The safety recall 19S54 is affecting my vehicle. It was made at the same plant at the approved date range as the other vehicles on the recall list but it seems my vehicle wasnt added to the list because it is a hybrid but it has the same exact issue as the non hybrid models
2010 Mercury Milan brakes problems
107 complaints (11% of all complaints for this car). Typical mileage when it fails: 76,000. 8 crashes reported.
- owner complaints
- 107
- of this car's complaints
- 11%
- typical mileage
- 76,000
- crashes
- 8
- recalls
- 1
Which part fails
- Pedals and linkages1
At what mileage
Complaints by mileage at the time of the problem.
Mercury Milan brakes problems in other years
Specific symptoms reported on the 2010 Mercury Milan brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: antilock/traction control/electronic limited slip: control unit/module
- What is wrong
- Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.
- Risk
- If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.
- Remedy
- Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 19S54.
Recall number 19V904000 · Recall details
What 2010 Mercury Milan owners say
Most recent owner complaints, unedited.
The contact owns a 2010 Mercury Milan. The contact stated that while depressing the brake pedal to the floorboard, the vehicle failed to immediately stop. The vehicle was taken to the local brake service center, but the cause of the failure was not yet determined, and the vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the federal safety agency Campaign Number: 19V904000 (SERVICE BRAKES, HYDRAULIC). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was approximately 140,000.
Whenever the car engine isn't warm and I slam on the brakes, they barely respond. I have replaced the master cylinder, abs hydraulic module, brake booster, calipers, pads, and rotors, and it still has about 20% normal braking power when the engine is cold. Just got it back from the dealership again. Dealer said no vacuum leak found, no leaks found, abs module checks out fine, and said the check valve passed diagnostics. The problem remains. This has been ongoing for several years now. May have contributed to an accident in 2023. Not sure as my wife was driving. When the engine is warm, the brakes work perfectly.
The contact owns a 2010 Mercury Milan. The contact stated that while operating the vehicle, the "Check Brake System" and "Service Advance Track" messages remained displayed. The cause of the failure was not yet determined. The contact indicated that the failure had occurred days after the vehicle was repaired under the federal safety agency Campaign Number: 19V904000 (SERVICE BRAKES, HYDRAULIC). The manufacturer and local dealer were notified of the failure. The failure mileage was 240,000.
My name is [XXX] and I own a 2010 Mercury Milan. I bought it on [XXX] from an 84 year old woman who take good care of it. It had 91,000 miles which were mostly hwy miles. She kept records of all her oil changes. After having it for almost 3 years and keeping up with it myself, on February 27,2024 in the morning I put brake fluid in the car. I had brake pads and rotors done on the car in August 2023. On the evening of [XXX], my son and I took a ride to the local 7/11 which is 5 minutes away. While driving home and coming to the traffic light at the beginning of my neighborhood the light turned red. As I proceeded to stop my foot went all the way to the ground and I had no brakes. I had to go through the light because i could not stop. The car was flying down the road because it is a very steep hill. I tried to pull the emergency brake and nothing happened. I was nearing the end of the road going 40 MPH due to the hill. I thought I was going to hit my neighbors house at the bottom of the hill. My son grabbed the steering wheel to turn it and I went up on my curb, across my lawn and crashed into a storage tent on my driveway. My car was wedged inside the tent which was filled with furniture and other belongings. I called Ford Corporation in reference to this recall from December 2019 for 2010 Mercury Milans. Then I spoke with a Ford dealership in Smithtown where they were rude and said the car was 14 years old and I may have to pay if they didn't find my car was part of the recall. I tried calling several other numbers in Washington and was finally told to upload the horrible situation that had occurred due to my brakes not working on this website. Someone needs to look at my car to make sure this will not happen to others. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
On May 10, 2024, as I was rounding a sharp curve, I applied brakes to slow down, but there were no brakes. In fact the brake pedal went to the floor. I had to use emergency brake to stop and gain my wits. I turned around and slowly drove home (about 0.5 miles) and used e-brake to stop and park in front of house. On May 21 I had vehicle towed to dealer. They found that the brake pedal was still against floorboard, but when they started vehicle, it came back up to normal position and was working fine. They could not duplicate the loss of brakes. My vehicle was manufactured within the date range of a TSB regarding hydraulic control unit and DOT3 brake fluid corrosion, but dealer says VIN not applicable to TSB. I am thinking of paying for new HCU anyway, just for my family's protection. I would like my VIN to be included in TSB repair.
