2016 Ford Focus: sudden loss of power

Filed Nov 3, 2026 · TX

I am filing this complaint regarding my 2016 Ford Focus S and concerns about a potentially recurring safety defect associated with Ford’s safety recall involving the canister purge valve. My vehicle experienced a no-start condition and stalling. The vehicle became inoperable and had to be towed to an authorized Ford dealership for inspection. These symptoms are particularly concerning because the recall information describes the possibility of engine stalling and difficulty restarting the vehicle. The dealership informed me that the recall had previously been performed on my vehicle. However, despite the recall repair, my vehicle experienced symptoms consistent with those described in the recall. The dealership was able to start the vehicle when it arrived and stated that it could not reproduce the problem. The dealership subsequently performed diagnostic testing on a dyno but claimed that the issue was unrelated to the recall. No definitive cause for the no-start and stalling condition was identified. I was charged $219 for the diagnostic testing. I am concerned that the dealership’s inability to reproduce an intermittent problem does not establish that the underlying safety defect has been corrected or that the current symptoms are unrelated to the recalled component. A vehicle that unexpectedly stalls or fails to restart creates a serious safety risk. If the engine stalls while driving, the driver could lose power and potentially lose power steering assistance and normal brake assistance. The vehicle could become disabled in traffic, at an intersection, or in another dangerous location. A vehicle that unexpectedly fails to restart could also leave the driver stranded in an unsafe location.The problem was intermittent, which may explain why the dealership was unable to reproduce it during its inspection. I am requesting that the federal safety agency investigate whether the recall remedy is adequately addressing this safety concern and reimbursement of a diagnostic and tow fee.

Filed Sep 20, 2026 · Transmission · TN

The DPS6 transmission started out shuddering in low gears even after clutch replacement early on. This made pulling out into traffic slower than it should be. Received “transmission overheating” message “pull over for 5 minutes” in heavy traffic. Prior to the message car would shudder and lose power. This happened suddenly going at highway speeds on the interstate. Replaced clutch actuators and TCM only to have the clutch adaptive learn procedure fail and after inspection by the dealer was told needs new transmission. These problems have been present at very low mileage and Ford now wants to charge a ridiculous amount to replace transmission that should have been fixed long ago. Several times the car stalled in traffic almost causing me to get in accidents.

Filed Feb 5, 2026 · Transmission · TX

The vehicle experienced failure of the DPS6 dual-clutch automatic transmission. The transmission began slipping during acceleration, hesitating between gear engagement, and triggering a “Transmission Overheat” warning. Eventually, the vehicle lost the ability to reliably shift between Drive and Reverse and would not consistently engage gears. The vehicle can start and move forward but cannot reliably switch directions within the same ignition cycle. The vehicle is available for inspection. The transmission malfunction created safety concerns due to delayed or failed acceleration when entering traffic. The vehicle hesitated and slipped under throttle input, which could prevent timely acceleration when merging or crossing intersections. Additionally, the inability to reliably shift between Drive and Reverse could create hazardous situations in parking lots or emergency maneuvering scenarios. The sudden transmission overheat warning and gear disengagement could result in loss of power in traffic. The issue has been confirmed by an independent mechanic who diagnosed transmission failure. The vehicle has a known history of prior clutch replacement under similar symptoms. The transmission malfunction is consistent with documented DPS6 transmission failures in 2016 Ford Focus models. The vehicle has been inspected by an independent service center. The manufacturer has not inspected the vehicle. Prior to failure, the vehicle exhibited shuddering during acceleration from a stop, particularly at low speeds. This condition has been intermittently present for several years following a prior clutch replacement. In the days leading up to failure, the vehicle experienced difficulty accelerating and hesitation under throttle. A “Transmission Overheat” warning message appeared while driving. After cooling, the vehicle temporarily resumed operation but subsequently lost reliable gear engagement.

