Back up camera stays on after selecting Drive and moving forward, it will either stay on showing what’s happening behind me or will stay on for 20-40 seconds than go to a blue screen or blue than black screen and stay in that screen. While this is happening I have no control over the display, sound, radio or heat. There has been time the back up camera has stayed on while in park. I have several pictures and videos of these incidents. In the incidents I was able to reboot my display it would be unresponsive and not update time these issues only happened when the back up camera would not properly shut off
2020 Ford Explorer driver assistance complaints
Page 4 of 7: complaints 71 to 100 of 180, newest first, as owners wrote them.
Summer 2023 OTA update to Ford Sync caused Sync system to malfunction. As a result touch screen controls are a black screen. No radio , no rear climate control, no backup camera , no 911 crash assist, no voice activated features, no forward collision warning system. Waiting for service appointment at local ford dealer.
Warning that the cruise control function was not working. The the car would not go more the 5 miles an hour until it had switched out of 1st gear, it kept changing gears. I was scared to death of driving it. I had to use my emergency blinkers everytime I had to slow down and the try to regain speed. The transmission was making a clunk noise and the engine was reviving like crazy. I was afraid of being rear-ended or someone crashing into my car because I could not get out of the way. The car is at the dealership right now, they will not have time to look at it until after the holiday. I was 600 miles from home and terrified.
The contact owns a 2020 Ford Explorer. The contact received notification of the federal safety agency Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed the parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the camera became inoperable with the display screen going black. The vehicle had not been diagnosed or repaired. The failure mileage was unknown. VIN tool confirms parts not available.
I purchased my 2020 Ford Explorer ST in 2020. Since then, I've had several warranty issues and recalls. Presently, this "blue screen" issue when the car is placed into reverse cannot be resolved by Ford who offers no solutions other than platitudes. This is a significant safety issue with the vehicle as the exterior camera assist does not work ("blue screen") and beeps intermittently when the vehicle is in reverse, which is a distraction. I cannot comprehend how/why a vehicle has had so many issues and believe action should be taken against Ford to remedy these problems.
Good Afternoon, the problem that I have encountered for is is that the rear camera does not work all the time a blue screen appears and I am not able to see what is behind me and that can cause me to have an accident. I do not feel safe
When you put car in reverse the camera screen may go blue or black. Sometimes it is all in cone in rear, other times it’s on the right side and at other times it is the entire screen. Turning blue or black. This started in the first several months of ownership in 2020. The dealership tried several things including replacing the camera in 2020-2021-2022. Problem continued. Was told it was all fixed and the same day it happened again. I live in metro DC and have to park in small spaces often between cement pillars. I bought the car specifically for the camera system. I have hit things while attempting to get the camera back to useable again while in heavier car use areas buy not being able to see or have a sensor go off. Since 2020 Ford has had no viable remedy available. No option for new owners other than taking the loss on the car which as a widow I cannot afford to do.
2020 ford explorer st-about 55,000 miles. Dealer: preferred ford in grand haven, mi. Issue is sometimes a multitude of warning lights would come on when traveling. They include shutting down the cruise control when in motion, the forward collision sensor would stop working, all wheel drive and hill assist lights would come on and stop working. This happens whether a short trip, 10-15 miles into town, or on a longer trip. Only way to potentially reset it was to stop, turn vehicle off for a minute or two and restart. Sometimes this worked and sometimes not. This is a safety hazard when operating on a roadway, usually at highway speeds, especially in winter road conditions or an occasional trip through the mountains to the southern states. Had a computer update, which cost $540.00, still not solve it. Finally able to get into dealer with all warning lights activated. Dealer stated has to do with drivetrain. Now today (8-3-23), was advised by dealer a new ford engineer internal service memo stated that is not the total fix. Total repairs cost is in/around $2000.00. If ford knows this is an issue and with the many ford explorers on the road today, this needs to be addressed so the consumer can have confidence in driving their vehicles.
