2023 GMC Yukon: engine stalls while driving

Filed May 19, 2026 · Electrical, Engine · MA

Ok so my first issues were with the vehicle stalling while driving in gear. Happened a few times intersections off-ramps etc…and the car would roll to a stop. Luckily no one killed. Again happened a few times. Went to dealer they “fixed”it. Then it happened a couple other times…scary shit…went to dealer then they“Fixed” it again. Happened again I didnt bring it back. By this point I was carrying a 10 millimeter wrench in the glovebox to disconnect the battery so the body computer would reset. Car would start after cycling the power from the battery terminal. And Those were my electrical problems …As far as mechanical problems I brought car in for the recall notice “ the pico test’ . Went for the recall oil change /test/per the recommendations.300 miles later car engine failure at 70 miles an hour on route [XXX] south wife driving. She started crying doesn’t want anything to do with this car. Too many incidents… safety of my family at risk. Please help. FYI i am a mechanic / car electrician [XXX] so could probably be much more descriptive if need be Tow trucks Ubers rental cars etc… shit show. Engine died April 16 so car has been at a dealer in [XXX] for 31days. I have dealer receipts and some play by play video of a few of the incidents INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Apr 2, 2026 · Driver assistance, Electrical · TN

The brake system control module, engine control module, and vehicle stability control system have repeatedly failed across 24 months and 9 repair attempts at two authorized GMC dealerships in Tennessee. As of March 17, 2026 the vehicle has 27 active diagnostic fault codes including U160F and U1610 (brake system control module lost communication on both CAN buses), U1611 (engine control module lost communication), and C2A0A (vehicle stability control disabling inhibited). All components are available for inspection at Beaman GMC in Antioch, Tennessee where the vehicle currently remains in an undrivable condition. Safety risk: Vehicle has stalled on the highway with my family including young children in the car. Brakes have randomly engaged over 100 times with nothing around and also failed to engage when needed. Stability control is disabled. These are active safety failures confirmed by GMC's own diagnostic scans. The problems have been confirmed by both Darrell Waltrip GMC and Beaman GMC across 9 visits. GMC's own Technical Assistance Center (Case XXX) was involved and could not resolve the defects. The vehicle was returned with more active codes than at drop-off after 57 consecutive days in GMC custody. Two unresolved GMC safety recalls are open on this vehicle — L87 engine loss of propulsion (N252494003) and brake fluid leak detection failure — directly related to the reported defects. Warning codes have been present and documented since October 2023 beginning at 1,381 miles. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Mar 22, 2026 · Engine, Transmission · GA

The 6.2L motor in my GMC Yukon failed due to the camshaft and stalled me in an intersection on a highway. Had to shut the lanes down to get towed. Lost all power and couldn’t do anything but sit in the road. Just did a PICO test and it “passed” but failed 3k miles after the recall was done.

Filed Mar 18, 2026 · Electrical, Engine · CA

On 3/3/2026 during the night-time hours, I was traveling on the freeway in my 2023 GMC Yukon at over 65 MPH when I received a notice from the instrument cluster stating that the battery was low and oil pressure was low. Before I could pull over to a safe location, the Yukon turned off while in motion. My wife and two children were in the vehicle. The Yukon stalled in the number one lane of the off-ramp. I had to remove my children and wife from the vehicle while in the roadway on busy throughfares and in darkness. I attempted to jumpstart the Yukon, but efforts were unsuccessful. The Yukon was towed to the dealership where I purchased it purchased from. The Yukon was returned to my custody on 3/10/2026 stating it was an issue with the battery. While driving the Yukon home it began to bog down and stalled out in-front of my residence as it was being driven by my wife. After arriving home (night-time), I went to check the Yukon, and it started with no issues. I drove the Yukon to see if the errors would occur again. While driving the Yukon on the freeway, the Yukon RMPs indicated close to redline and I received a notification from the instrument cluster stating to turn the vehicle off (traveling at about 70-75 MPH). Once again, I was unable to pull off to a safe location before the Yukon turned off on its own while still in motion; I attempted to jumpstart the Yukon but attempts were unsuccessful. The Yukon was towed again to dealership. On 3/11/2026 I was advised that the engine had seized and on 3/13/2026 I was advised by GMC the engine needed to be replaced (this was covered under powertrain warranty). The approximate milage of the vehicle is at about 42,200.

Filed Jan 19, 2026 · Engine · MA

Car driving down highway at ~70 MPH with wife and our three young kids. Engine spontaneously shut off while driving. Electronic and other systems continued to function (power steering, brakes, lights, screens etc). Dangerous situation but was able to stop car in shoulder. Tried turning car on and off but car would not restart. Police were notified but did not come. Tow truck came and tuck car to a GMC dealer (GMC Danvers). Next day when techs arrived at dealer, they were able to start and drive car without issue. There were no present or stored fault codes other than a warning pertaining to the battery. Battery has been replaced and GMC is stating car is now safe to drive. Because issue could not be replicated by dealer and car did not store any fault codes despite the engine shut off, we question whether the issue has been correctly identified and repaired. We noted to GMC that the issue experienced was the same issue associated with the recent recall (for which the car was previously serviced). At this time we do not believe the work GMC performed under recall properly addressed the known engine shut off issue. We requested GMC and dealer perform another picoscope test to conform no issues with crank shaft. GMC refused to perform the service, despite us offering to pay for the test out of pocket. GMC is not offering any additional solutions to identify the cause of the engine shut off issue.

