2000 Ford F-550 SD problems

What is wrong

Ford is recalling model years 1995-2003 windstar, 2000-2003 excursion diesel, 1993-1997 and 1999-2003 f-250 sd through f-550 sd diesel, 1992-2003 e-150 through e-550, 1995-2002 explorer, 1997 and 2002 mercury mountaineer, 1995-1997 and 2001-2003 ranger, and 1994 f53 vehicles equipped with the texas instruments speed control deactivation switch (scds). The scds may leak internally and then overheat, smoke, or burn.

Risk

A vehicle fire could occur with or without the engine running.

Remedy

Ford will notify owners that dealers will install a fused wiring harness in line with the scds. On 1999-2003 windstar vehicles with a leaking scds, dealers will also inspect the ABS control module connector and repair as necessary. Repairs will be completed free of charge. The safety recall began on october 27, 2009. Owners may contact ford at 1‑888‑222‑2751.

Recall number 09V399000 · Recall details

What is wrong

On certain heavy duty trucks equipped with 7.3l diesel engines, the camshaft position sensor located on the engine of the vehicle may function intermittently, possibly resulting in an engine stall.

Risk

In the event of an engine stall, a crash could result without warning.

Remedy

Dealers will inspect the sensor and replace it with an improved camshaft position sensor free of charge. The recall began on december 29, 2007. Owners may contact ford at 1‑866‑436‑7332.

Recall number 07V553000 · Recall details

What is wrong

On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.

Risk

Overheating could result in smoke or burn and an underhood fire.

Remedy

Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford at 1‑866‑436‑7332. (note: also see recalls 05v017 and 05v388)

Recall number 06V286000 · Recall details

What is wrong

Vehicle description: passenger cars, sport utility vehicles, and light and medium duty pickup trucks. A switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, or ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ice obstructs the blades from returning to the "parked" position at the bottom of the windshield. These vehicles were built at the following assembly plants: atlanta plant from 2/11/00 through 7/31/00; chicago plant from 2/14/00 through 8/4/00; kansas city plant from 2/26/00 to 9/4/00; kentucky truck plant from 2/18/00 to 8/31/00; michigan truck plant from 2/23/00 through 8/3/00; norfolk plant from 2/21/00 through 7/27/00; wayne stamping and assembly plant from 2/25/00 through 8/15/00; and wixom plant from 2/15/00 through 8/8/00.

Risk

Loss of visibility while driving increases the risk of a crash.

Remedy

Dealers will inspect the date code on the wiper motor. Motors built with the suspect time frame will have the wiper motor gear case cover replaced. Owner notification began august 20, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1‑866‑436‑7332.

Recall number 01V258000 · Recall details

What is wrong

Vehicle description: trucks equipped with commercial truck tires that have steel cords in the tire sidewall. The valve stems may have been torn or damaged during assembly and could leak causing sidewall damage.

Risk

If not maintained, could result in a sidewall zipper failure. A zipper failure during inflation of a damaged tire could result in injury to someone near the tire.

Remedy

Dealers will inspect the valve stems for leakage, and will replace both the valve stem and the tire if leakage is present. Owner notification began march 28, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1‑800‑392‑3673.

