2016 Hyundai Tucson: engine knocking or ticking

Filed Jul 28, 2026 · Engine, Transmission · FL

While stopped at a traffic light, the engine began producing a loud metallic clattering and clanking sound, consistent with connecting rod bearing failure (rod knock). There was no prior warning light or indication of this specific failure. When the light changed, the vehicle would not accelerate normally, leaving me stalled in a lane of moving traffic. I was forced to make an emergency turn to get the vehicle out of the way of oncoming and crossing traffic. The engine would not hold an idle afterward and has not run since. The vehicle was towed to a Hyundai dealership, where a service department employee stated by phone that this 1.6L turbocharged engine family has a known, documented history of severe factory defects affecting the connecting rod bearings.

Filed Jul 1, 2026 · Engine, Transmission · PA

While driving, the vehicle experienced a sudden and severe loss of motive power accompanied by a loud, catastrophic internal knocking sound from the engine compartment. The vehicle was towed to an authorized Hyundai dealership (Piazza Hyundai of Limerick), where a certified diagnostic technician confirmed a severe internal connecting rod bearing failure (rod knock). This sudden engine failure creates a significant highway safety hazard due to the immediate loss of acceleration and power steering/brake assistance if the engine completely seizes while operational. Hyundai has issued widespread safety recalls and a 15-year/150,000-mile extended warranty (TXXM) for this exact failure mode in other engine displacements (such as the 2.0L Nu GDI), yet they have excluded the 1.6L Turbo engine from identical coverage despite it suffering from the exact same manufacturing defect and presenting the same public safety risk.

Filed Jun 4, 2026 · Engine · SC

Oil consumption engine ticking hesitate to change gears poor acceleration.

Filed May 2, 2026 · Engine · TX

The engine in this 2016 Hyundai Tucson has experienced progressive failure symptoms consistent with the known rod bearing defect covered under Hyundai's engine warranty extension campaign. Symptoms include: excessive oil consumption requiring frequent top-offs over several months, severely degraded acceleration, failure to upshift under load, and an audible metallic crunching noise occurring around 4,000 RPM. A knock sensor fault code (P1326) was previously triggered (on 2/16/26), confirmed by a mechanic (on 2/17/26), and cleared. The dealer was visited (on 2/17/26) and refused to perform the campaign repair, stating no active code was present at that time. The vehicle is available for inspection. The problem has not been confirmed by the dealer despite a visit; the dealer declined to act citing absence of an active code. The vehicle has not been inspected by police or insurance. Warning symptoms include the prior knock sensor code, oil consumption, loss of power, and the current mechanical noise. Symptoms first appeared several months ago and have progressively worsened. The dealer's refusal to act under the existing campaign despite documented symptoms has left this vehicle in a dangerous condition on public roads.

Filed Mar 23, 2026 · Electrical, Engine · FL

I am writing regarding the diagnosis provided for my vehicle [XXX] . I was informed today that the engine failure is being attributed to a "water hose failure" rather than the engine defects covered under the active safety recall/settlement regarding Connecting Rod Bearing failure. As there were no coolant leaks before or after the vehicle was towed to your dealership. I am formally requesting a re-evaluation and more detailed evidence. Given the known history of these engines seizing, I need to ensure this diagnosis is absolutely correct and not a symptom of the internal defect. I request the following information be provided immediately: 1. Evidence of Overheating: Did the vehicle store any specific "overheating" codes in the ECU prior to the engine shutting off? 2. Oil Pan Inspection: Has the oil pan been removed to inspect for metal shavings or debris? If the connecting rod bearings failed (the recall issue), there will likely be metallic debris in the oil, regardless of the condition of the water hose. 3. Bearing Clearance Test (BCT): Was the mandated Bearing Clearance Test performed? If not, I request that this be done, or that a teardown be performed to inspect the rod bearings specifically. 4. Causal Link: Can you provide evidence that the water hose failed causing the engine to seize, rather than the engine seizing causing a pressure spike that damaged the cooling system? I have no transportation to work and school. They would not honor a loaner. This has happened since Decemeber of 2025. I await your written response with the requested photos and technical data. My case # with Hyundai Consumer Affairs # XXX Please provide: All relevant photographs Freeze-frame and ECU data Technician diagnostic notes Results of oil pan inspection and/or BCT (if performed) Any physical evidence supporting the stated cause of failure I request this information be sent in writing at your earliest convenience. Thank you for your attention to INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U

