2025 Mercedes-Benz CLA250 technical service bulletins
74 technical service bulletins and manufacturer communications cover the 2025 Mercedes-Benz CLA250.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Slight creaking noises when steering
- Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is...
- Radio station cover art does not refresh when switching stations
- Clanking noise from the area of the speakers in the doors
- Temporary no start condition with check engine light and multiple warning messages
- Intermittent shift feel or thud/clunk noise perceived, such as a brief jerk or transmission reaction...
- Tailgate opens unintentionally
- 1. General Diagnostic Tips 2. One or More PARK Sensor Activations 3. Red Ring Around Vehicle 4. "Active...
- CEL light on with no drivability concerns
- Check/test procedure: 1. Open hood
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- CEL light on with no drivability concerns
- Service code B1 displayed in the customer menu does not match the workshop code displayed in the workshop...
- After successful commissioning of the HERMES control unit (N112/9) with XENTRY Diagnosis DVD 03/2026, the...
- Noises from the area of the steering column
- There are several types of complaint about noises or poor windshield wiper wiping performance: A: Wiper...
- There may be creaking noises when steering while stationary or driving slowly
- 1. General Diagnostic Tips 2. One or More PARK Sensor Activations 3. Red Ring Around Vehicle 4. "Active...
- Cause At present, there are no known noise problems with the steering column
- The intent of
- Headlamp, front fog lamp leaky or fogged
- -Check engine light illuminated
- The "easy entry and exit feature" function deactivates itself after a brief period
- Radio station cover art does not refresh when switching stations
- The vehicle's position on the map is displayed far away from its actual position, e.g. the vehicle is...
- Yellow information message in driver display (instrument cluster): "Switch on motor to charge the 12V battery"
- Tailgate opens unintentionally
- Unknown or other
- Activating Navigation Please Wait" message seen on central display
- After the charging process is complete, an instrument cluster message with a charging error appears and FC...
- Customer states the AC either does not cool/has poor performance or heat is insufficient
- Customer states the AC either does not cool/has poor performance or heat is insufficient
- Oil residue in connector of transmission control unit in dual-clutch transmission models 724.0 and 724.1.
- The flap of the reversing camera opens and closes by itself during forward travel several times during the...
- A finger is permanently detected although none is present, but it is not identified (ghost function)
- The check engine light illuminates or the 48 V message is displayed in the instrument cluster
- USB port not functioning properly
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Electrical system
- Instrument cluster message "4MATIC inoperative". The following fault code may be present in all-wheel...
- At low speeds and light brake pressure, brakes will make a groaning or honking noise
- The "Easy entry and exit feature" function deactivates itself after a brief period
- The check engine light illuminates or the 48 V message is displayed in the instrument cluster
- The result from the XENTRY battery test does not match the current state of the battery
- No audio is output either in radio mode, or with media playback via app, Bluetooth or USB. In such cases,...
- The Dynamic or Park Camera button in the LCP is stuck or does not react
- Customer complains about anti-theft alarm system triggering without obvious cause when the vehicle is...
- Transmission limp-home mode with fault message in IC "Gear Change to R Not Possible", the even gears are...
- Customer complaints regarding automatic transmission 724.1 (8FDCT & 8FDCT hybrid) For faster, more...
- Complaint: Check engine light comes on when driving/starting the vehicle
- The check engine light illuminates or the 48 V message is displayed in the instrument cluster
- Check engine light comes on when driving/starting the vehicle
- After a software update for instrument cluster (IC) control unit (N133/1) is performed the following...
- There may be creaking noises when steering while stationary or driving slowly
VIN decoder
See the problems and recalls for an exact car
Buying a used 2025 Mercedes-Benz CLA250?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history