The engine malfunctioned and faulty rear seat belt, it is not available for inspection because it started a fire that destroyed by car. The remains of the car is at a savage yard. We were put at risk because we were driving/riding in the car at the time it starting burning. We were able to pull the car over and park it in a gas station parking lot before it became fully engulfed in flames. I am reaching out to Ford. Since it was not an accident involved, the fire department inspected the vehicle and determine the fire started in the engine. Insurance representative has determined it is a total loss. There were no warning lamps or messages from the car. However, what caused us to detect something was wrong was the thick smoke started filling the car's cabin at which time we immediately pulled over. When we stopped the car, actual flames came from under the hoods towards the windshield of the car and we proceed to exit the car. My granddaughter in the back seat was having a hard time releasing herself from her seat belt.
2013 Ford Fusion seat belts problems
100 complaints (6% of all complaints for this car). Typical mileage when it fails: 63,000. 6 crashes reported.
- owner complaints
- 100
- of this car's complaints
- 6%
- typical mileage
- 63,000
- crashes
- 6
- recalls
- 2
Which part fails
- Pretensioner1
- Front1
At what mileage
Complaints by mileage at the time of the problem.
Ford Fusion seat belts problems in other years
Specific symptoms reported on the 2013 Ford Fusion seat belts
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Seat belts: front
- What is wrong
- Ford Motor Company (Ford) is recalling certain model year 2013-2016 Ford Fusion vehicles manufactured November 2, 2012, to July 31, 2014, and 2013-2015 Lincoln MKZ vehicles manufactured November 14, 2012, to July 31, 2014. In the event of a crash, heat from the deployment of a seat belt pretensioner may cause a front seat belt anchor cable to fail.
- Risk
- If the driver or front passenger seatbelt cables cannot properly restrain the front seat occupants, they would be at an increased risk of injury.
- Remedy
- Ford will notify owners, and dealers will apply a protective coating to the seat belt cable, free of charge. The recall began May 16, 2017. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 16S42.
Recall number 16V875000 · Recall details
Seat belts
- What is wrong
- Ford Motor Company (Ford) is recalling certain model year 2013-2014 Ford C-Max vehicles manufactured January 19, 2012, to November 21, 2013; Ford Fusion vehicles manufactured February 3, 2012, to August 24, 2013; Ford Escape vehicles manufactured October 5, 2011, to November 1, 2013; and Lincoln MKZ vehicles manufactured April 25, 2012, to September 30, 2013. The coating on portions of the Restraint Control Module (RCM) may crack, and when exposed to humidity, circuits on the printed circuit board may short.
- Risk
- The short circuits could cause the frontal air bags, side curtain air bags and the seat belt pretensioners to not function as intended when needed, increasing the risk of occupant injury in the event of a crash.
- Remedy
- Ford will notify owners, and dealers will replace the RCM, free of charge. Parts are not currently available. The recall began on May 26,2015. Owners may contact Ford customer service at 1‑866‑436‑7332. Ford's number for this recall is 14S21.
Recall number 14V597000 · Recall details
What 2013 Ford Fusion owners say
Most recent owner complaints, unedited.
The contact owns a 2013 Ford Fusion The contact stated while driving at an undisclosed speed, the contact became aware that one of the passengers was unable to properly engage their seat belt. The contact stated the seat belt remained locked and could not be removed from the base. The contact became aware of a failure with the hardware body of the seat belt after inspecting the vehicle. The contact was concerned that the middle seat belt section of the vehicle posed a safety hazard for his children. The dealer was contacted and informed the contact to call the manufacturer for assistance. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NSHTA Hotline for assistance. The failure mileage was approximately 136,179.
The contact owns a 2013 Ford Fusion. The contact stated that while operating the vehicle, the passenger’s side air bag warning light remained illuminated. The vehicle was taken to the local dealer who diagnosed that the passenger’s side seat belt sensor was faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the federal safety agency Campaign Number: 14V597000 (Air Bags, Seat Belts). The failure mileage was 110,000.
