The contact owns a 1991 Jeep Cherokee. The contact stated while driving 20 MPH, the contact depressed the brake pedal however, the vehicle failed to slow as needed. The brake warning light was illuminated. The depressed the brake pedal with extreme force and the vehicle came to a stop. The dealer was contacted but the vehicle was not diagnosed because the vehicle was an older vehicle. The contact was informed that had already been repaired under the federal safety agency Campaign Number: 96V260000 (Service Brakes, Hydraulic). The manufacturer was contacted and stated that the vehicle was imported from Canada, and once it was imported, the vehicle warranty was voided. The failure mileage was 175,000.
The worst 1991 Jeep Cherokee problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Brakes163
- Engine17
- Seat belts14
- Transmission13
- Acceleration12
- Electrical9
- Seats6
- Fuel system4
- Lights3
- Steering3
- Body2
- Locks2
- Tires2
- Visibility2
- Suspension1
- Wheels1
Specific symptoms reported on the 1991 Jeep Cherokee
Recalls 5
Service brakes, hydraulic: foundation components: disc: rotor
- What is wrong
- Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors can experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion can eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
- Risk
- The reduced strength can allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
- Remedy
- Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Recall number 98V005000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Vehicle description: vehicles equipped with antilock brake system (ABS). The antilock brake system (ABS) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.
- Risk
- If this occurs, the ABS function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional.
- Remedy
- Dealers will test the vehicle's ABS and repair as necessary. The warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous ABS component repair costs.
Recall number 96V260000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system can cause detachment of the hose from the ABS system, and discharge of hydraulic fluid.
- Risk
- Detachment of the hose from the ABS system causes theloss of the ABS function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire.
- Remedy
- Replace the ABS high pressure hose.
Recall number 91V063000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Improperly installed brake fluid tube may allow the tube to contact the steering intermediate shaft damaging the tube.
- Risk
- Brake fluid leakage could occur and result in partialloss of braking capability.
- Remedy
- Reposition brake tube to avoid contact with steering shaft; also, replace any damaged brake tubes.
Recall number 91V023000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Suspension jounce bumper could contact left rear wheel brake tube when suspension is at full jounce (bounce).
- Risk
- Contact at full jounce may cause the brake tube tocollapse and restrict the hydraulic brake fluid pressure to the left rear brakewhich affects the braking capability of the vehicle.
- Remedy
- Replace left rear brake tube with tube designed to eliminate contact with bumper.
Recall number 90V206000 · Recall details
See all 5 recalls for the 1991 Jeep Cherokee
Defect investigations
Sudden acceleration
There is no summary currently available
DP02005
Brake disc/hub separation
Consumer complaints indicate that corrosion of the brake rotors have caused separation of the brake disc from its hub, resulting in brake failure.
EA97001
Brake disc/hub separation
consumer complaints indicate that corrosion of hte brake rotors have caused separation of the brake disc from its hub, resulting in brake failure.
PE96053
Vehicle sudden acceleration
There is no summary currently available
DP95007
Rear axle shaft separation
This investigation was opened to examine the failure mode and the risk to motor vehicle safety posed by allegations of rear axle separations.the rear axle shaft and housing design is typical of those in which the weight of the vehicle is carried on the axle housing.the left and right axle shafts, supported by roller bearings, are situated inside the axle housing.the inboard splined end of the axle shaft receives power transmitted from the differential assembly, providing torque to the rear wheels.the allegations are that the axle shaft fails, resulting in the separation of a wheel and axle hub assembly or the entire axle shaft and wheel assembly, depending on the location of the axle shaft failure.as identified by chrysler, the subject rear axles are dana 35c and 35cm models, which have been used on the subject vehicles since the 1990 model year.a safety defect trend with respect to the subject axle shafts has not been identified.see hard copy resume for full text of summary.
