2013 Jeep Grand Cherokee: check engine light

Filed Mar 30, 2026 · Electrical, Engine · 105,537 miles · MT

The contact owns a 2013 Jeep Grand Cherokee. The contact stated that while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to the dealer; however, no cause for the failure was found. The dealer informed the contact that the battery charge was extremely low. The vehicle was not repaired. The contact stated that the failure persisted. The vehicle was taken back to the dealer, and was informed that the alternator had failed. The alternator was replaced. The contact stated that on a separate occasion, while stopped at a traffic light, the vehicle sputtered and stalled. The vehicle was pulled over to the side of the road. A tow truck arrived on the scene, and while the tow truck driver was attempting to jump-start the vehicle, sparks were coming from the battery. The tow truck driver became aware that the alternator was red hot, and the wires surrounding the alternator were burned, with a burning odor coming from the vehicle. The tow truck driver did not jumpstart the vehicle due to safety concerns. The vehicle was pushed onto the flatbed truck. The vehicle was towed to the residence and had not been driven since. The contact related the failure to the federal safety agency Campaign Number: 17V435000 (ELECTRICAL SYSTEM); however, the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was unknown.

Filed Nov 10, 2025 · Electrical, Engine · NY

- The core component that failed is the Totally Integrated Power Module (TIPM). The failure was initiated by a fault in the external fuel pump relay (V62 Safety Recall remedy part), which caused improper power delivery. This improper power delivery subsequently damaged the fuel pump motor, requiring replacement of both components. This failure has cascaded, also disabling the circuits for the Engine Cooling Fan (Codes P0480/P0693) and Exterior Lighting (Headlights/B1630), and the Horn. I am in possession of the burnt-out fuel pump relay/fuse component. -The engine stalled while the vehicle was operating, the exact hazard the V62 recall was meant to prevent. This was followed by a catastrophic TIPM breakdown, creating new, simultaneous safety risks: Overheating/Fire Risk: The Cooling Fan circuit failed (P0480/P0693), causing severe engine overheating. No Headlights: The Headlights failed (B1630), causing total loss of visibility at night. No Horn: The Horn failed, eliminating the ability to warn other drivers. - Yes. The initial engine stall and subsequent no-start condition (due to a blown relay fuse) were confirmed by an independent service center (Monro). The cascading failures (overheating, horn, lights) and the diagnostic codes (P0480, P0693, B1630, C2201-00) were confirmed on 11/1. - The vehicle was inspected by an independent service center (Monro), who returned the failed recall component to me (relay). Recommend it go to a certified jeep dealership. It is waiting to be towed there. -The first warning was a history of intermittent starting difficulty. On 10/23, the engine stalled while operating and immediately resulted in a no-start condition. The Check Engine Light illuminated after the subsequent failed restart attempts.

Filed May 28, 2025 · Engine · NV

There are several recalls on jeeps catalytic converter. I keep having on going issues with my grand jeep cherokee 2013. This vehicle should also have a recall like the others. This isn't cheap to fix. Can someone please help me with this on going issue with the catalytic converter. Engine light keeps coming on with the same code PO430.

Filed Apr 17, 2025 · Fuel system · MN

The V62 fuel pump recall was repaired in 2021. Recently this vehicle has had hard starts again, misfires, engine light came on. The vehicle was taken in to certified repair shop. The shop states cannot diagnose without tearing the only thing apart and a high expense. The shop believes it could be lifters or possibly cam but they are unsure even though the systems to this vehicle having a hard start and misfiring relates to this V62 fuel pump relay that is relates to the cam shaft sensor and causes hard starts and misfires. The car is not driveable more than a short distance. The vehicle is unsafe to drive due to the fact you do not know when this vehicle will stall or start again. The V62 recall pet fuel pump relay has malfunctioned. This part was repair but is a faulty part, a lemon, and the manufacturer should be standing behind this part and their product. I have discussed this with the repair shop and Chrysler/Jeep and now pursing with you due to the safety of this vehicle, the defective recall part, and the fact the manufacturer needs to stand behind their product.