The contact owns a 2010 Mercury Milan Hybrid. The contact stated while his mother was driving approximately 30 MPH, the brake pedal was depressed and the pedal extended to the floorboard however, the vehicle did not immediately stop. During the failure, the ABS, traction control, and brake warning lights were illuminated. The vehicle was later towed to the local dealer who diagnosed that the HCU and ABS modules were faulty and needed to be replaced. The vehicle was not yet repaired. The contact was informed that the HCU module was no longer available from the manufacturer. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the federal safety agency Campaign Number: 19V904000 (Service Brakes, Hydraulic). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 60,539.
Power brake failure, brake pedal goes to the floor, vehicle rolls forward and backward while in park, ABS warning and Trac system warning lights are on and also Brake Service warning light.
The brake system went completely out. The brake pedal has no pressure and goes all the way to the floor. When looking online there are 197 complaints after reading through the first 9D all of them were about the ABS control module. All other repairs regarding to the brakes have already been made with the problem still not being fixed. there were no warning signs of this happening. The brake switch just went out when driving home one day. This has all been diagnosed by a private mechanic. The only thing left to change or repair is the ABS control module.
When starting to drive 2 days ago multiple braking warnings went off on the vehicle, including Advance Trac warnings. The vehicle became extremely difficult to stop, requiring high pressure on the pedal. It was able to be stopped safely as there was an empty parking lot nearby. It was taken to a Ford Dealership (Tri-County Ford) and diagnosed with a failure of the ABS Control Module. The part was confirmed by the dealer to be the same as in the federal safety agency recall # 19V904000 (Ford recall 19S54). Repair cost $1220, dealer advised calling Ford. I then called Ford who informed me that my specific VIN was not covered under the recall. There were no issues or warnings prior to this event. The worst part is that this is the second time such an serious incident has occurred with my vehicle which could have harmed or killed me or others. In 2019 the Power Steering failed spontaneously on the car while driving and again, the 2011 Milan Hybrid was covered but not my specific 2010 VIN (I filed a separate the federal safety agency complaint and sent a letter to Ford yet there were multiple reports prior, and multiple similar reports since then, sadly). I have now experienced two major safety events with the vehicle. Thankfully I was very fortunate to walk away from both (at a combined cost of $3000), yet these should have been corrected by Ford and covered under recalls. I am an emergency medicine physician who takes care of people injured in motor vehicle accidents. Shame on you, Ford and the federal safety agency for failing to correct either problem and for keeping similarly unsafe and unrepaired cars on the road! Make sure the correct vehicles are covered with these recalls and if not and additional reports come in, it is your duty to expand them to keep the public safe!
Questions about the 2010 Mercury Milan brakes
Does the 2010 Mercury Milan have brakes problems?
Owners have filed 107 complaints about the brakes of the 2010 Mercury Milan, 11% of all its complaints.
At what mileage do 2010 Mercury Milan brakes problems start?
The typical (median) mileage in owner complaints is 76,000 miles.
Was there a recall on the 2010 Mercury Milan brakes?
Yes, 1 recall: 19V904000. Check your VIN to see if your car still needs the free repair.
What year does the Mercury Milan have bad brakes?
The Mercury Milan model years with the most brakes complaints are 2008 (198 complaints), 2007 (127 complaints) and 2009 (115 complaints).
Other 2010 Mercury Milan problems
Steering 248Acceleration 178Engine 169Transmission 149Fuel system 138Lights 135Airbags 106Electrical 105Driver assistance 34Body 10Wheels 10Visibility 4Locks 3Suspension 3Tires 2Seats 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2010 Mercury Milan?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history