The contact owns a 2020 Ford Explorer. The contact stated that while reversing at an undisclosed speed, the back over prevention camera displayed a black screen. The contact stated that the vehicle was taken to the dealer to be diagnosed. The contact was informed that the back over prevention camera needed to be replaced; however, the parts were not available. The contact stated that she had received notification of the federal safety agency Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact later received a notification that referenced a temporary fix; however, when the vehicle was taken to the dealer, the contact was informed that there was no temporary fix available. The vehicle was not repaired. The manufacturer was made aware of the failure. VIN tool confirms parts not available.
The contact's wife owns a 2020 Ford Explorer. The contact stated that the rear-view camera was displaying a blue image on the screen while in reverse(R). The contact had taken the vehicle to a dealer and was initially informed that there would be a recall to address the failure. The contact then received notification of the federal safety agency Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The vehicle had been taken to several dealers where repairs were made to the rear-view camera; however, the failure persisted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 500. VIN tool confirms parts not available.
17 recalls, multiple recalls for the same thing with the rear view camera Currently have another recall on the rear view camera with no exact date on when remedy will be available. Sounds like a qualifying lemon to me.
I have had the previous recall for my rear camera/display screen repaired in 08/2022. However, recently I have had my display screen start to glitch and turn off intermittently. Sometimes this happens while I am driving. Other times is happens while I am in reverse and the reverse camera does not work. When the reverse camera is not functioning there is concern for unseen dangers. I have videos of this but I cannot upload them into the form.
For months our backup camera would turn blue and not show the rear cameras. Also during this time, on occasion the emergency braking would stop us from backing up and then the brakes would not work. We had a recall on the blue screen software but the breaking has started again.
When the car starts all warning lights come on. Hill start assistance, pre collision assistance, all assistance. There is no cruise, no safety collision assistance at all. First appeared on May 19 2023. Ford Dealer is currently trying to fix the problem. They are unsure why it’s doing it. It puts all occupants life at risks as the car doesn’t have any safety assistance.
360 degree camera is failing. The screen goes blue in reverse and i hit a garage wall unable to see it thru camera. Now the camera is failing in the front as well . Also is now occuring on a daily basis nor random anymore. Ford has not addressed the issue only thue software updates which i have has 2 occasions and yet camera still fails.
My vehicle has had 3 software updates to try correct blue screen issues. Recently under a blue screen i was backing up in a parking garage and hit the wall as i could not see with the screen being blue. Fortunately I was going slow but it did scrape my bumper from hitting the concrete wall. Mostly It scared my kids and had an abrupt stop. I had read a pin on the connector was left uncapped leading to corrosion resulting in faulting screen. Why is ford trying to fix with software update? They should of been replacing connector pins or cameras. I have been experiencing this for over 2 years.
The contact owns a 2020 Ford Explorer. The contact initially received notification of the federal safety agency Campaign Number: 23V022000 (Back Over Prevention). The contact took the vehicle to the dealer where the recall was performed. Once the vehicle was returned, the contact stated that the lane assist, the forward collision assist, and several other electrical features failed to operate as needed. The vehicle was taken back to the dealer however, the mechanic was unable to correct the failure. The manufacturer was notified of the failure and a complaint was filed. The contact was then transferred to the federal safety agency Hotline for further assistance. The vehicle was not repaired. The failure mileage was approximately 42,000. The contact states that none of the accident prevention features are working. After two months, the manufacturer still has not provided a remedy and no parts are available.
The contact owns a 2020 Ford Explorer. The contact received notification of the federal safety agency Campaign Number: 23V022000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the rearview camera image turned black, blue or gray while reversing. The contact stated that the failure occurred increasingly. The messages "Reverse Brake Assist Not Available - See Owner’s Manual” and "Park Aid Fault" were displayed. The local dealer was not contacted. The vehicle was not diagnosed nor repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 58,000. VIN tool confirms parts not available.
The contact owns a 2020 Ford Explorer. The contact stated that there was a blue image on the rearview camera screen and a black image on the side-view cameras. The contact then received notification of the federal safety agency Campaign Number: 23V022000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 8,000. VIN tool confirms parts not available.
Acceleration issues because of transmission slippage. Transmission slippage, upon acceleration transmission, vibration in slippage. Slipping upon acceleration, low speeds, and high speeds. Clutch plate engaging issues. When putting the car from drive into park On a slight incline, car will bounce back-and-forth roughly 1 inch before stopping.
