When I am driving, all of the lights on my dash come on. Seatbelt, check engine, brakes, low tire pressure etc. The stay on for a couple of seconds. Then EVERYTHING turns off for about half a second. Gas gauge, rpm, speedometer all go down to zero, which is how it is when I turn the jeep off. While I'm still driving and going 45 mph! Then every thing turns back on. It happened about 5 months ago once. Then today it happened about 15 times as I drove home from my mother's house, which is about 7-9 miles from my house.
2007 Jeep Grand Cherokee: multiple warning lights
37 of the 1,109 complaints about the 2007 Jeep Grand Cherokee describe multiple warning lights.
- owner complaints
- 37
- of this car's complaints
- 3%
- typical mileage
- 59,000
- recalls
- 2
Multiple warning lights by model year
What owners say
All dashboard warning lights come on. Loss of electrical power. No headlights, no brake lights. Speedometer doesn't work, tachometer doesn't work, radio doesn't work. No power locks or windows. Anything electrical doesn't work. The battery is good. The vehicle runs. But it is unsafe. The vehicle is crap. Never buy a jeep! They are total crap
Takata recall all the dash lights come on from battery,check engine,low tire pressure, code read 0411 & well not pick up speed.
Soon after the p41 ignition switch recall, while driving 1 mile, the instrument cluster gauges stopped working-speedo, gas, etc , all warning lights illuminated . Information messages in the ic noted "service required : and transmission -over the temperature allowed u1403,u1411,u110e, u110f and others all implausible signals to ic. While driving transmission an road speed decreased immediately while at speed and engine and transmission to not operate in a predictably safe operation. These are the symptoms that the recall was to repair. What is the next step?
While driving or parked with engine running all dash warning lights flash on and off any interior lights that are on turn off, radio turns off and heater/AC and fan turn off for a couple seconds then turn back on. Usually the check engine light will then stay on for a few more cycles. Engine, power steering and brakes and head lights all continue to work throughout the cycle. This will happen numerous times in one day or go for a month without doing it at all.
Iam having a problem with my 2007 jeep grand cherokee starting it's not the battery all lights radio and heat work but car will not start I have looked up the problem and hundreds of other jeep owners are having the same problem and still no recall why????? Obviously not owners fault
Tl* the contact owns a 2007 jeep grand cherokee. While driving at 50 MPH, the engine stalled while all the warning lights illuminated. The vehicle was able to restart. The failure was persistent. The vehicle was taken to a dealer where it was not diagnosed or repaired. The contact received notification of the federal safety agency campaign number: 14v438000 (electrical system); however the part to do the recall repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not aware of the failure. The contact had not experienced a failure. The failure mileage was approximately 120,000. Parts distribution disconnect.
The dashboard went blank, no speed information, etc, all the warning lights lite up as if the vehicle was being started. Steering became hard, was a very scary moment!
Tl* the contact owns a 2007 jeep grand cherokee. While driving approximately 65 MPH, the vehicle lost power and all of the warning lights on the instrument panel illuminated. The contact received notification of the federal safety agency campaign number: 14v438000 (electrical system); however, the parts needed were unavailable to perform the repairs. The manufacturer was not notified of the failure. The approximate failure mileage was 90,000.
Tl* the contact owns a 2007 jeep grand cherokee. While driving 30 MPH, all the warning lights illuminated and all the electrical components failed. The contact stated that the vehicle was able to restart after three to five seconds. The vehicle was taken to the dealer, but the failure was not able to be determined. The vehicle was not repaired. The contact received a notification of the federal safety agency campaign number: 14v438000 (electrical system); however, the part to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was 20,000. Updated 07-16-15 *bf updated 9/21/2015
While I was driving jeep and my jeep shut down on its own, all lights shut down , my wheel locked up, I was not able to steer. Thank god my brakes worked. I was able to stop the jeep but a few minutes later I tried to start up the jeep again and all the lights were flickering and then finally it started again. I could leave the cat where I was at the time because I was at a very busy street and this is during traffic time. I did call a dealership to see if it was a recall and they said it was. They said it was the started switch. My question is how do I get that switch replaced?
