2015 Mercedes-Benz ML350 technical service bulletins
125 technical service bulletins and manufacturer communications cover the 2015 Mercedes-Benz ML350, including 2 warranty extensions.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Mercedes-Benz USA, LLC will provide an Extended Modification Warranty for each vehicle that has received...
- Visibility/wiper
- Customer complaints relating to automatic transmission 725.0 (NAG3 Classic /9G‑TRONIC automatic...
- Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is...
- Only vehicles with a variable transfer case are affected
- Clanking noise from the area of the speakers in the doors
- Customer complaints relating to automatic transmission 725.0 (NAG3 Classic / 9G‑TRONIC automatic...
- During part of the steering movement, it feels heavier or more difficult to steer in the same spot every time
- This document is intended as a pre-case diagnostic reference for transmission related concerns
- Mercedes-Benz USA is currently experiencing limited availability of transmission fluid specification ATF...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Creaking noise, in irregular sequence when driving slowly in combination with slight steering movements...
- After successful commissioning of the HERMES control unit (N112/9) with XENTRY Diagnosis DVD 03/2026, the...
- Dear Mercedes-Benz USA Dealers, The part numbers listed in the chart below should no longer be installed,...
- The part numbers listed in the chart below should no longer be installed, and any existing stock must be...
- Headlamp, front fog lamp leaky or fogged
- Headlamp, front fog lamp leaky or fogged
- Headlamps leaking or fogged
- Check engine light on with the following fault is current in the VGS Control Unit: P084300 Oil pressure...
- (Original LI document #: LI27.35-P-079039) Clicking noises from the electro-hydraulic control unit (EHS)...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Possible complaints about shift quality, issues with learning the park lock, and slipping/rinse entries in...
- Commissioning not possible after replacement of TRANSMISSION 722.9 or of electrohydraulic controller unit...
- After a software update of HERMES communication module N112/9 has been performed on a gray import vehicle,...
- Headlamp, front fog lamp leaky or fogged
- Vehicle with atypical reduced heat output
- A clicking/ticking/taping noise from underneath the vehicle with engine off during ECO stop event or after...
- During a phone call, the called party has difficulty understanding/cannot understand the driver, or...
- Creaking noise, in irregular sequence when driving slowly in combination with slight steering movements
- Fuel door may require several attempts to open
- Windows of the front doors poorly adjusted/sluggish
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- The flap of the reversing camera opens and closes by itself during forward travel several times during the...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- The flap of the reversing camera opens and closes by itself during forward travel
- Creaking noise, in irregular sequence when driving slowly in combination with slight steering movements
- After a control unit replacement of "N112/9
- Transmission control unit Y3/8n4 (fully integrated transmission control unit (VGS)) not listed in quick...
- Rear lamps fogged up/not leaktight
- Only vehicles with a variable transfer case are affected
- Washer fluid system leaks
- Headlamp or front fog lamp leaky or fogged
- Headlamps fogged or droplets forming
- To insure vehicle down time is kept at a minimum and all required information is available when case is...
- Headlamps fogged or droplets forming
- Electrical system
- In our continuing efforts to ensure the proper performance and quality of your vehicle, we are writing to...
- Crease formation on genuine leather seat covers in vehicles with low mileage ⢠Objects left on the seats...
- In our continuing efforts to assure the proper performance of Mercedes-Benz products and to enhance the...
- The touchpad dimming function does not work and the search lighting is either at maximum brightness or...
- MY15+ M278 and M157 Equipped Vehicles with Fault Code ""P023400 – Boost Pressure is Too High"" "
- Touch pad: Search lighting does not dim or does not turn on.
- Electrical system: software
- Armrest In Center Console (Front) Only Opens On One Side Or Not At All
- Creaking noise from fixed glass section of panoramic roof in area of rear passenger compartment grab handles
- Mercedes-Benz USA, LLC (?MBUSA?) has entered into an agreement with the United States Department of...