Filed Jan 19, 2024 · Electrical, Visibility · MI

2ND, To continue with the issues of the vehicle lastly provided, while driving the check engine light come on and the traction control turns off, cannot turn back on using dash button, cannot access vehicle system on wheel, change display of dash view, windshield wipers are stuck on constantly, turn signals do not work nor does the hazard lights, vehicle is also stuck in 4x4 drive and cannot be taken out. Vehicle was taken to Preferred JCD of Muskegon MI and diagnostics were run with no clear diagnosis and no fix, suggestion was to replace TIPM box. Now Jan 2024 and vehicle still sits with issues and not driven.

Filed Dec 18, 2023 · Engine · 89,000 miles · MA

The contact owns a 2013 Jeep Grand Cherokee. The contact stated while driving 10 MPH, the vehicle started shuddering. The check engine warning light illuminated. The contact was able to drive to the nearby residence. The contact stated that her husband used an OBD reader to diagnose the vehicle and determined that cylinder #5 was misfiring. The contact stated that her husband replaced the fuel pump relay. The contact stated that after replacing the fuel pump relay, the OBD reader indicated that cylinder #7 was misfiring. The dealer was notified of the failure and informed the contact that the VIN was not included in a recall. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 89,000.

Filed Aug 3, 2022 · Electrical · 125,000 miles · MI

The contact owns a 2013 Jeep Grand Cherokee. The contact stated that the vehicle was taken to the dealer for recall repair under the federal safety agency Campaign Number: 19V813000 (Electrical System). However, three days after the recall repair had been completed, the check engine warning light illuminated while driving. The vehicle was taken back to the dealer where it was diagnosed that the Totally Integrated Power Module (TIPM) had failed. The contact stated that he had not experienced any failures with the vehicle prior to the recall repair. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 125,000.

Filed Jul 12, 2022 · Acceleration · NC

While driving my check engine light came on and then the electronic stability control light came on to show the system was off. I tried to accelerate but the car would not go any faster. I let off and moved to the right lane then pressed the gas again. It struggled to go but eventually did resume speed. This problem is intermittent because after I stopped for fuel, the light went away. After a few hours of driving, it came back on. Park the car and it sat overnight. Next morning started up and light was off. Took in for service and cannot get a code for repairs. Suggestion was continue driving in hopes the light will come back on. Could this be camshaft position sensors?

Filed Feb 13, 2022 · Electrical, Engine · AL

Yes the Jeep developed a stall while going down the highway then would crank and run for 3 or seconds and die again and that’s all it would do. Check engine light comes on as well as the lighting bolt on dash. I believe the fuel pump is part of the problem seeing how at a qt tank of gas it will die and only run when more gas is added but also the body control module cause it keeps throwing diff codes after I fix the issues. As well as the way it cranks n dies like security issue. This is very common for jeeps everywhere

Filed Jun 20, 2021 · Electrical · NY

I was driving on the highway.When thr check engine light and red electric bolt came on. The truck slowed down and didn’t accelerate good and traffic was flying past me and honking horn as I pulled over. I took to dealership was told it was the Accelerator pedal so replace it and reflashed system light cam back on now they saying throttle body or wiring harness is it a tsb or recall because my truck was fire

Filed Apr 21, 2021 · Electrical · 100,000 miles · LA

Tl* the contact owns a 2013 jeep grand cherokee. The contact stated that while driving at various speeds, the vehicle jerked and stalled while depressing the accelerator pedal. The check engine warning light was illuminated. The contact discovered that her VIN was included in the federal safety agency campaign number: 19v813000 (electrical system). Lakeshore chrysler dodge jeep ram fiat (330 e howze beach rd, slidell, la 70461) and rainbow chrysler dodge jeep llc (301 river highland blvd, covington, la 70433) were contacted and it was confirmed that the part was not yet available. The manufacturer was made aware of the issue. The failure mileage was approximately 100,000. Parts distribution disconnect.

Filed Mar 8, 2021 · Fuel system · 92,500 miles · TX

Recall v62/the federal safety agency 19v‑813. Fuel pump relay recall. Responded to the recall and a new wiring harness was installed. This has not fixed the problem. While stationary, vehicle has false starts almost on a daily basis. By false I mean car will crank but does not start. At times while in motion, vehicle will run sluggish and check engine light comes on. This is the second replacement harness installed .