2008 Jeep Liberty problems

What is wrong

Chrysler Group LLC (Chrysler) is recalling certain model year 2007-2008 Dodge Nitro 4X2 vehicles manufactured March 21, 2006, through March 1, 2008; and 2008 Jeep Liberty 4X2 vehicles manufactured February 15, 2007, through March 1, 2008. The transfer case heat shield may drop down and rub on the drive shaft, weakening it and potentially causing the drive shaft to break.

Risk

If the drive shaft breaks, a section of it can strike the transfer case tunnel with enough force that the airbag computer will believe the vehicle is in a crash and thus deploy the airbags. Additionally, the drive shaft failure will result in a loss of motive power. Either condition may increase the risk of a crash.

Remedy

Chrysler will notify owners, and dealers will add a bracket to support the rear of the heat shield, free of charge. An interim letter was mailed to owners on May 29, 2013. Owners may contact Chrysler at 1‑800‑247‑9753. Chrysler's recall campaign number is N10.

Recall number 13V121000 · Recall details

What is wrong

Chrysler is recalling certain model year 2008 jeep liberty vehicles. The vehicles are equipped with windshield wiper motors that contain excess adhesive that may allow for water intrusion, which could result in intermittent and eventually inoperative windshield wiper operation.

Risk

A failing or inoperative windshield wiper system will reduce a driver's visibility which could result in a crash.

Remedy

Dealers will replace the windshield wiper motor free of charge. The safety recall began on december 1, 2010. Owners may contact chrysler at 1‑800‑853‑1403.

Recall number 10V550000 · Recall details

What is wrong

Chrysler is recalling 3,663 my 2007-2008 dodge nitro and my 2008 jeep liberty vehicles equipped with manual transmissions. The park brake lever clutch drum may distort and reduce the effectiveness of the park brake system.

Risk

This could allow the vehicle to move inadvertently and cause a crash without warning.

Remedy

Dealers will replace the park brake lever assembly free of charge. The recall began on october 27, 2008. Owners may contact chrysler at 1‑800‑853‑1403.

Recall number 08V525000 · Recall details

What is wrong

Chrysler is recalling 494 my 2008 jeep liberty vehicles. The windshield and/or fixed rear quarter glass may have been assembled using incorrect urethane adhesive. This could affect glass retention.

Risk

If the glass separates while driving, it could strike another vehicle or injure a pedestrian.

Remedy

Dealers will replace the windshield and/or fixed rear quarter glass free of charge. The recall began on october 13, 2008. Owners may contact chrysler at 1‑800‑853‑1403.

Recall number 08V455000 · Recall details

In a letter dated August 21, 2014, the Center for Auto Safety (CAS) petitioned the federal safety agency to initiate a defect investigation of alleged failures associated with the Totally Integrated Power Module (TIPM) installed in Chrysler SUV?s, trucks, and vans beginning in the 2007 model year. The petitioner alleges that TIPM defects may result in engine stall, airbag non-deployment, failure of fuel pump shutoff resulting in unintended acceleration, fire, and other symptoms. On September 25, 2014, the Office of Defects Investigation (ODI) opened DP14-004 to evaluate the petition for a grant or deny decision. ODI analyzed complaint data provided by CAS as well as complaints submitted to ODI from consumers. In total, there were 296 complaints submitted by the petitioner in the original petition and five supplements, including 271 complaints related to the subject vehicles equipped with TIPM-7. Approximately 3 percent of CAS complaints are related to vehicles equipped with TIPM-6 and ODI?s review of these complaints did not identify any safety defect trends. ODI conducted a detailed review of complaints narratives submitted by CAS and consumers including careful analysis of vehicle repair histories, warranty claims obtained from the manufacturer and any available Customer Assistance Inquiry reports (CAIR). Analysis of the field data indicated that MY2011-2013 Jeep Grand Cherokee and Dodge Durango vehicles exhibited significantly higher complaint rates related to fuel pump relay (FPR) failures than other subject vehicles. In a September 3, 2014 letter to the federal safety agency, Chrysler submitted a Defect Information Report (DIR) identifying a defect in the FPR within the TIPM-7 which can result in a no start or stall condition in approximately 188,723 model year (MY) 2011 Jeep Grand Cherokee (WK) and Dodge Durango (WD) vehicles manufactured from January 5, 2010 through July 20, 2011 (14V‑530).In a February 24, 2015 letter, Chrysler submitted a second DIR expanding the scope of the FPR defect condition to include an additional 338,216 MY 2012 through 2013 Jeep Grand Cherokee vehicles manufactured from September 17, 2010 through August 19, 2013 and MY 2012 through 2013 Dodge Durango vehicles manufactured from January 18, 2011 through August 19, 2013 (15V‑115).ODI analysis of the CAS allegations of TIPM defects resulting in stall while driving, airbag non-deployment, unintended acceleration, fire and other faults identified a single defect condition related to 1 of over 60 different circuits in the TIPM assembly. The most common effect of this defect condition, related to the fuel pump relay, was a no-start concern, but it could also result in stall while driving (76 complaints). No valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components.Except insofar as the petitioner's contentions relate to the defect condition addressed by the Chrysler recalls, the factual bases of the petitioner's contentions that any further investigation is necessary are unsupported. In our view, additional investigation is unlikely to result in a finding that a defect related to motor vehicle safety exists or a the federal safety agency order for the notification and remedy of a safety-related defect as alleged by the petitioner at the conclusion of the requested investigation. Therefore, in view of the need to allocate and prioritize the federal safety agency's limited resources to best accomplish the agency's safety mission, the petition is den

DP14004