The contact owned a 2014 BMW 328I. The contact stated while the vehicle was parked, the vehicle stalled after overheating the previous day. The contact stated that an unknown warning light was illuminated. The vehicle was towed to a dealer, where it was diagnosed that the valvetronic system needed to be replaced; while the vehicle remained at the dealer awaiting repairs, the contact was notified that the vehicle had sustained thermal damage over the weekend, caught fire, and burned completely, leaving only the frame. The vehicle was unoccupied during the fire. A police and fire department report was filed. The manufacturer was notified of the failure. The contact was later notified that the VIN was included in the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The failure mileage approximately 100,000.
BMW 328I overheating problems
83 of the 2,584 owner complaints about the BMW 328I describe engine overheating, most of them for the 2011 model year.
- owner complaints
- 83
- worst model year
- 2011
- typical repair cost reported
- $1,332
- typical mileage
- 112,000
By model year
Often reported together
Fire or smoke 19Check engine light 12Stalling 8Loss of power 4Engine failure 4Won't shift 3Misfire 3Warning lights 2
What owners say
Vehicle is under Recall 24V‑608 for a fire risk. The vehicle has suffered the exact failure described (Overheating, Limp Mode, and Smoke/Thermal Event). Dealership (BMW of Pleasant Grove Utah) is refusing to replace the failed water pump, offering only a 'protective shield' which does not fix the current failure. This is a failure to provide a free and effective remedy for a known safety defect. A code was discovered when the senior advisor at this location ran the scanner, and displayed a "coolant pump switch-off due to locking" which the senior advisor tried to deflect as a physical object blocking the pump or some other mysterious issue. The issue was confirmed at a reputable maintenance shop earlier in the day before towing to BMW dealership. The senior advisor at BMW of Pleasant Grove is attempting to put me back in the road in a high safety risk vehicle.
The contact owns a 2009 BMW 328i. The contact stated that while driving at an undisclosed speed, the engine overheating warning light illuminated. The vehicle was driven to the intended destination, which was nearby. The contact stated that the temperature gauge was displayed at 240. The contact stated he went inside the friend's residence, and when the contact walked back outside five minutes later, the entire front hood was engulfed in flames. The vehicle was unoccupied. The fire department arrived and extinguished the fire. The contact was informed of the loose wires; however, the cause of the fire had not been confirmed. The contact stated that the vehicle was consumed in the fire. The contact stated that the trunk of the vehicle was the only part left. The vehicle was not towed away. The remains of the vehicle were still in the contact friend's driveway. A fire report was filed. The contact stated that the vehicle was a total loss; however, the insurance company had not confirmed. The contact stated that his insurance did not cover fire insurance. No injuries were sustained. No Police report was filed. In addition, the contact stated that the fire caused the contact's friend's residential window to shatter. The contact received a recall notification: the federal safety agency Campaign Number: 17V676000 (Electrical System) and the federal safety agency Campaign Number: 22V119000 (Engine and Engine Cooling). The contact stated that the local dealer was contacted several times to schedule an appointment; however, the contact stated that the dealer informed the contact that he would receive a call back to schedule the appointment. The contact stated that he never received the call back to schedule the appointment. The manufacturer was made aware of the failure, and a case was filed. The failure mileage was approximately 132,150.
The contact owns a 2013 BMW 328i. The contact stated that while driving at an undisclosed speed, the engine overheated, and multiple warning lights were illuminated. The contact then stated that the vehicle lost power and would not restart. The vehicle was towed to an independent mechanic, where it was diagnosed that the water pump and electrical plug connector had failed and needed to be replaced. The vehicle was repaired. The contact later received notification of the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The vehicle was taken to the dealer, where it was not diagnosed or repaired. The contact requested reimbursement for the cost of the repair that was performed prior to the safety recall, but the dealer informed the contact that the reimbursement claim was denied. The manufacturer was made aware of the failure, and the manufacturer also denied the reimbursement claim. The approximate failure mileage was 89,565.
My 2015 BMW 328i xDrive (VIN [XXX] ) experienced an engine-compartment fire that began shortly after coolant sprayed from the front of the vehicle. This incident occurred before BMW’s official recall announcement for the federal safety agency Campaign 24V‑608 / BMW 24V‑608:474 (Safety: Engine Coolant Pump Electrical Connector). The fire originated near the coolant pump area, consistent with the recall’s described defect involving electrical shorting and overheating at the pump connector. The vehicle was declared a total loss by my insurance company. I believe this event was caused by the same defect identified in the recall and request that this incident be investigated and documented under campaign 24V‑608. Supporting photos and insurance documentation are available upon request. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2014 BMW 328I. The contact stated that while his son was driving at an undisclosed speed, the engine overheated. An alarm sound was coming from the vehicle. An unknown warning light was illuminated, and there was smoke coming from under the hood. The contact's son was able to pull over to the side of the road. The vehicle was towed to an independent mechanic, where it was diagnosed that the water pump had failed and needed to be replaced. The vehicle was repaired. The mechanic called the BMW dealer to order the parts and asked if there was a recall for the water pump, and was informed that there was no recall for the water pump issued by BMW. Upon further investigation, the contact found a recall on the website issued by BMW for the water pump. The manufacturer was made aware of the failure and confirmed that there was a recall associated with the VIN. The manufacturer informed the contact that to receive a reimbursement, the contact needed to contact a local BMW dealer to verify that the recall repair was completed. The vehicle was taken to the dealer, and the contact was informed that the original water pump was needed to complete the inspection. The contact informed the dealer that he no longer had the original part. Several weeks later, the contact received notification of the federal safety agency Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The manufacturer denied the claim for reimbursement since the repair was not completed at a BMW dealer. The failure mileage was approximately 96,000.