PE95049
Driveshaft/univ.joint fail
There is no summary currently available
PE93057
Technical service bulletins for the 1991 Jeep Cherokee 17
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Child Seat Tether Anchor Installation
- Subject regarding floor pan corrosion
- Subject regarding wire splice repairs
- Subject regarding child seat tether anchors
- This bulletin provides a revised wire splice procedure and related parts
- Subject on the child seat tether anchors
- Information on child seat tether anchors
- The outer exhaust manifold studs may fatigue and break
- Information on installation of radio transmitting equipment
- Various car owner's have expressed interest in using engine coolants made with propylene glycol instead of...
1991 Jeep Cherokee fuel economy
Official EPA estimates in miles per gallon (MPGe for electric). Ranges cover trims that share the same engine.
| Engine | Drive | City | Highway | Combined |
|---|---|---|---|---|
| 2.5L 4‑cyl | RWD | 17 | 21 | 18 |
| 2.5L 4‑cyl | 4WD | 16 | 20 | 18 |
| 4.0L 6‑cyl | RWD | 14-15 | 20 | 16-17 |
| 4.0L 6‑cyl | 4WD | 14-15 | 18-20 | 15-17 |
What 1991 Jeep Cherokee owners say
Most recent owner complaints, unedited.
Tl* the contact owns a 1991 jeep cherokee. When the contact engaged the brake pedal, it became stiff and had to be depressed several times to stop the vehicle. The contact also had to depress the brake pedal from a greater distance to bring the vehicle to a complete stop. The brake warning indicator remained illuminated. The vehicle was taken to huntington beach chrysler dodge jeep ram (16701 beach blvd, huntington beach, ca 92647, (714) 841-3999) and a pressure test was performed, which found an internal leak at the ABS pump and master cylinder. The dealer stated that the system did not build up over 800 psi and the brake pedal shift interlock system failed. The dealer advised the contact that the vehicle was unsafe and should not be driven. The vehicle was not repaired. The VIN was not available. The failure mileage was 208,970.
Tl* the contact owns a 1991 jeep cherokee. The contact stated that the vehicle made an abnormal noise and the brake pedal traveled to the floorboard. The contact lost brake functionality while being operated on the highway and the ABS warning indicator illuminated. The contact was able to stop the vehicle. The vehicle was taken to ryan auto mall (located at 1000 highway 55 e, buffalo, mn) where it was diagnosed that the pump motor assembly was defective and needed to be replaced. The contact stated that the vehicle was previously repaired per the federal safety agency campaign number: 96v260000 (service brakes, hydraulic), which stated that the component had a lifetime warranty. The technician refused to do the recall repair due to lack of parts. The manufacturer was made aware of the issue and informed the contact that there was nothing they could do to assist. The failure mileage was not provided.
Letter from congressman hunter on behalf of constituent regarding ABS brake issues on his 1991 jeep cherokee. *smd the consumer stated the brakes failed and the dealer could not find the pump to repair the ABS brakes. The consumer requested the to have the vehicle repaired or replaced. The consumer referenced recall #96v260000
Tl* the contact owns a 1991 jeep cherokee. The contact stated that the brakes were slow to respond and failed to function properly. The dealer determined that the vehicle was excluded from the federal safety agency campaign number: 96v260000 (service brakes, hydraulic). The failure recurred. The manufacturer was notified. The failure mileage was not available.
My ABS pump has failed, and chrysler is failing to comply with the federal safety agency recall #96v260000 having to do with the ABS pump. The recall clearly states that "the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage". I called the chrysler recall center today, and at 5:01pm pst, sasha told me that there is no warranty on that part, and I was denied help. The federal safety agency recall clearly states otherwise. Trying to find answers on the internet, I have found that other people are experiencing the same issue with chrysler denying and refusing service, because apparently this part can no longer be had. Why is their direct conflict with the stated lifetime coverage on the recall? I also learned that last year chrysler was fined $105 million by the federal safety agency for mishandling recalls. If the federal safety agency allows chrysler to deny this, legal responsibility may fall on both parties, as I will be continuing with legal action.