Filed Mar 18, 2026 · Engine · CA

Vehicle: 2016 Hyundai Tucson Issue Category: Engine / Powertrain / Vehicle Safety Complaint: I am reporting a serious safety issue involving my 2016 Hyundai Tucson equipped with a Theta II engine. My vehicle first displayed an engine oil warning light. I immediately took the vehicle to an authorized Hyundai dealership, where I was charged approximately $500 for an oil change and diagnostic testing. I was told there were no issues with the vehicle. Within approximately 20 miles of leaving the dealership, the vehicle suddenly entered limp mode while driving and displayed diagnostic code P1326. This created a dangerous situation as the vehicle lost power unexpectedly. I returned the vehicle to the dealership, where a software update was performed. However, within another 20–30 miles, the exact same issue occurred again, with the vehicle entering limp mode and triggering code P1326. Hyundai has now refused to repair the engine under warranty and is attempting to attribute the issue to a catalytic converter problem, despite the presence of code P1326, which is associated with engine rod bearing failure and is part of a known defect affecting these vehicles. This condition presents a significant safety risk, as the vehicle can lose power suddenly while driving, increasing the risk of a crash. I believe this issue is directly related to the known Hyundai Theta II engine defect, which has been the subject of recalls and a class action settlement. I am requesting that the federal safety agency investigate Hyundai’s handling of these failures and their refusal to repair vehicles experiencing known engine defects that pose a safety risk

Filed Mar 2, 2026 · Transmission · MA

My car had a KSDS knock sensor detection system campaign 966 installed in 2022 specifically to active if having rod bearing wear. Towed my car to Hyundai under the TXXM warranty and they said my bearing clearance was ok and i need new lifters and timing chain cost for repair $2900. I have asked for the full rod bearing wear test report and they will not provide it. They have had my vehicle for 20 days now and I am out of work on disability. Hyundai service center is generally expected to provide you with a report following a rod bearing wear test (often referred to as a Bearing Clearance Test or by a related service campaign, such as T6G or TSB 21-EM-004H). Here is what you can expect regarding reports and documentation: Documentation of Results: The dealership should provide a copy of the results, specifically noting if the bearing clearance passes or fails. Proof of Inspection: If the test is performed under a recall or Service Campaign (e.g., Campaign 966, 982, or T6G), they are required to document the inspection, which you can request for your records. Evidence of Damage: If the test results in a failed diagnosis, technicians often take photos of the engine internals, such as metal flakes in the oil pan or excessive wear, which are used to support the warranty claim. If the Test Passes: If your vehicle passes, ask the technician to print a copy of the results. If the Test Fails: A formal diagnosis of rod bearing failure, confirmed by this test, is required for engine replacement under the extended 15-year/150,000-mile warranty. Hyundai - Recalls +3 This is a safety issue without the full rod bearing report to consumer. Thank you for upstanding, [XXX] cell - [XXX] email - [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Feb 3, 2026 · Engine, Transmission · 125,000 miles · OH

The contact owns a 2016 Hyundai Tucson. The contact stated that the check engine warning light was illuminated, and there was a ticking sound coming from the front of the vehicle. The vehicle was taken to Auto Zone, where a mechanic diagnosed the vehicle with a knock sensor failure. The knock sensor was replaced. The mechanic informed the contact that the vehicle was included in Manufacturer Campaign: CS966 for the transmission control module (TCM). The vehicle was taken to the dealer, who confirmed that the vehicle was included and the software update was performed. After the vehicle was repaired, the check engine warning light was no longer illuminated; however, approximately 30 minutes later, the vehicle failed to exceed 35 MPH, and the check engine warning light started flashing. The vehicle was returned to the dealer, and the contact was informed that the software update caused the vehicle to enter LIMP Mode to protect the engine. The dealer informed the contact to drive the vehicle for 30 days or a total of 500 -1000 miles, and if the vehicle continued to enter LIMP Mode or failed to operate as needed, to return the vehicle for the engine to be replaced. There were no additional repairs performed. The manufacturer was not informed of the failure. The failure mileage was approximately 125,000.

