2022 GMC Yukon: engine stalls while driving

Filed Sep 1, 2026 · Engine, Fuel system · TX

My engine has failed twice. I am now on my third engine. The vehicle stalled while driving on a highway, was in the shop for nearly 3 months and was "fixed" with same 6.2 engine. Eight months later it stalled again was in the shop for 2 months with a new engine. I was informed that they still don't know the issue and they just put the same type of engine. A bandaid was placed in my vehicle and I'm suppose to feel safe in it.

Filed Aug 22, 2026 · Engine · WA

Engine would tick and burn oil after the updated recall was done. There would be a hesitation occasionally when applying gas when pulling out from stop sign or stoplight. The engine stalled and would not restart. It would crank over but it was a super fast and elongated turn over. We had to call a tow truck and have it towed. The dealership said they found nothing wrong and sent us back out with it. We sent it to another dealership would replaced the auto start stop switch, changed the belts, and did a fuel/valve treatment to clean the fuel system. We got it back and ran it less than 30 days when we picked it up from the dealership after we changed the engine oil, my wife headed out of town on the highway headed to pick up our daughter and the car made it less than 6 miles before it lost power and shut off going 65 mph and almost caused her to get in a wreck. The engine did not turn back over and would not start. Sent it back to the dealership and they found a crank bearing had seized and they replaced the engine. We just got it back but we are not holding our breath since we know so many people here in our small town who have had their engines replaced and we have heard of people getting multiple engines replaced! There fix is not a fix and when these motors go down at highway or freeway speeds it is extremely dangerous. It’s also dangerous for people when they get stranded out in the middle of no where.

Filed Jul 7, 2026 · Engine · 45,000 miles · PA

The contact owns a 2022 Chevrolet Yukon. The contact stated that while driving at an undisclosed speed, an abnormal knocking and ticking sound emanated from the engine before the vehicle stalled. The vehicle was towed to a local dealer, where it was diagnosed with total engine failure, requiring replacement. The vehicle was not yet repaired. The contact stated that the current engine was a replacement engine from a previous failure, which was tested prior to installation but also failed. Additionally, the contact stated after the failure, the transmission could not be shifted into Neutral, forcing the tow operator to drag the vehicle onto the flatbed truck. The manufacturer was not yet notified of the latest failure. The failure mileage was 45,000.

Filed Jun 8, 2026 · Engine · MI

The engine began making a metallic knocking noise while at idle and very soon after began to make the same noise under acceleration. This noise sounded very much like the onset of rod bearing failure. The vehicle was driven straight home and parked. We called the dealership the next day and made a service appointment. As I drove the vehicle to the dealership, the engine noise became worse and was clattering very loudly as I pulled into the dealership parking lot. I pulled into a parking spot and let the engine idle with the transmission in Park while I was collecting some personal items when the engine stalled. I tried several times to start the engine but it would not crank. The dealership engine tech later confirmed that the engine was seized

Filed Mar 29, 2026 · Engine, Transmission · LA

While driving on the interstate at highway speed, the vehicle suddenly lost acceleration and stalled. I was forced to pull over. After stopping, the vehicle displayed a message to restart, but it would not start. All electronic accessories (lights, dash, etc.) remained functional, but the vehicle would not shift into drive or neutral. The message “Conditions Not Correct for Shift” appeared. Nearly rear ended, this created a dangerous situation due to loss of power in active traffic and inability to move the vehicle on a 250,000 vehicle per day very busy tollway.

Filed Feb 20, 2026 · Engine · FL

Vehicle: GMC Yukon Denali Model Year: (insert) Engine: 6.2L L87 Mileage at Failure: 44,000 Failure Date: February 18, 2026 Recall: GM 6.2L Engine Failure Recall (crankshaft/bearing defect leading to propulsion loss) Complaint Summary: Complete engine failure and total loss of propulsion on a high-speed highway on-ramp with my family inside, causing extreme danger and emotional trauma. Full Description: On February 18, 2026, my GMC Yukon Denali experienced a sudden and complete loss of propulsion while we were on the on-ramp to a high-speed, heavy-traffic expressway. The engine failed without warning as traffic was accelerating rapidly around us. My husband, my [XXX] son, and I were all in the vehicle on our way to celebrate my son’s birthday. Instead, the vehicle died in one of the most dangerous locations possible — the merge zone of a busy highway — leaving us stranded with cars coming at full speed. Traffic immediately began backing up for a long stretch behind us. Drivers were honking, yelling, and aggressively swerving because the lane was blocked by our stalled vehicle. The situation felt chaotic and frightening. I genuinely believed we were at risk of being rear-ended at highway speed. We felt helpless waiting for police to arrive to protect us. The emotional distress, panic, and fear for my family’s safety were overwhelming. My son was shaking and visibly upset on what was supposed to be his birthday celebration. None of us felt safe until law enforcement was able to block traffic. After the incident, the dealership confirmed that the failure was caused by the GM L87 engine defect currently under recall and stated that the engine needed to be completely replaced. This sudden stall created a severe safety hazard that could have easily resulted in a catastrophic crash, injury, or worse. It has had a lasting emotional impact on me and my family. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Feb 12, 2026 · Electrical, Engine · WA

