2023 GMC Sierra 1500: misfire or rough idle

Filed Aug 7, 2026 · Engine, Fuel system · CA

- vehicle started misfiring, ECM, valve timing code, throttle system code, data system, gateway, module,. Vehicle is available and currently at the GMC dealership for continued diagnostic. -this happened on the freeway and out of nowhere the vehicle started shaking, rough, losing power and acceleration, I had to cut someone off on the freeway just to get over to the right shoulder and turned off the vehicle called a tow truck and haven’t been able to use the vehicle since. Vehicle is unable to be driven due to safety issues of increased acceleration and loss of power, intense shaking. -the vehicle is at the dealership now, prior there was a diagnostic performed by a different dealer, and it has been confirmed. -the vehicle is at the GMC dealership now. -ECM check engine light came on prior to the vehicle misfiring and other codes coming up.

Filed May 16, 2025 · Engine · MA

Engine misfire, bringing vehicle to low speed. Safety was a main concern, while I was on a highway and could not maintain a flowable speed with other vehicles. The problem was confirmed by the dealer on 4/25/25 milage 77681, repaired. Then happen again on 5/9/15 milage 79091, repaired and confirmed again by a different dealer. There were no pre-warnings, once it happen all warnings went on.

Filed Apr 30, 2025 · Engine · MI

I was with my two kids about to go on the highway as I accelerated at the speed of the 60 mph the truck completely shuts down I managed to move to the right shoulder my miraculously had to wait for a tow truck for 3 hours. Got truck towed to the dealership they told me it needed an engine and its back order took them 4 weeks to get ot done 2 days later check engine light came back on I was told only a misfire. I was without my truck for another 2 weeks. All this happened back in January of 2025

Filed Apr 4, 2025 · Engine · 33,000 miles · MO

The contact owns a 2023 GMC Sierra 1500. The contact stated while driving at various speeds, the vehicle experienced a loss of motive power. The contact shifted to neutral(N) and was able to restart the vehicle. Additionally, the contact stated that while driving 55 MPH and pulling an unloaded trailer, the vehicle suddenly stalled. A message advising the contact to shift to neutral(N) and to attempt to start the vehicle was displayed; however, the vehicle failed to restart as intended. The contact was still able to use the power brakes and the power steering, which allowed the contact to pull over in a safe area. The vehicle was towed to the dealer, where it was diagnosed that the presence of copper filings in the oil had caused the engine to run roughly. The dealer determined that the engine needed to be replaced; however, the part was not available. Additionally, the average waiting period for an engine was approximately 6 months. The vehicle was not repaired. The manufacturer was informed of the failure and a case was filed. The failure mileage was 33,000.

Filed Jul 26, 2024 · Engine · WV

In late February/early March, my GMC Sierra with around 9000 miles had the following to occur on a cold start: check engine light came on as well as the service esc light & traction control light, truck shuddered and shimmied. Took for service on March 4, 2024 with 9774 miles on odometer, where service tech said they couldn't duplicate concern (see attachments: March Service Invoice Pg 1 & 2). Took truck home & same issues kept occurring especially on cold mornings & days. Took the truck back for service on April 1, 2024 with 10895 miles on odometer. Told them to keep it till its fixed & to start it on cold mornings because thats when problem occurs. They had truck till April 12, 2024 and were able to duplicate the concern. Dealer changed the fuel injector (that was not the problem). Service tech finally found the cylinder 8 has a misfire until vehicle gets to operating temperature. They replaced all 8 lifters in bank 2 (right side) & gave me an oil change. This seems to have fixed the problem, but I won't really know until winter 2025. My problem with this lifter issue is that this engine will probably only last for 3 maybe 4 years tops because of all the metal shavings that are roaming around in the engine. This has been a problem with GM engines for some time & GM has yet to fix it or at least take responsibility for their poor engineering. I paid over $70,000 (of which GM made around $17,000) for this truck only to have the engine probably make it for a few years. My last truck I kept for 10 years. I don't see this happening with this truck.