Recall number 01V046000 · Recall details

In a december 3, 2007 letter, ford advised the federal safety agency that it will conduct a safety recall to replace the cam position sensor (cps) in approximately 1.2 million subject vehicles to address reports of engine stalling.a new design cps with improved performance and durability will be installed as a remedy.owner notifications will begin in december 2007. The subject vehicles are durable, full-sized, medium duty trucks commonly used for commercial purposes, rescue/emergency response, and commercial or recreational towing.cps failure is comparable to unexpectedly turning the key off since the signal it produces is vital to the electronic engine control system.cps signal loss terminates fuel injection resulting in an engine stall.once stalled, the engine may restart right away, or may restart after a delay (typically 5 to 10 minutes), or may not restart at all.in addition to exposing the driver and other motorists to crash risk due to loss of motive power or vehicle disablement, engine stalling also effects the power assisted steering and braking. Through consumer interviews, odi determined that cps failures occurred without any form of warning, at any vehicle speed (50% at highway speeds), and under any driving condition, such as accelerating.consumers reported that about a third of the vehicles failed to restart, with another third reporting delayed restarting.half the vehicles that did restart experienced another stall on the same or a subsequent drive cycle (before cps replacement) re-exposing those consumers to the risks associated with a stalling event.in their voq reports, half of the odi complainants described difficulty controlling the vehicle due to lose of power assist systems, especially those who were towing at the time of the incident. The one alleged injury incident occurred in an intersection when a subject vehicle stalled while turning across oncoming lanes of traffic.although unsubstantiated, the complainant alleged an injury to a child occupant during odi's interview.the other crash allegations mostly involved low speed, loss of control incidents often caused by lack of power assist; no injuries are reported in these incidents, and property damage, if any, was minimal.consumers also reported other incidents with significant safety risks, such as disablement in a lane or on a shoulder of a high-speed roadway or interstate, or extended disablement in remote areas during severe weather conditions. The population above is ford's estimate of the 1.4 million subject vehicles produced that are currently registered.the ford complaint and warranty counts noted above are current as of ford's last submission dated june 21, 2007; they do not include f-450, f-550, or econoline counts as these products were not formally within scope of the investigation when failure information was requested.warranty data analysis indicates that about half the claims involved a stall while driving event ( ford's assessment) and that poor cps durability was a longstanding concern.ford reported that the new cps design should meet or exceed their 10 year, 150k mile life expectancy design requirement.

EA06012

Ea05-005 is closed with ford?s actions in recalls 05v‑017, 05v‑388, and 06v‑286, recalling approximately 6.7 million vehicles equipped with texas instruments speed control deactivation switches (scds).the brake systems in these recalled vehicles generate a vacuum that can potentially cause the scds to fail and, in certain switch installation orientations, catch fire.ford is also including the entire population of 1998 explorers.ford has informed odi that testing to determine the cause of failures in the 1998 explorers will continue after this investigation is closed.odi believes that the vehicles exhibiting the factors causing scds failure described in this report correlate well with the observed failure rates on these vehicles by model and model year.the closing of this investigation does not constitute a finding by the federal safety agency that a safety-related defect does not exist in the non-recalled vehicles manufactured with scds that are not included in ford?s recalls.odi will continue to monitor the non-recalled population for incidence of engine compartment fires.the agency reserves the right to take further action if warranted by the circumstances.see attached closing report for details.

EA05005

This investigation was opened on certain ford pickup trucks and vans to evaluate the effects of a valve stem ejection (with rapid air loss) and a slow leaking valve stem on vehicle handing.during the investigation, odi evaluated over 1,100 complaints and warranty claims, conducted vehicle dynamic testing on a subject vehicle with the failure mode replicated, interviewed owners, and examined complaint vehicles in the field.the results of the test program indicates the effect of a valve stem ejection on these vehicles is easily controlled. Further, with a population of almost 900,000 vehicles, having two to four years of exposure, odi is aware of only 3 minor crashes and is unaware of any injuries.the small number of crashes relative to the large population of vehicles is consistent with the testing which was performed. Therefore, this investigation is closed.see the attached report for full technical details.

EA02018

This ea was opened based on a response received from ford motor company to an information request (ir) submitted during sq00-018.ford stated in an internal service message that it had changed the steering gear sector shafts and pitman arms installed 1999 model year f-series super duty vehicles on march 22, 1999.ford stated that these design changes were implemented to make improvements in vehicle steering and handling, and that virtually all of the reported fractured sector shafts were the result of extraordinary, possibly multiple, impacts.an engineering analysis closing report is attached.

EA01009