In 2023, the vehicle began exhibiting erratic transmission shifting behavior, including harsh and unpredictable shifts while driving. The vehicle was taken to a GMC dealer for diagnosis and repair. Recently, the vehicle developed additional drivetrain and engine control issues related to the crankshaft position sensor circuit. The vehicle stalled while driving on a highway mountain overpass with multiple vehicles traveling behind me. When the stall occurred, the vehicle shifted into park and would not restart for several minutes. This created a hazardous situation due to loss of propulsion in active traffic at highway speed and limited shoulder space. Following diagnosis, the servicing dealer determined that the engine wiring harness requires full replacement due to internal wiring integrity issues affecting critical engine control signals. The crankshaft position sensor and related wiring are essential for engine timing and propulsion. Loss or corruption of this signal can result in reduced engine power, erratic transmission behavior, stalling, or no-start conditions. The earlier erratic shifting behavior appears consistent with conditions described in GM Technical Service Bulletin 21-NA-149, which identifies engine harness-related causes for drivetrain and shifting concerns. This issue appears to involve degradation or defect within the engine wiring harness affecting engine management and transmission operation. Given that this condition resulted in a highway stall and temporary inability to restart, I am reporting this for investigation as a potential safety-related defect involving loss of propulsion.

Filed Feb 10, 2026 · Engine · 46,000 miles · AL

The contact owns a 2022 GMC Yukon. The contact stated that the vehicle was consuming an excessive amount of oil. The vehicle was taken to the dealer, where it was diagnosed, and metal shavings were found in the engine oil. The dealer replaced the camshaft and lifters; however, the failure worsened. The contact stated while driving approximately 65-70 MPH, the vehicle stalled and lost power steering functionality. The contact's husband was able to pull over to the side of the road. There was no warning light illuminated. The vehicle failed to restart and was towed to the residence. The vehicle was then picked up and diagnosed by the dealer. The dealer determined that the engine had seized and needed to be replaced. The contact had opened a case with the manufacturer for buyback assistance due to safety concerns. The vehicle was not repaired. The failure mileage was approximately 46,000.

Filed Aug 12, 2025 · Engine · CA

1. The engine is malfunctioning, leading to excessive oil consumption and random shutdowns. The vehicle is available for inspection at Alexander Buick GMC, Oxnard, CA, where it has been taken for repairs multiple times. 2. The engine's random shutdowns pose a significant safety risk. The vehicle can stall without warning while in motion, which could lead to accidents, especially in high-traffic situations or at high speeds. This puts the driver, passengers, and other drivers at risk. 3. Yes, the dealership Alexander Buick GMC has confirmed the excessive oil consumption and has observed the engine shutting down. However, they have not been able to determine the root cause of the shutdowns. 4. The vehicle has only been inspected by the dealership Alexander Buick GMC which is an authorized service center for the manufacturer. It has not been inspected by any other parties. 5. There were no warning lamps or messages consistently appearing before the engine shutdowns. Sometimes, the oil pressure warning light would flicker briefly before a shutdown, but not always. The excessive oil consumption was noticed approximately a year ago before the shutdowns began. Not too sure when these shutdowns started occurring.

Filed Jun 17, 2025 · Fuel system · FL

Vehicle stalls and shuts off. Unable to start back vehicle as it only cranks and unable to put it in neutral gear to push out of roadway or for towing.

Filed May 17, 2025 · Engine, Fuel system · NY

After only 47,000 the Yukon started with hard starts and triggering a check engine light. Owner suggested fuel issues, the dealership suggested a bad wire. They adjust the "bare wire", and mentioned that the fuel pumps on these vehicles have issues and they would order one- but give them a holler when we have additional problems. The Yukon continued to hard start, evolving into stalling when started. The dealership was alerted but due to lack of engine codes being stored the dealership couldn't help us. Eventually when driving 57mph, the Yukon cut engine on a busy route, driver was able to get the Yukon to the shoulder and attempted restart- the Yukon was dead. AAA attempted to battery jump the Yukon without success. We were without our Yukon for 8 weeks, being placed in random trucks that couldn't support our family size. Upstate Chevy of Attica was not help in the process. We did contact GM directly and received a case number 9-14907008493. The engine was replaced. The Yukon still doesn't seem to be 100%, with some slow to starts. We are asking for compensation toward another GM full size SUV. We are GM friends and family and have purchased several vehicles over the years. We'd like to trade our suv now for a new 2025 without engine issues- but since our Yukon was gutted, that is now noted on a carfax which devalues our trade.

Filed May 1, 2025 · Engine · 44,000 miles · NJ

The contact owns a 2022 GMC Yukon. The contact stated while driving 50 MPH, the vehicle independently shifted into neutral. The contact was able to coast to the shoulder of the roadway, where the vehicle stalled and was unable to be restarted. No warning lights were illuminated. The vehicle was taken to the dealer, who determined that the engine had seized, resulting in damages to the engine. The contact was informed that the engine needed to be replaced. After investigating the failure, the contact related the failure to the federal safety agency Campaign Number: 25V274000 (Engine and Engine Cooling); the VIN was included, but parts were not yet available. The manufacturer was not notified of the failure. The failure mileage was 44,000. VIN tool confirms parts not available.