Entered my parked car on a sloping driveway and started the engine to pull away. I hit the brake pedal to put the car in gear and the brake pedal gave under the pressure of my foot and went to the floorboard. No brakes, car rolled into street and I was able to drive home with very little stopping ability. Thank goodness I only had to go a short distance to my house with no stopping required in the 6 mile trip. As it turns out the rear brake line had rusted away and blew out under normal use and dumped the fluid.
2000 Chevrolet Impala: brake failure
8 of the 817 complaints about the 2000 Chevrolet Impala describe brake failure.
- owner complaints
- 8
- of this car's complaints
- 1%
- typical mileage
- 80,123
- recalls
- 0
Brake failure by model year
What owners say
I was heading to work I slowed to turn right on to the on ramp of the interstate, as I began my turn I lost all power the vehicle shut off, lights went dead and the brakes went out. I made it to the curb and vehicle would not restart.vehicle had to be towed home. I have checked all that could have caused the issue and have narrowed it down to the ignition switch, battery has been replaced even though it checked fine. Starter is brand new. Mass air sensor checks ok and cam and crank sensors check ok. I was lucky if I had been on the interstate I would have had no chance to recover from this failure. Even though this vehicle is 14 years old this type of failure should not have happened. I have never carried more than the ignition key and key fob on the key ring as both my wife and I use the vehicle.
When I applied the brakes to stop the car, the pedal went all the way to the floor. Since the car was going only 5-10 MPH, I was able to stop without hitting anything. When I checked the brakes, I found that the right rear brake line had rusted through, approximately 4 inches to the rear of the fuel filter. I had both rear brake lines replaced, for the other was rusty.
Dt: contact states while driving his vehicle, he experienced complete brake failure. When he applied the brakes, he heard a popping sound and the pedal went to the floor. The vehicle was towed to the local dealer and they found rust on the brake line. The dealer replaced the brake line and this corrected the problem. *jb updated 12/27/05.
Dt: contact owns a 2000 chevrolet impala; contact complaint that brake linings corroded. While driving on highway, in course of hitting brakes and all of a sudden, there was no brakes. Car was towed to local dealer. Mechanic could not fix brake lines. Consumer had to pay for brakes to be fixed at another dealer . . No injuries. No police reports. No crashes.
The consumer stated that since she purchased the vehicle in august 2003 the brakes did not worked properly. When applying the brakes they constantly grabbed and let go. She did not know whether she could talk to the dealer about the problem, but will get in touch with the dealer tomorrow. *ak the brakes were repaired at the dealership. The brakes pulsated when they were applied the trunk light was inoperative. *sc
Car completely turned off while the secruity warning showed in the message center when driving at 65mph on the freeway and had to force the car off the road with no brakes and no power steering.
When driving 40 MPH, driver stomped on pedal in a panic stop and the connection which went to the brake pedal piston collapsed, causing total brake failure. Accident resulted. Consumer has contacted the dealer, not parts had been replaced. *ak
Service bulletins that may apply
- Service brakes, hydraulic
- ABS pump running when not needed
- ABS indicator on intermittently
- ABS light on and possible diagnostic trouble codes
- ABS light coming on and codes C1225, C1226, C1232, C1233, C1276 and/or C1277 are found in the ebcm
- Service manual update regarding revised brake rotor lateral runout check specification
- Concerns with rattle type noise coming from the front of the vehicle
- Some customers may comment about a rattle type noise coming from the front of the vehicle under 30 mph and...
Related recalls
No recalls on record for this model year.
Questions about the 2000 Chevrolet Impala brake failure
Is brake failure a common problem on the 2000 Chevrolet Impala?
8 of 817 owner complaints about the 2000 Chevrolet Impala (1%) mention brake failure. The model year with the most reports is 2000.
Is there a recall or service bulletin for this on the 2000 Chevrolet Impala?
There are 0 recalls and 11 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2000 Chevrolet Impala
Stalling 87Fire or smoke 56Airbag light 46Won't start 43Harsh shifting 28Steering noise 23No deployment 18Check engine light 18Hesitation 18Headlights 16Engine failure 14Power steering loss 14ABS 10Ball joint 10Knocking 10Fuel gauge 10Jerking 10Overheating 10Steering lock-up 10Fuel pump 8Transmission failure 8Loss of power 7Pulling 7Door locks 6Fuel leak 6Adaptive cruise 5Sudden acceleration 5Whining noise 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 Chevrolet Impala?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history