Filed Jan 23, 2026 · Acceleration, Transmission · UT

When driving my car all of a sudden it loses power almost like it’s struggling to go but the RPM revs up and makes a loud noise and my car kind of got stuck for a minute and there were cars behind me then it started going but every couple minutes it would do that again rev up really loud even when I barely push the gas and lose power and then go I have no idea why it was doing that I took it to get it looked at, but there was no light on then a light finally came on and it came up with P07A3. Transmission friction element A stuck on. It starts end doing that with no notice. Light came on later after I tried to get it scanned. There seems to be extended warranty satisfaction things offered on vehicles at the same time mine was made. Same vehicle. But my number is not on the vin recall. But it exhibits same symptoms. The ford customer satisfaction program 14m02 covers same issues but my vin is not listed. This is a driving hazard unsafe that I feel is issues from their manufacturing.

Filed Jan 13, 2026 · Engine, Fuel system · SC

Fuel purge valve is malfunctioning. Vehicle loses power and is sluggish. Idles very rough and sometimes has a loss of power. My car has been at Ford twice in the last six months and problem still isn't fixed. Complete engine was replaced about a year and a half ago due to recall issue which I don't want happening again. I do not feel safe driving this car. I made an appointment with Ford a month ago for tomorrow for same stalling issue. I went to drop off and explain I wanted the repairs done for the recall to see if that fixed the problem. I filled up my gas tank on Sunday. The car wouldn't start and engine light came on saying engine failure service now. I let it sit for about ten minutes and it hesitantly cranked and engine light went off but accelerates slower with loss of power. It keeps doing this intermittently and sometimes loses power, and struggles when idling. I cut off let sit and then is okay until I pump gas again. I told the service repair person what happened and handed him the key to drop off the vehicle. He said if the light was not on at the time he would not be able to fix it and they couldn't schedule my vehicle for any additional recalls that are greatly needed for the car. It is running terrible. It idles and intermittently loses power while driving. Evan at Ford (Greer) response was to wait until it got bad enough that the engine light came on and stayed on. This was at D&D Ford in Greer, SC. He said it was Ford's policy the light had to be on to replace under recall with no charge. I told him it is unsafe to drive if it gets any worse it could cause an accident. I have two children and his recommendation to wait until it gets worse was appalling. He kept backlashing Ford and stated he doesn't work for Ford he works for D&D and only represents Ford. I said to him he was not representing Ford very well and that it was highly unlikely they would agree with his statements. I asked for documation of this policy--it contradicts what he says.

Filed Nov 1, 2025 · Engine · NJ

In the Ford 3 cylinder 1.0L Ecoboost engines there is a terrible wet belt system, there is a recall on the automatic models but nothing for the manual models, regardless of the fact that the manual models are designed far more poorly than the automatic models in the sense that the manual models have no tensioners and rely solely on the factory tension of the screws, keeping in mind that the belt is both rubber and sitting in hot oil when in use, if not a money grab, my best guess is that they hoped the wet rubber belt would simply not not stretch in good faith. 4 days after getting basic maintenance, the wet belt failed, clogging the oil pickup causing engine failure, and temporary loss of power steering, after the engine was given time to warm up, luckily the road was nearly empty, and i was driving at a slower pace. However the fact that Ford Motor Company has gone nearly a decade without dealing with the issue, and then denies having knowledge of this design flaw, is absolutely and abundantly absurd. I have all vehicle maintenance records, as well as mechanic testimony, all of which point to this incident being caused by poor engine design. In addition to the estimated cost to replace the engine is 8,500$, or about 140% the cars total value prior to the engine failure. This a NOT a minor issue, this is not even a uncommon fail point on many other manual models, this IS a major safety concern, that god forbit it, could lead to a major accident. I simply think that the Ford Motor Company should be made accountable for cheaping out for profit, at the cost of customer’s safety.

