2008 Ford Fusion: loss of power steering

5 of the 1,353 complaints about the 2008 Ford Fusion describe loss of power steering.

owner complaints: 5
of this car's complaints: 0%
recalls: 0

Is there a fix? 1 service bulletin covers this area of the car. See below

Loss of power steering by model year

2020
2
2019
2
2018
4
2017
16
2016
54
2015
51
2014
116
2013
174
2012
779
2011
777
2010
932
2009
2
2008
5
2007
8
2006
5

What owners say

Filed Dec 31, 2021 · Electrical, Steering · OH

1. Currently on My 2nd PCM and 4th set of coils and plugs. I was driving My car a few months ago and it started struggling to stay running and the engine light started flashing and after about 2 minutes the car completely shut down. Bought All new coils and Plugs to find out that the pcm was just popping them. Replaced the Pcm and Coils and plugs and Now My car is sitting due to the same problem with the PCM and coils. 2. About a Year ago, I Pulled into the Gas station and when I got back into my car it wouldn't start. After days of Mechanic work I was told that the wiring harness that powers the fuel pump were melted. Which could have very easily caught My car on fire while I was inside. 3. 6 months ago My power Steering went out for the 1st time because of the bolt on the pully and happened again 3 months ago. How are these things not recalled!!?? I've seen a ton of complaints!

Filed Jul 6, 2016 · Electrical, Engine · 63,000 miles · FL

I have replaced the broken bolt on the idler pulley for the second time in 6 months. This is an annoying issue with this engine. Fortunately it happened on statrt up so we were in the driveway. Had it happened on the highway, the loss of power steering could have easily resulted in a fatal crash. The bolt is poorly designed and needs to be larger and or harder. If this is not fixed someone will eventually be killed. How many deaths does it take to warrant attention by ford???

Filed Dec 3, 2014 · Electrical, Engine · 142,000 miles · MI

Belt idler pulley attachment bolt broke off while negotiating a corner, detaching the pulley from the front of the motor causing sudden loss of power steering assist, alternator charging, and engine cooling. Ford fusion equipped with the 2.3l motor. This issue has now happened multiple times, with multiple parts replaced each time in an attempt to fix the underlying issue. A quick search online reveals this to be a very common problem with the ford/mazda 2.3l 4 cylinder.

Filed Jun 24, 2014 · Steering · 60,000 miles · GA

Tl* the contact owns a 2008 ford fusion. The contact stated while driving approximately 10 MPH, there was a loss of power steering without warning. The vehicle was towed to an independent mechanic. The technician informed that the idler pulley bolt fractured. The vehicle was repaired. The part had been replaced a total of four times on separate occasions. The manufacturer was notified of the defect. The approximate failure mileage was 60,000.

Filed Apr 16, 2012 · Steering · 81,000 miles · NC

Over time the vehicle developed gradually more slackness and free play in the steering response. I initially attributed the condition to tire wear and vehicle age. Eventually the condition became so serious that I was certain it was not normal, so I decided to try and diagnose the cause. Upon investigation I discovered that the steering rack assembly was moving around on its attachments in response to steering inputs. I checked the mounting bolts that secure the rack to the sub-frame and found that two of the bolts were loose enough to be turned by hand and the third was broken and was just sitting in the hole. If I had not intervened, the condition would almost certainly have progressed to the point that the steering rack completely detached from its mounts resulting in total loss of steering control.