Tl* the contact owns a 1991 jeep cherokee. After starting the vehicle, the brake and ABS warning indicators illuminated intermittently. The vehicle was taken to the dealer where it was diagnosed that the brake actuator piston assembly would need to be replaced however, the vehicle was not serviced even though the VIN was included in the federal safety agency campaign number: 096v26000 (service brakes, hydraulic). The contact mentioned that he was responsible for the cost of the diagnostic test. In may of 2016, the vehicle was taken back to the dealer a seond time because the ABS pump motor failed to operate. The dealer stated that the part was no longer being produced and the manufacturer would repurchase the vehicle at the fair vehicle price. The manufacturer was notified of the issue. The contact was not interested in the amount ofered per the repurchase program. The approximate failure mileage was 90,000. ...updated 09/19/16 *bf
Tl* the contact owns a 1991 jeep cherokee. While driving at any speed, the brake pedal became stiff and the ABS light illuminated. The failure was neither diagnosed nor repaired. The manufacturer was not made aware of the failure. The failure mileage was 127,000.
Tl* the contact owns a 1991 jeep cherokee. While driving at various speeds and attempting to stop the vehicle, the contact had to depress the brake pedal with extreme pressure to stop the vehicle. When the contact filled the vehicle with brake fluid, the fluid leaked out quicker than anticipated. As a result, the manual braking system had to be used instead of the power assist braking system. The brake warning light illuminated. Also, the horn sounded without warning and the power steering seized. The failure recurred. The contact took the vehicle to a certified mechanic who diagnosed that the power assist brake unit failed and needed to be replaced. The power steering failure was not diagnosed. The vehicle was not repaired. The manufacturer was not made aware of the failures. The approximate failure mileage was 184,000.
Tl* the contact owns a 1991 jeep cherokee. The contact stated that the brake pedal did not properly release and there was a loose wire connection associated with the braking system near the brake pedal. There were no warning lamps illuminated for the ABS. The contact had to maneuver the pedal and lift the pedal to get it to release. The vehicle was to be taken to an authorized dealer for further inspection and diagnostic testing. The contact stated that there was a manufacturer recall that was not repaired before the vehicle was purchased. The contact was not able to confirm the recall information. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was not available.
Compare the 1991 Jeep Cherokee
Cherokee vs Ford EscapeCherokee vs Honda CR-VCherokee vs Toyota RAV4Cherokee vs Chevrolet EquinoxCherokee vs Nissan RogueCherokee vs Subaru ForesterCherokee vs Hyundai TucsonCherokee vs Kia Sportage
Other model years
199019911992199319941995199619971998199920002001200620142015201620172018201920202021202220232026
Questions about the 1991 Jeep Cherokee
Is the 1991 Jeep Cherokee reliable?
Owners have filed 233 complaints about the 1991 Jeep Cherokee, fewer than a typical Cherokee model year.
What is the most common problem with the 1991 Jeep Cherokee?
Brakes, with 163 complaints, typically around 174,735 miles. Next is engine (17).
How many recalls does the 1991 Jeep Cherokee have?
5 recalls, covering service brakes, hydraulic.
Was there a recall on the 1991 Jeep Cherokee brakes?
Yes, 5 recalls: 98V005000, 96V260000, 91V063000. Check your VIN to see if your car still needs the free repair.
What year does the Jeep Cherokee have bad brakes?
The Jeep Cherokee model years with the most brakes complaints are 2014 (211 complaints), 1991 (163 complaints) and 1990 (152 complaints).
What gas mileage does the 1991 Jeep Cherokee get?
Official estimates for the 1991 Jeep Cherokee range from 15 to 18 mpg combined. The most efficient version (2.5L 4-cyl, RWD) gets 17 city and 21 highway.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Jeep Cherokee?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its historyJeep Cherokee in the news
- Jeep extends warranty coverage on 2014-2023 Cherokee (power train)
- Jeep recalls 2024-2026 Grand Cherokee, 2026 Cherokee and 2024-2025 Wagoneer and other models over pressure monitoring and regulating systems problem (201,975 vehicles)
- Jeep recalls 2026 Grand Cherokee, 2026 Wrangler and 2026 Cherokee and other models over back over prevention camera problem (844,028 vehicles)