Filed Oct 29, 2025 · Engine · NJ

The transistor arm or tensioning arm for the wet belt, which drives the oil pump in the oil pan failed, leading to oil starvation to the engine, causing total catastrophic engine failure, and temporary loss of power steering, while driving, fortunately, I was moving at a slow pace in minimal traffic, however, this is a known fail point in Ford 1.0 L ecoboost 3 cyl engines, that Ford claims my vehicle does not have, and refuses to cover, regardless of the fact that it did happen, and I have pictures in mechanic testimony to prove this to be true, had I’ve been on a different road, or had more traffic, this could have to a fatality. The engine replacement would cost a estimated 4500-7500$

Filed Aug 6, 2025 · Acceleration, Engine · NY

2016 Ford Focus, VIN: [XXX] Power Train: Automatic Transmission: Control Module (TCM) This complaint details a recurring and severe safety defect in our 2016 Ford Focus. The vehicle's Transmission Control Module (TCM) has failed twice, resulting in sudden, complete loss of power and dangerous stalling incidents at highway speeds. In January 2023, at approximately 8,000 miles, the vehicle suddenly lost all propulsion while traveling on a highway. We were forced to execute a dangerous emergency maneuver across lanes of traffic to reach the shoulder. A Ford dealership diagnosed a failed TCM which had, in turn, caused the clutch to burn out. In July 2025, after only 7,000 additional miles (total vehicle mileage ~15,000), the identical, catastrophic failure occurred again. The vehicle once more stalled without warning on a major highway, creating another life-threatening situation. The diagnostic codes confirmed the same TCM and clutch failure, proving the issue is a persistent, underlying defect and not a random occurrence. This failure is entirely consistent with the widely-documented defect in Ford's Powershift (DPS6) transmission. This problem has been the subject of multiple national class-action lawsuits and is detailed in thousands of other consumer complaints filed. The repeated failure in our low-mileage vehicle underscores that this is a predictable and systemic design flaw that makes the vehicle inherently unsafe. We attempted to address this critical safety failure directly with Ford Motor Company. Our concerns were met with dismissal, and despite being issued a case number, Ford has failed to respond to our calls registered letter. This vehicle is unsafe to operate. We are filing this complaint to implore the federal safety agency to launch a formal investigation into this defect. The repeated, sudden loss of power presents an unreasonable risk of serious injury or death to occupants and other motorists. We believe a mandatory recall is urgently required. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATI

Filed Mar 18, 2025 · Fuel system, Transmission · GA

My clutch and or transmission is malfunctioning. When I drive up hill the car shudders and I lose power, it's a risk when another vehicle or pedestrian is behind me. When I accelerate from a full stop, same symptoms. If in an emergency I have to move I would be at risk because then the vehicle would hesitate. The issue was confirmed with the manufacturer's dealership service center. No warning lamps, no messages just a sudden appearance of the symptoms that were progressively getting worse. I looked up two separate customer satisfaction programs which I believe I should be eligible but bought the vehicle after their expiration and even though I think the vehicle satisfies the programs' terms, the manufacturer did not include my vehicle's vin.

Filed Feb 16, 2025 · Engine, Transmission · MI

2016—2022 Ford EcoSport® and Focus® 1.0L Engine--- My car is experiencing the same issue as the Automatic transmission. The car is not listed on the Oil Pump Failure Recall on the Ford Website as it shows that it applies to automatic transmission, and doesn't mentioned manual transmission. Both transmission carry the same issue as it's an engine design flaw and not a transmission related issue. The car experienced a bad idle that results to lost of power and Oil light went on as I drove it to the Mechanic shop. Currently there's no parts available and ford website the part is back ordered. The reference number is 23S64 for the current recall of the 1.0L engines. Please see reference below. I've contacted Ford support about the issue and was informed to report the issue here. Website for reference: [XXX] . INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Dec 8, 2024 · Acceleration, Transmission · OH

The car is shuddering on acceleration. RPM currently rises and falls in an unnatural manner. Loss of power and gas mileage. This appears to be the same issue that other 2016 ford focuses are covered by.

Filed Aug 6, 2024 · Engine, Fuel system · AZ

My 2016 Ford Focus SE is stalling at higher temperatures while driving at high speeds, which is very dangerous. This issue occurs primarily during hotter daily temperatures. I have previously taken the vehicle in for the recall (the federal safety agency Campaign Number: 18V735000) related to the Canister Purge Valve (CPV) malfunction, which was supposed to address excessive vacuum in the fuel vapor management system. However, this did not resolve the stalling issue. This has stalled my car out at interstate highway speeds (75 MPH) which makes me lose power steering and acceleration and has nearly ended in accidents numerous of times due to this.