Letter from congressman hunter on behalf of constituent regarding ABS brake issues on his 1991 jeep cherokee. *smd the consumer stated the brakes failed and the dealer could not find the pump to repair the ABS brakes. The consumer requested the to have the vehicle repaired or replaced. The consumer referenced recall #96v260000
1991 Jeep Cherokee: brake failure
33 of the 233 complaints about the 1991 Jeep Cherokee describe brake failure.
- owner complaints
- 33
- of this car's complaints
- 14%
- recalls
- 5
Is there a fix? There are 5 recalls for this area of the car. See below
Brake failure by model year
What owners say
Brakes totally fail, I was unable to stop vehicle safely. No warning, the dashboard check ABS light comes on after brake failure. Dealer gave me the run-around when I asked them to check the brakes previously.
Tl* the contact owns a 1991 jeep cherokee. The contact stated that while driving 60 MPH, the brake light illuminated and then the brakes failed. The vehicle was taken to a personal mechanic for diagnosis and the contact was informed that he would need an anti-lock brake pump. The manufacturer was notified and offered no assistance. The vehicle had not been repaired. The failure and current mileages were 153,000. The VIN was unavailable.
1991 jeep cherokee. Consumer states problems with brakes *tgw the consumer stated the ABS light illuminated and the brake pedal was very hard. The consumer stated he discovered the master cylinder nearly empty. The consumer took the vehicle to the dealer and it was determined the ABS pump and actuator had failed. The consumer stated the ABS pump and actuator failed again which left him with no brakes while driving. The vehicle was taken to the dealer again, where the consumer was informed the ABS pump was leaking.
I recently installed new bumpstops on the rear of my jeep and noticed a decrease in braking ability. Today while driving I had a sudden loss of braking power and rear ended another vehicle. While inspecting my braking system and my jeep for damage. I noticed that I had a rear brake line collapsed. I remember reading about recall 90v206000. It stated that "contact at full jounce may cause the brake tube to collapse and restrict the hydraulic brake fluid pressure to the left rear brake which affects the braking capability of the vehicle." this was quoted from this site. I read the documents that were linked, and even though my VIN does not pull up the recall, which I have gone to a dealer upon buying my vehicle and had them make sure all recalls were performed. They did not say I needed the recall referenced. My jeep does meet all the other parts of the recall in terms of what vehicles were affected.
Abs always activates at speeds over 45 MPH, producing a loud clicking, increasing stopping distance and pulling car sharply to right and left. Check ABS light comes on after 10 minutes of driving. About every 5 months, check ABS light comes on with parking brake light, resulting in complete brake failure. This lasts anywhere from 10 minutes to 2 days, until everything suddenly turns back on and braking is restored. Dealer cannot solve problem.
The ABS light illuminated on the dashboard, and the vehicle had no brakes, also the ABS pump was replaced 4 times.
The one problem I have had is with the ABS not being able to stop. It happened early december 2001. It was replaced free of charge as it is under lifetime warranty. Thinking all is ok I drive my car and on march 30, 2002 my brakes again failed. Had it fixed up from the dealer and drove it about a mile only to have no brakes again. This is the 3rd time the part has been replaced. I believe it is a safety issue. ****dims 11 ivoq entry posted after 12/12/02 cut-over to artemis****7650836. *ak
When the jeep hits a hard bump the right rear bump stop will contact the brake fluid line on the passenger side. I had the jeep loaded and when I got home I looked under the jeep and I feel if the jouce bumper its the brake line hard enough it will cut off fluid to the brake on that side. That would cause partial loss of brakes and could kill me.
Consumer put vehicle in reverse and there were no brakes. Consumer was on a flat surface & gradually came to a stop. Dealer went to expense to inspect it, and repair shop said that dealer would have to hook it up to a computer.
When the brake pedal is applied it feels like air is in the lines. Pedal goes to the floor and the vehicle slows down before finaly stopping. Dealer has been contacted.
Brake failure.
Related recalls
Service brakes, hydraulic: foundation components: disc: rotor
- What is wrong
- Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors can experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion can eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
- Risk
- The reduced strength can allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
- Remedy
- Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Recall number 98V005000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: vehicles equipped with antilock brake system (ABS). The antilock brake system (ABS) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.
- Risk
- If this occurs, the ABS function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional.
- Remedy
- Dealers will test the vehicle's ABS and repair as necessary. The warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous ABS component repair costs.
Recall number 96V260000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system can cause detachment of the hose from the ABS system, and discharge of hydraulic fluid.
- Risk
- Detachment of the hose from the ABS system causes theloss of the ABS function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire.
- Remedy
- Replace the ABS high pressure hose.
Recall number 91V063000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Improperly installed brake fluid tube may allow the tube to contact the steering intermediate shaft damaging the tube.
- Risk
- Brake fluid leakage could occur and result in partialloss of braking capability.
- Remedy
- Reposition brake tube to avoid contact with steering shaft; also, replace any damaged brake tubes.
Recall number 91V023000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Suspension jounce bumper could contact left rear wheel brake tube when suspension is at full jounce (bounce).
- Risk
- Contact at full jounce may cause the brake tube tocollapse and restrict the hydraulic brake fluid pressure to the left rear brakewhich affects the braking capability of the vehicle.
- Remedy
- Replace left rear brake tube with tube designed to eliminate contact with bumper.
Recall number 90V206000 · Recall details
Questions about the 1991 Jeep Cherokee brake failure
Is brake failure a common problem on the 1991 Jeep Cherokee?
33 of 233 owner complaints about the 1991 Jeep Cherokee (14%) mention brake failure. The model year with the most reports is 1990.
Is there a recall or service bulletin for this on the 1991 Jeep Cherokee?
There are 5 recalls and 0 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1991 Jeep Cherokee
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Jeep Cherokee?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history