2007 Volvo VN problems

What is wrong

Volvo is recalling certain model year 2002-2013 VHD and VN trucks, manufactured from August 4, 2000, through June 22, 2012, and equipped with bench passenger seats. The seat belt d-ring weld may not be sufficient enough to meet the seat belt pull test. Therefore, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 210, "Seat Belt Assembly Anchorages."

Risk

In the event of a crash, an insufficient seat belt weld may prevent the seat belt from properly restraining the occupant. This increases the risk of injury to the seat occupant.

Remedy

Volvo Trucks of America will notify owners, and dealers will replace the suspected d-ring, free of change. The safety recall began on May 10, 2013. Owners may contact Volvo at 1‑336‑393‑2000.

Recall number 12V510000 · Recall details

What is wrong

Volvo trucks is recalling certain model year 2007 and 2009 vhd, model year 2006 through 2010 vn, and model year 2007 through 2009 vt trucks manufactured from november 7, 2005, through october 30, 2009, equipped with an air release fifth wheel. The inversion valve on the frame may be orientated where contaminants can enter the valve through the exhaust port. As a result, the brake valve may corrode.

Risk

Corrosion of the valve can cause it to malfunction, thereby adversely affecting braking performance and increasing the risk of a crash.

Remedy

Dealers will inspect the inversion valve and replace as required. This service will be performed free of charge. The safety recall is expected to begin on or before february 18, 2011. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 10V571000 · Recall details

What is wrong

On certain heavy duty class 8 trucks equipped with dana steering shafts, there is a potential that the steering shaft pinch bolt hole may be incorrectly located. The pinch bolt fits into a groove in the steering gear input shaft to ensure that the steering shaft does not separate from the steering gear if the pinch bolt comes loose.

Risk

This could potentially lead to steering shaft separation resulting in loss of control of the vehicle if the pinch bolt were to come loose increasing the risk of a crash.

Remedy

Dealers will inspect the steering shaft and replace it as required free of charge. The recall began on august 28, 006. Owners may contact volvo trucks at 1‑800‑528‑6586.

Recall number 06V099000 · Recall details

ODI opened Recall Query RQ11-001 after a review of EWR Field Reports identified lower bunk window separations on the subject vehicles.Volvo had issued three recalls for sleeper window separations since 2003.Additionally, Volvo had issued two bulletins for sleeper window issues during the same time period.The frequency of related actions led ODI to open this formal investigation.An Information Request (IR) letter was sent to Volvo on 23 June 2011.Volvo responded on 17 August 2011 and then provided updated warranty information on 9 January 2012.Volvo provided production change data and warranty information which was correlated to vehicle build month and failure date.ODI analyzed the data to determine if additional production time frames should have been included in previous recalls.ODI also requested information from its network of fleet owners.The response from this network reaffirmed the accuracy of the updated warranty information.Based on the information and data received, ODI has concluded that all production periods have been appropriately addressed by Volvo's previous recalls and no additional recall action is required at this time.

RQ11001

On october 18, 2007 volvo trucks north america filed defect report 07v‑496 which outlines a safety recall program to notify the affected owners and correct the affected vehicles.

PE07046