The contact owns a 2008 Ford Fusion. The contact stated while driving approximately 25 MPH, the vehicle stalled. There were no warning lights illuminated. The vehicle was taken to a local dealer and diagnosed the vehicle with #4-cylinder failure. The contact purchased the parts and had an independent mechanic replace the part however, the failure recurred. The approximate failure mileage was 129,000.
2008 Ford Fusion: engine stalls while driving
11 of the 1,353 complaints about the 2008 Ford Fusion describe engine stalls while driving.
- owner complaints
- 11
- of this car's complaints
- 1%
- typical mileage
- 112,000
- recalls
- 0
Engine stalls while driving by model year
What owners say
Unintended acceleration while slowing down (rolling with my foot feathering the brake) to park in a stall at my local post office my 2008 ford fusion instantly accelerated jump the curb crossed the sidewalk and hit the building. The car continued to rev spinning the front wheels until I shut it off with the key. I verified there is nothing blocking the pedal and the floor mat is secure and clear of the accelerator. I had my foot full hard on the brakes and was unable to stop the car. Fortunately, no one was hurt.
Takata recall - I received the safety recall notice in march 2017. It stated that ford would contact me when the parts are available. I received the notice from tk holdings, inc. About the class action lawsuit vs. Takata. It states that the deadline for filing claims against takata is 12/27/17. I called towne ford dealership in orchard park, ny to schedule the replacement. They stated that they do not have the parts yet. My concern is that this is a stall tactic by both takata and ford to delay past the 12/27/17 date and absolve them of any exposure. I should not have to pay for legal counsel on this matter. Any advise would be welcome/
When I put the AC on the car tries to stall out, and won't pick up any speed, I almost got rear ended more than once because of this problm
Car acceleration was uncontrollable, unable to accelerate, stalling during acceleration. Car will accelerate to 40 and then drop to 0 in a matter of seconds, all while accelerator is being pressed.
Tl* the contact owns a 2008 ford fusion. While driving approximately 60 MPH, the vehicle stalled. The wrench and engine warning indicators illuminated. The contact had to maneuver to the side of the road. After two minutes, the vehicle restarted normally, but the engine warning indicator was still illuminated. The failure recurred approximately fifteen times. The vehicle was taken to the dealer where it was diagnosed that the codes were erroneous and the fuel throttle body assembly needed replacement. The manufacturer was not notified of the failure. The approximate failure mileage was 45,965.
I was on the on ramp for the highway and accelerated to enter ahead of upcoming tractor trailer. I entered the highway and the engine completely shut down on me. I managed to get into the breakdown lane before being hit by the oncoming tractor trailer. I turned off ignition and waited a few minutes before attempting to start car again. It did start and I drove home. Vehicle seemed fine the next few days except for an incident where car was off, no keys in it, but bell kept going off when I opened the door. Had two more instances where car stalled when first started in morning, thought it was just cold. Five days after first incident it happened again. I started car and it stalled several times. When I stepped on gas it felt odd, like it wasn't getting the gas. I proceeded to put in drive, got a third of a mile from home and the exact same thing occurred. I was driving down the street and the car just completely shut down while I was going approximately 25 MPH. Would not start for about 15 minutes but once started I was able to get back home. Happened two more times and I am terrified I will be badly hurt or hurt someone else by causing an accident. No warning just a complete engine shut down. Now after all instances the check engine light has come on.
After I purchase my vehicle about 2 1/2 years ago I contacted my dealer multiple times in the past and I let them know it felt like my car was not accelerating properly and I was told that's just how ford's drive. Eventually the dealer ended up having to replace the coil stating that it had been burned out in the llama problem should be fixed. Now back in august it just got completely worse. I was driving and attempted to accelerate at a green light and my car would not proceed, at that point I continued to press on the gas and eventually my car slowly picked up and begin to go now every time I accelerate my car feels as if it is stalling.
My 2008 ford fusion se 2.3l, 5-speed manual, has shut off on the highway with no warning at highway speeds of 65+MPH. The engine would suddenly lose power and stall and I would have to coast and attempt to control my car at speed until I could get the engine restarted. I was unable to just turn the key forward to restart the engine and had to turn the key backwards all the way into the "off" position before attempting to restart the engine. The engine would not always restart on the 1st or second attempt. This happened to me twice over a 2 week period at high speeds before suddenly worsening and causing my vehicle to stall and not run in idle or randomly at any speed. I took my vehicle to a ford dealership where they diagnosed it as a faulty throttle body (engine fault codes included p0128, p0607, p2107) but refused to cover any portion of the repair despite the vehicle having only 35,500 miles and numerous complaints about similar safety issues on similar vehicles/components.
Tl* the contact owns a 2008 ford fusion. The contact stated while driving 60 MPH, the vehicle stalled and the check engine warning lamp illuminated. The vehicle was taken to the dealer where the technician diagnosed that the PCM malfunctioned causing the coils to melt and as a result, the ignition coil, spark plugs and PCM needed to be replaced. The manufacturer was made aware of the failure. The vehicle was repaired. The failure and current mileage was 112,000. Updated 7/14/14*cn updated 07/18/2014
On an interstate merge ramp, the fusion suddenly lost power and felt like it would stall. Wrench light came on and engine surged with acceleration, but never got over 40 MPH. When I took my foot off the gas pedal, it felt like the car would stall; it lurched and managed to keep going very slowly. I feared for my safety on this very busy interstate. The car lurched and surged until I could get to a safe stopping point.
Service bulletins that may apply
- When performing any transmission fluid change or topoff involving Motorcraft® Premium ATF, MERCON® V has...
- The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic...
- Ford/lincoln/mercury: may have sludge buildup in throttle body leading to less airflow or engine idling...
Related recalls
No recalls on record for this model year.
Questions about the 2008 Ford Fusion stalling
Is engine stalls while driving a common problem on the 2008 Ford Fusion?
11 of 1,353 owner complaints about the 2008 Ford Fusion (1%) mention engine stalls while driving. The model year with the most reports is 2010.
Is there a recall or service bulletin for this on the 2008 Ford Fusion?
There are 0 recalls and 3 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2008 Ford Fusion
ABS 255Brake failure 120Spongy pedal 64Airbag light 38Door locks 37Check engine light 24No deployment 16Jerking 11Loss of power 11Hesitation 7Knocking 6Fire or smoke 6Sudden acceleration 6Engine failure 5Power steering loss 5Transmission failure 5Won't start 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Ford Fusion?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history