Filed May 8, 2025 · Engine · 55,000 miles · PA

The contact owns a 2023 GMC Yukon. The contact received notification of the federal safety agency Campaign Number: 25V274000 (Engine and Engine Cooling); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated while driving approximately 45 MPH and passing another vehicle, the vehicle stalled. The contact noticed that the vehicle had unexpectedly shifted into neutral. The vehicle was coasted to the nearest parking lot and stopped. There were no warning lights illuminated. The vehicle was towed to the dealer who diagnosed the vehicle and determined that the engine had seized. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure and opened a case. The failure mileage was approximately 55,000. VIN tool confirms parts not available.

Filed Apr 28, 2025 · Engine, Transmission · MN

On March 28, my 2023 Yukon Denali stalled on a 4 lane road forcing me to make an emergency stop on the side of the road in a right hand turn lane. The vehicle required towing to a local GMC dealership. They could not restart the vehicle and upon evaluation found metal shavings in the oil. They have recommended an engine replacement. There was no warning, it just stalled and would not restart. My Yukon remains at the dealership and we are still waiting for an engine.

Filed Mar 3, 2025 · Engine · TN

On Friday 2/21/25, while driving on the Interstate at Highway speeds, the dashboard said to idle the engine. The engine then stalled and thankfully I had enough speed and there was a shoulder available to pull off on. The dashboard then gave many messages including voltage, overheating, high oil temperature, idle engine, etc... I was unable to restart the vehicle on the side of the interstate. I was towed to the dealer who advised the engine would have to be replaced. This vehicle has a 6.2L gas engine with 39,223 (approx) miles.

Filed Feb 28, 2025 · Engine, Transmission · 20,549 miles · OH

The contact owns a 2023 GMC Yukon. The contact stated that while driving 70 MPH, the vehicle independently shifted into neutral and stalled in the middle of the highway. An unknown message was displayed. In addition, after restarting the vehicle, the accelerator pedal was depressed but the vehicle failed to accelerate as intended. The contact stated that the transmission then shifted into neutral(N) independently after driving for several miles. The contact stated that the vehicle would not crank and was towed to a local dealer. The contact stated that the vehicle failed to shift into neutral and was towed while in park(P). The vehicle was diagnosed and determined that the engine needed to be replaced. The vehicle was not repaired and remained at the local dealer for further investigation. The contact related the failure to GM investigation: PE25001. The manufacturer was made aware of the failure. The failure mileage was approximately 20,549.

Filed Feb 14, 2025 · Engine · 40,000 miles · TX

The contact owns a 2023 GMC Yukon. The contact stated that while driving at 65 MPH on the Interstate with his family in the vehicle, the engine stalled, and the rear wheels locked up. No warning lights were illuminated. The contact and his family were left stranded in the middle of the Interstate. The vehicle was towed to a local dealer to be diagnosed and the contact was informed that the main bearing in the engine had seized, and the engine block needed to be replaced. The contact stated that the vehicle was repaired; however, after retrieving the vehicle, while driving to the residence the failure recurred and the wheels locked up again. The contact pulled over to the side of the roadway and exited the vehicle. The vehicle was towed back to the local dealer to be diagnosed. The contact was informed that the vehicle had experienced the same failure as before. The vehicle was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 40,000.

Filed Feb 4, 2025 · Engine · 25,000 miles · FL

The contact owns a 2023 GMC Yukon. The contact stated while driving at approximately 65 MPH, there was an abnormal clicking sound from the engine compartment. The contact stated that there were no warning lights illuminated. The contact arrived at the destination and checked under the engine compartment and saw engine oil covering the undercarriage of the vehicle. The contact had recently had an oil change performed by the dealer. The contact had taken the vehicle to a local dealer and was informed that the oil filter was not tightened correctly and refilled the reservoir and replaced the oil filter. The vehicle was repaired. The contact stated that after returning to his home state, the contact heard the clicking sound and checked the oil dipstick. The contact stated that the dipstick was not reading any oil in the engine. The contact checked under the vehicle, however this time there was no visible sign of an oil leak. The contact stated no warning light was illuminated. The contact had the vehicle towed to the dealer, where it was diagnosed and determined that oil needed to be added. The vehicle was repaired; however, the failure recurred. Additionally, the contact stated that the vehicle was shaking as if it was going to stall. The contact stated that there were no warning lights illuminated. The contact had the vehicle towed to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was informed of the failure. The failure mileage was approximately 25,000.

Filed Jan 31, 2025 · Engine · CA

On [XXX] driving to Las Vegas Nevada from Garden Grove California, coming down the hill north on [XXX] just 12 miles from state line our GMC shut off and went into Neutral. The Engine completely shut off and we were lucky to pull over on the side of the road with no power. Our Vehicle was towed to Auto Nation GMC in Henderson NV. The Vehicle is still there due to no engines available. My GMC case number is [XXX]. I have agreed to a repurchase from GMC and accepted their offer, however now they are stalling. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)