Filed Jan 15, 2026 · Engine · WV

The car has been diagnosed with internal engine failure by both an independent service center and a dealership service center. The issue was described as a rod timing issue causing knocking, leading to failure of the engine. A light was not on for a majority of the issue but did start flashing before car became completely undrivable. The car was sold to me with this issue and has been driven for nearly 3 years with a power loss issue that was dismissed as turbo lag or other issues. Driving a car with this issue that does not alert with a check engine light is a major threat to driver and passenger safety as it can result in engine seizure and vehicle fires. The engine issues began at the least before 58,000 miles, with total failure occuring at roughly 96,000 miles. Hyundai is known for this issue, particularly in turbo model engines. Only once during ownership of the car did the check engine light come on prior to engine failure. When checked, it was described as a catalytic converter issue. The service center also did an oil change on the car, and the light went off. The check engine light did not come on again for more than a year. The check engine light did not come on until after the issue was diagnosed by the independent service center it was taken to in January 2026.

Filed Dec 14, 2025 · Engine · VA

My motor has a knocking/tapping noise that is obnoxiously loud. My oil level is always changed on time every 3k miles. I have 146,257 miles on my vehicle. I was informed from my mechanic shop that many of the 1.6L motors have issues. I have never had an engine noise then boom its knocking. I was informed not to drive my car to further damage the vehicle. I do not drive it but now am stuck in a loan for a vehicle I cannot drive. I had zero warning for this matter.

Filed Nov 21, 2025 · Engine · PA

Part(s) Affected: Engine / Engine Control / Stall / Loss of Power Summary: My 2016 Hyundai Tucson (VIN: [XXX] ) has an active P1326 – Knock Sensor Detection System (KSDS) code, which indicates rod bearing wear and imminent engine failure. The vehicle experiences: •loss of power •inability to accelerate •engine hesitation •risk of stalling while driving These are serious safety risks. This issue is part of the Hyundai/Kia engine defect settlement XXX), yet Hyundai refuses to provide towing or address the safety risk despite the P1326 code being a known precursor to engine seizure. The vehicle is currently unsafe to drive, and Hyundai Customer Care has refused to escalate my case according to settlement requirements. This is a safety hazard that can cause engine seizure and sudden loss of power while driving. Details: •Hyundai Case #: XXX •Engine settlement code P1326 confirmed •Hyundai refusing proper support •Vehicle should not be driven the federal safety agency intervention is needed due to Hyundai’s failure to address a known safety defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Nov 7, 2025 · Engine · IL

My 2016 Hyundai Tucson has a severe engine defect that causes excessive oil consumption and poses a safety risk while driving. It constantly throws the P1326 engine issue, which is the knock sensor.The issue is not due to any misuse or neglect on my part. The vehicle consumes approximately one quart of oil per week, and I have been advised by two different Hyundai dealerships not to invest any money into repairs because the engine should be replaced under Hyundai’s extended engine warranty (15 years/150,000 miles).Despite multiple attempts to get the issue resolved over the past year, Hyundai continues to deny the engine replacement, leaving me with no resolution and forcing me to drive an unsafe vehicle.The engine burns an excessive amount of oil and needs frequent refilling to prevent damage.The vehicle has stalled and runs rough at times, creating a safety concern.Both Hyundai dealerships I’ve visited confirmed that this is a known issue and advised me not to spend money on repairs since the engine qualifies for replacement under the extended warranty.Hyundai corporate continues to deny coverage and has not repaired or replaced the engine despite the clear warranty terms.The issue has persisted for nearly a year, and the vehicle continues to deteriorate.I believe this defect poses a serious safety hazard because the engine can fail without warning while driving. The excessive oil consumption also increases the risk of engine seizure, stalling, or fire. I am currently forced to operate the vehicle in unsafe conditions due to Hyundai’s inaction. I am requesting that the federal safety agency investigate this ongoing engine defect and Hyundai’s repeated denial of warranty coverage for affected Tucson models. Owners should not be forced to drive unsafe vehicles or pay for repairs that should be covered under Hyundai’s extended