The contact owns a 2013 Ford Fusion. The contact stated that on several occasions when the vehicle was started and the seat belt was connected, the air bag warning light illuminated. The vehicle was taken to a dealer where it was diagnosed that the seat belt sensor needed to be replaced due to failure in detecting that the seat belt had been inserted. The manufacturer was notified of the failure but provided no assistance. The failure mileage was unknown.
The contact owns a 2013 Ford Fusion. The contact stated while driving 40 MPH, the vehicle started overheating with the high engine temperature warning light illuminated. The contact was able to pull over and waited until the vehicle cooled down. The vehicle was restarted and operated normally. The vehicle was taken to the dealer and the contact was informed that the manufacturer would be notified. The vehicle was diagnosed, and the contact was informed that the coolant sensor needed to be replaced due to DTC: P1299 that was retrieved. An independent mechanic replaced the coolant sensor, but the failure persisted. On another occasion, the contact stated that while attempting to remove the seat belt from her child, the seat belt would not release. The contact had to remove the bolts from the retractor to remove the seat belt. The manufacturer was not contacted. The failure mileage was 105,000.
When the car interior gets very hot, the driver's seat belt tensioner refuses to disengage, preventing the driver from fastening his seat belt. This has occurred several times, over several summers; this was not just a one-time occurrence.
The engine coolant continually needs to be refilled, and has resulted in the car overheating multiple times. I have had the coolant system checked multiple times for leaks and they say that the pressure test doesn't show any leaking. I have had to pull over on the side of the highway twice since I've had the car to wait for it to cool down to put coolant in, which I now have to carry in the trunk because it happens so often. I don't know if the engine is just running hotter than it should and causing this but I would like to know if this has been a problem with other fusions because its become a big safety issue when I have to pull off the highway to fix the car. Also, I don't know if this has been a problem with other fords but the seatbelt constantly locks while trying to put it on whether the car is on or off.
Rear seat seatbelt locks up when the seat is moved down and won’t retract and only gets tighter when it gets pushed back up. Tightens on passengers in back seat at times. Has been taken to a dealership. Contacted other people who own fusions of the same year and they have similar issues.
The dash lit up notifying of a parking brake error while driving. Got home, parked car, turned car off. Went inside for about two minutes. When came back outside, there was smoke rolling out of the window. Put fire out. After examining, the fire appeared to have started from something electrical in the center counsel on the right side. It caught the seat on fire, melted the counsel, and the roof. No smoking of any sort has been allowed in my car since I got it. It was stationary when the fire started, but it was immediately after being driven.*dt
Rear middle seat belt locks each time the upper seat portion is lowered, regardless of it it is latched or not. Car does not have to be on or moving for this to occur. To remedy, the bottom seat has to be removed, and seat belt unbolted from car. I am concerned the belt could lock around a person if seated there. There is no leeway in the belt to pull to try and release the tension. Have experienced numerous times, beginning in december 2017.
Questions about the 2013 Ford Fusion seat belts
Does the 2013 Ford Fusion have seat belts problems?
Owners have filed 100 complaints about the seat belts of the 2013 Ford Fusion, 6% of all its complaints.
At what mileage do 2013 Ford Fusion seat belts problems start?
The typical (median) mileage in owner complaints is 63,000 miles.
Was there a recall on the 2013 Ford Fusion seat belts?
Yes, 2 recalls: 16V875000, 14V597000. Check your VIN to see if your car still needs the free repair.
What year does the Ford Fusion have the most seat belts problems?
The Ford Fusion model years with the most seat belts complaints are 2013 (100 complaints), 2014 (75 complaints) and 2015 (24 complaints).
Other 2013 Ford Fusion problems
Engine 448Steering 389Transmission 281Body 164Electrical 160Fuel system 142Airbags 101Locks 85Brakes 73Acceleration 43Driver assistance 43Wheels 32Lights 30Visibility 29Seats 27Suspension 11Tires 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 Ford Fusion?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history