model year
What owners say
For close to one year, there feels like a catch, grind, stall, or slight shake, mostly while the vehicle is shifting gears, made worse or noticed more by higher speeds like driving on the highway vs. slow city streets. It's difficult to explain or assess so not sure if it is the engine or transmission. With the open recall from GMC on some vehicles with the same engine as mine it is concerning that maybe it should have been included.
While driving, the vehicle experienced a sudden and momentary loss of power, similar to briefly applying the brakes, after which power resumed. This was followed by a progressively louder squealing noise. I pulled over to investigate, at which point the engine shut off and a low oil pressure warning appeared on the dashboard. The vehicle would not restart. The vehicle was then towed to a dealership, where initial inspection suggested the issue may be related to the L87 recall involving the crankshaft bearing.
While driving my vehicle, the engine and transmission lost power and the check engine light came on. The vehicle went into limp mode and engine propulsion was limited. Had I been traveling at a faster speed, this would have been very unsafe. After coming to a stop, placing the transmission in reverse did not move the vehicle and there was a grinding noise. I was able to savely move forward in limp mode, but the shifting was harsh. I was able to find an empty parking lot to safely park. The truck was towed to Jim Winter dealership in Jackson MI for inspection.
Following the remedy of the engine recall in 2025, the truck started having intermittent electrical issues (i.e. warning lights on dash turn on/off: service 4WD, Loss traction Control, etc) come one while the truck is being driven. If the truck is turned off while the dash warning lights are on, it will NOT Start for about 24 hours. If the warning lights are ignored, eventually they will go off on their own. Additionally, the truck is having "no-start" problems (randomly the truck does not start, then after a few days it starts). A New development, when backing up there is a scraping/squealing sound (possibly universal joint). Truck has been back to the dealership that replaced the engine block for the recall and they have failed to identify any issues as these problems are intermittent. Engine Recall Replacement Invoice (Attached)
Engine developed a low knock type noise just above idle while beginning to move in the parking lot. It was also noted pulling away from an intersection at low rpm under light acceleration. Oil pressure was normal, 30 psi and approximately 50-60 at cruising speed. Low level knock began earlier in the day but no other symptoms. Oil level was checked and found to be at proper level. At mile 2 into my trip a chirping/ squeak type noise was heard under light throttle and light load at approximately 1500 rpm. The noise stopped when accelerator was released. Rough running sensation followed the noise under the load. Noise returned when the accelerator was pressed and then the engine stopped running while traveling 45-50 mph. Placed the shifter to neutral and attempted to restart, engine rolled slowly for a brief moment and then locked up entirely. Starter only clicks when attempted after that. Vehicle left me stranded with no heat on the shoulder of the highway in the dark in Northern Michigan on March 5, ambient temp was 28 degrees. Vehicle towed to closest dealership which is also where it was purchased for inspection on 3/6/2026. General motors customer care contacted and case opened. No assistance with repair at time of callback.
I have had shuddering on the highway and a few hard random diwnshifts. Last week I went to start my truck and the transmission started grinding and rattling. I was told after towing to the dealer it needed a transmission due to pump not getting enough fluid and had failed. I was told I needed to pay, even though the part causing the problem had a extended 150,000 miles and the subsequent pump failure is a result of the control valve failure.
The contact owns a 2021 GMC Sierra 1500. The contact received notification of the federal safety agency Campaign Number: 25V274000 (Engine and Engine Cooling). The contact stated that while driving at approximately 50 MPH, there was a loud squeaking sound coming from the front driver’s side of the vehicle before the vehicle lost power. Simultaneously, the check engine warning light started blinking. The vehicle was pulled over to the side of the road and the sound became louder, before becoming a knocking sound. The vehicle was restarted, and the failure persisted. The vehicle was towed to the residence. The vehicle was not diagnosed or repaired, but a dealer stated that there was as recall associated with the VIN; however, parts were not yet available to repair the vehicle. The manufacturer was not notified of the failure. The failure mileage was approximately 128,000. VIN tool confirms parts not available.
At cold start-up, engine (6.2) makes a metal-to-metal grinding sound for 60-90 seconds. After warm-up, a steady tick on the right side of the engine while running. I contacted GM and they said, " this was normal at start up". however, with me being a mechanical engineer, all of my school and working experience tells me anything grinding metal to metal is not good.
Service bulletins that may apply
- This informational bulletin advises the technician to check for faults that may be caused by the trailer...
- Service brakes
- Service brakes
- This bulletin advises the dealers to maintain the vehicle stock on hand by doing a full inspection on the...
- This technical bulletin provides a procedure to replace the rear calipers if found packed for of mud and...
- This service bulletin provides repair information to correct customer concerns of Rear Wheel Lock Up, ABS...
- Service brakes
- Service brakes
Related recalls
No recalls on record for this model year.
Questions about the 2021 GMC Sierra 1500 grinding brakes
Is grinding or squealing brakes a common problem on the 2021 GMC Sierra 1500?
9 of 603 owner complaints about the 2021 GMC Sierra 1500 (1%) mention grinding or squealing brakes. The model year with the most reports is 2014.
Is there a recall or service bulletin for this on the 2021 GMC Sierra 1500?
There are 0 recalls and 31 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2021 GMC Sierra 1500
Engine failure 115Check engine light 111Loss of power 65Knocking 56Misfire 25Oil consumption 21Stalling 21Shudder 19Won't shift 19Jerking 18Won't start 17Hesitation 15Transmission failure 15Harsh shifting 13Overheating 11Warning lights 11Fire or smoke 10Slipping 8Adaptive cruise 7Power steering loss 7Steering lock-up 7Headlights 6Screen failure 6Ball joint 5Fuel pump 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2021 GMC Sierra 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history