- Incorrect time and/or instrument cluster message "SOS, service not activated" and/or Mercedes Me connect...
- Lamp unit fogged or droplets forming
- To enhance the satisfaction of our customers, avoid further costs of litigation and return focus to its...
- Update engine control unit software
- Reversing camera nonfunctional on vehicles with code 805 YoM 14/1 (MY15)
- Minor oil filler neck leak
- Xentry (daimler): after key cycle, vehicle in limp home mode, returns to normal operation due to being...
- Xentry (mercedes): stored in engine control unit (ECU) is fault to exhaust back pressure sensor causing...
- Engine diagnosis warning lamp lights up in instrument cluster, fault code U145400: "Implausible data were...
- Summary to be provided on a future date.
- The 1-2, 2-3 and/or 3-4 acceleration upshift can be uncomfortable when the transmission oil is cold.
- The electric seat adjustment and/or the seat heater/seat ventilation or rear monitor is nonfunctional
- Noise in center console area of W166.
- Side windows may make noises when closing and opening, or reverse direction when closing.
- Oxidation products of the cavity preservation can enter the interior compartment via the air conditioning.
- Fault code(s) 13BA00, 13BB00, 13BC00, 13BD00, 13BE00, 13BF00
- Xentry (mercedes): after engine has started, several issues occurs, an acoustic warning sounds is heard,...
- Xentry( mercedes): blind spot inoperative
- Belt holder/ retaining tab on side paneling in trunk is broken
- Minor leaks at the oil duct of the left or right cylinder head of engines 157, 276 and 278
- ACTIVE CURVE SYSTEM malfunction in instrument cluster in combination with the following fault codes in the...
- Rumbling noises from the area of the front axle.
- Brake linings on rear axle exhibit differential wear
- A production fault means that the telematics DVD A 166 827 14 00 cannot be used
- The engine diagnosis warning lamp
- Cracking noises or squeaking noises at the doors in the area of the window frame while driving, especially...
- Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control...
- Sound system: Intermittent loss of sound after engine start
- Creaking noise when making vertical or longitudinal adjustment to electrical steering column
- Engine diagnosis warning lamp active
- The complete headliner can no longer be replaced for loose headliner magnets
- Cracking, clunking noise when braking the vehicle to a stop or when moving off, when the suspension...
- The rear seat heating cannot be activated when the customer has set the ambiance illumination to "Neutral"...
- The liftgate can no longer be opened when the ambiance illumination is set to stage 1 or 2.
- Oil spray or fouling on the ACTIVE CURVE SYSTEM is not related to leakage of the hydraulic pump.
- The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the...
- Engine diagnosis warning lamp lights up
- Message in instrument cluster "DISTRONIC PLUSCurrently Unavailable
- Thumping noises from front axle when driving over bumps on road.
- Software update of COMAND Online control unit.
- Engine diagnosis warning lamp lights up. Fault code 20B91B, 20B913 (The output for the heating element of...
- Mobile phone cotacts are not transferred completely.
- FC 2783 (Friction power of torque converter lockup clutch is too high) or FC 0741 (Actuation of torque...
- Since 12/2012 (model 166) and since 06/2013 (model 242) the glass breakage loops are no longer in the side...
- Thumping noises at the front axle when driving over road bumps
- Single, throttle lift-off, clunking noise from the side shaft when starting off (audible at the wheel)
- Engine rattling noise after engine start for several seconds
- 1. In vehicles up to VIN 166 ### #A 097760 without code 803, the following fault code is logged in the...
- Customer experiences low battery conditions, resulting in jump starts, and eventually requiring battery...
- Engine diagnosis warning lamp activated
- The COMAND unit does not start or the COMAND display remains dark
- Combination message: "Clean fuel filter" is displayed
- A flapping/rattling noise can be heard from the area of the center console towards the rear.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 Mercedes-Benz ML350?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history