Dealer refused to cover DME that failed immediately after recall 24V‑608 work. In early June 2025, I contacted my local BMW dealership about an overheat notification I received while driving. They confirmed there was an open recall on the vehicle for a water pump connector (Recall 24V‑608). I had the vehicle towed to their location. They sent me a video walkaround that characterized everything looked good, except the water pump connector which had failed. Several days later, I was informed the recall repair had been completed but when they plugged in the new water pump connector, the DME shorted and they had to unhook the battery. Despite my best attempts to get this consequential damage covered as part of the recall work, BMW refused. I was told I had to come pick up the car as-is or pay for repairs. When I looked into the issue further online, I learned that if I had chosen to pick up the car, hook up the battery and attempt to start and drive it, I could have found myself stuck inside the car (electronic locks) with a DME that literally caused the whole car to start on fire. Thank goodness I didn't go that route. After further investigation into the recall issue (24v-608), I have learned the entire basis of the recall was risk of a "thermal event" caused as a result the faulty water pump connector shorting out. BMW never denied this when I brought it up. It is infuriating that BMW is suggesting the DME shorting out is not related to or covered by the water pump recall issue. A risk of thermal event is stated in the recall notice, and the DME literally shorted out DURING the recall repair work. They quoted me something like $5,000-7,000 to have the car drivable again. I'm at a complete loss.
The contact owns a 2015 BMW 328I. The contact stated while driving approximately 45 MPH, the A/C was blowing hot air, and the temperature gauge was rising. Additionally, there was white smoke coming from under the hood. The contact stated there was no warning light illuminated. The contact related the failure to the federal safety agency Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The contact had received the recall notification from the manufacturer. The contact called a local dealer and was informed that a plastic shield was to be installed on the water pump, but that the shield would not stop the engine from overheating. The vehicle was not repaired. The manufacturer was informed of the failure . The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 95,000.
The contact owns a 2012 BMW 328I. The contact stated that while driving at an undisclosed speed, the temperature gauge indicated that the engine was overheating, and shortly afterwards the vehicle lost motive power in the middle of the roadway. The contact stated that several unknown warning lights were illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the fuse box. The contact was informed that the fuse box had melted and was stuck to the battery. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 161,000.
My BMW IS OVERHEATING ITS BEEN IMAT BMW OF DOWNTOWN FOR 8 days and they’re trying to charge me to repair my melted fuse box,cooling systems and battery, damage that has occurred as a default of the pcv
Related recalls
Engine and engine cooling: exhaust system: emission control: crankcase (PCV)
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain 2008-2011 128i and 2007-2011 328i, 328xi, 328i xDrive, 525i, 525xi, 528i, 528xi, 530i, 530xi, X3 3.0si, X3 xDrive30i, X5 xDrive30i, Z4 3.0i, Z4 3.0si and Z4 sDrive30i vehicles. The heater for the positive crankcase ventilation (PCV) valve may short circuit.
- Risk
- An electrical short can cause the parts within the PCV valve to melt, increasing the risk of a fire, even when the vehicle is not in use.
- Remedy
- BMW will notify owners, and dealers will replace the PCV valve heater, free of charge. Interim letters were mailed on November 27, 2017. Owners will receive a second notification by the end of October 2018. Owners may contact BMW customer service at 1‑800‑525‑7417.
Recall number 17V683000 · Recall details
Engine and engine cooling: engine
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain model year 2010-2011 128i Coupe, 128i Convertible, 328i Sedan, 328i xDrive Sedan, 328i Coupe, 328i Convertible, 328i Sports Wagon and Z4 sDrive 30i, 2011-2012 135i Coupe, 135i Convertible, 335i Sedan, X5 xDrive 35i, and X6 xDrive 35i, 2011 335i xDrive Sedan, 335i Coupe, 335i Convertible, 528i Sedan, 535i Sedan, 535i xDrive Sedan, X3 xDrive 28i, and X3 xDrive 35i, 2010 X3 xDrive 30i, and X5 xDrive 30i, 2012 640i Coupe, and 640i Convertible and 2010-2012 535i Gran Turismo vehicles. In the affected vehicles, the bolts that secure the housing for the variable camshaft timing adjustment (VANOS) unit can loosen over time and may possibly break.
- Risk
- If the bolts loosen or break the engine may have reduced power or stall. An engine stall increases the risk of a crash.
- Remedy
- BMW will notify owners, and dealers will replace the four VANOS housing bolts for both VANOS units (intake and exhaust), free of charge. In addition, owners of approximately 170,172 model year 2010-2012 BMW vehicles equipped with inline 6 cylinder engines not covered by this recall, will receive an extended warranty to address this condition. The recall began on September 24, 2014. Owners may contact BMW at 1‑800‑525‑7417.
Recall number 14V176000 · Recall details
Questions about the BMW 328I overheating
Which BMW 328I years have engine overheating problems?
The model years with the most reports are 2011 (19 complaints), 2007 (16 complaints) and 2008 (9 complaints).
How much does it cost to fix engine overheating on the BMW 328I?
Owners who mentioned a price put the repair at about $1,332 (median of 8 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used BMW 328I?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history