I purchased this 2020 Ford Explorer ST, used while still under factory warranty. Within a week or two the IPMB module started malfunctioning, this affects all of the safety systems to include reverse brake assist, lane keeping assist, rear view camera and more. I have had the vehicle in two different dealerships over 9 times in the 15 months I have owned this suv, and within days of the problem being fixed the unit malfunctions again. I have tried to have the vehicle bought back by the dealer through their customer service program and the BBB of Michigan, to witch both claims have been denied claiming that the chicle does not fall under the NYS lemon law policy for used cars. The issue I have is this problem started within 1-2 weeks if purchasing the vehicle. What are the next steps that can be taken to have Ford Motor Company but this vehicle from me, as there is recall after recall on the unit in question.
on several occasions when applying reverse the rear vision camera gives an image on the blue screen making vision impossible
The contact owns a 2020 Ford Explorer. The contact received notification of the federal safety agency Campaign Number: 23V022000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had experienced the failure. The failure mileage was unknown. VIN tool confirms parts not available.
The contact owns a 2020 Ford Escape. The contact received notification of the federal safety agency Campaign Number: 23V022000 (Back Over Prevention). The vehicle was taken to the dealer where the recall repair was performed; however, the contact stated that while shifted into reverse, the rear-view camera failed, and the screen display was blue. The vehicle was taken to the dealer where the contact was informed that the vehicle was previously repaired under 21V735000 (Back Over Prevention) and needed to be repaired again. The manufacturer was not notified of the failure. The failure mileage was approximately 100,000.
Back up Camera goes blue or blank screen, we have called the Ford Dealer, we took it into their maintenance. Can’t find issue We just received a recall in mail , we called the Ford Dealer today about our backup Camera recall. THEY told us they know nothing about it and Ford Manufacture has not confirmed this issue. ( todays date is 04/05/2023
Backup camera stays on the entire time driving or it will stay as a black or blue screen and not go back to original screen
The contact owns a 2020 Ford Explorer. The contact stated that while operating the vehicle, the back over prevention camera malfunctioned and intermittently displayed a blue screen. Additionally, while driving, the display screen would erroneously activate and cause the steering wheel to momentarily vibrate and shake. The vehicle was taken to the local dealer who performed a software update which corrected the failure; however, after a second software update was performed, the failure reoccurred. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 37,000.
The contact owns a 2020 Ford Explorer. The contact stated that the rearview camera image was distorted. The contact related the failure to the federal safety agency Campaign Number: 23V022000 (Back Over Prevention). The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure. The failure mileage was approximately 40,000.
Despite bringing the vehicle in for two recall repairs, I still get the blue screen on the 360 camera when reversing. This limits my ability to safely back up and view my surroundings.
The issue was initiated when you turn the vehicle on. The vehicle would process through normal startup modes, and then produce several error codes and light illuminations, all within several seconds. The illuminations would consist of; Traction Control Error, Auto Hold Error, Descent Control Error, Lane Assistance Error, and Collusion Avoidance Error. This would then maintain the error during the trip or until the vehicle was powered off for several minutes. After the power cycle, the vehicle would start and show no symptoms of any error codes, at all. This would happen in several different instances a day, lasting several months. In several of my cases, this would disable traction control for longer periods of time throughout the day or week as well. This places extreme risk to drivers who may not know that there are so little standard safety features active while behind the wheel. Additionally, it affects drivers ability to stop, which traction control and auto hold disabled, and reduces the safety of everyone else on the road. I took the vehicle twice to a Ford Certified dealer and repair shop to investigate the issue. The technician was able to verify the codes that arose from the incidents. However, the first instance when I took the vehicle in, they were unable to locate a solution to the problem. After the second visit, they recommended a complete reprogram of 5 major computer modules that have created the system error. I inquired since this seems to be an issue widespread that they could not identify as a user error, but rather an equipment defect. They indeed charged me for the service when this should be something that should be issued a recall and fixed at a wide spread level. The safety of others while on the road are effected and may lead to serious vehicle accidents as a result of the failure of the vehicle component.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 Ford Explorer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history