Tl* the contact owns a 2007 jeep grand cherokee. While driving approximately 75 MPH, the vehicle stalled and all warning lights illuminated on the instrument panel. The failure recurred on several occasions at different speeds. The vehicle was taken to the dealer, where it was diagnosed that the ignition switch needed to be repaired. The contact received notification of the federal safety agency campaign number: 14v438000 (electrical system) however, the part needed to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was 65,000.
Service bulletins that may apply
- Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair...
- Exterior Mirror The latest version of these exterior mirrors have had their glass removed to be serviced...
- Customer Satisfaction Notification P73 Reprogram Final Drive Control Module: The Final Drive Control...
- Customer Satisfaction Notification P73 Reprogram Final Drive Control Module The Final Drive Control Module...
- P41 Interim Repair Procedure Brazil ONLY Some Jeep Commander and Jeep Grand Cherokee vehicles may...
- Summary to be provided on a future date.
- 4WD Lamp Illuminated and Diagnostic Trouble Code C140F Active in Final Drive Control Modules (FDCM) Memory
- Part Description: Actuator Motor
Related recalls
Electrical system: ignition: switch
- What is wrong
- This defect can affect the safe operation of the airbag system. Until this recall is performed, drivers should adjust their seat to allow clearance between the driver's knee and the ignition key, and remove all items from their key ring, leaving only the vehicle key. Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2007 Jeep Grand Cherokee vehicles manufactured February 11, 2004, to July 5, 2007, and 2006-2007 Jeep Commander vehicles manufactured January 31, 2005, to July 5, 2007. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine.
- Risk
- If the ignition key inadvertently moves into the OFF or ACCESSORY position, the engine will turn off, which will then depower various key safety systems including but not limited to air bags, power steering, and power braking. Loss of functionality of these systems may increase the risk of crash and/or increase the risk of injury in the event of a crash.
- Remedy
- Chrysler will notify owners, and dealers will replace the ignition switch, free of charge. Chrysler sent interim notifications to owners in September 2014. The recall began on October 9, 2015. Owners may contact Chrysler customer service at 1‑800‑853‑1403. Chrysler's number for this recall is P41.
Recall number 14V438000 · Recall details
Electrical system
- What is wrong
- Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2010 Jeep Grand Cherokee vehicles manufactured February 11, 2004, through March 9, 2010; and 2006-2010 Jeep Commander vehicles manufactured January 31, 2005, through March 10, 2010. A transfer case electrical failure may result in an unintentional shifting of the transfer case into the neutral position.
- Risk
- If the vehicle shifts into neutral, it may roll away increasing the risk of a crash or personal injury.
- Remedy
- Chrysler will notify owners, and dealers will reflash the final drive controller which governs the transfer case, with new software, free of charge. The recall began on August 15, 2013. Owners may contact Chrysler at 1‑800‑247‑9753. Chrysler's recall campaign number is N23.
Recall number 13V175000 · Recall details
Questions about the 2007 Jeep Grand Cherokee warning lights
Is multiple warning lights a common problem on the 2007 Jeep Grand Cherokee?
37 of 1,109 owner complaints about the 2007 Jeep Grand Cherokee (3%) mention multiple warning lights. The model year with the most reports is 2006.
Is there a recall or service bulletin for this on the 2007 Jeep Grand Cherokee?
There are 2 recalls and 14 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2007 Jeep Grand Cherokee
Stalling 257Check engine light 94Loss of power 88Won't start 47Jerking 25Power steering loss 24Engine failure 17ABS 16Headlights 16Hesitation 16Won't shift 16No deployment 15Tire blowout 12Brake failure 10Fire or smoke 8Harsh shifting 8Sudden acceleration 8Airbag light 7Power windows 7Steering lock-up 7Transmission failure 7Water leak 7Door locks 6Key fob 5Overheating 5Slipping 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Jeep Grand Cherokee?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history