2018 Ford Fusion problems

Filed Nov 5, 2026 · Transmission · FL

My 2018 Ford Fusion automatically shifts back into Park and displays the "Shift Sys Fault" error message, the primary culprit is a broken transmission shift cable bushing, which I had replaced, however the "Shift Sys Fault" is continuing to be activated.

Filed Oct 26, 2026 · Engine · 138,000 miles · MI

The contact owns a 2018 Ford Fusion. The contact stated that there was an abnormal sound coming from the rear of the vehicle. In addition, the engine made a bubbling sound after turning off the vehicle. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, where an engine misfire was diagnosed, and a fuel odor was detected. The mechanic determined that the engine had failed and needed to be replaced. The failure mileage was approximately 138,000.

Filed Oct 24, 2026 · Transmission · MO

My daughter was driving getting on the highway, went to accelerate and the car would no longer accelerate. AAMCO stated the internal pressure pump is failing and the transmission is losing pressure.

Filed Oct 5, 2026 · Engine · FL

My 2018 Ford Fusion suffered a sudden and complete engine failure caused by internal coolant intrusion — coolant leaking into the cylinders and destroying the engine. Pep Boys diagnosed that the failure developed internally over time and could not have been avoided by the owner. This is a known Ford factory defect in the 2.0L EcoBoost engine, documented in Ford's own publications (SSM 47204, SSM 47462, TSB 19-2346, TSB 22-2229), all of which cover the 2018 Fusion. The root cause is Ford's open-deck engine-block design, which allows coolant intrusion and cracking between cylinders. Ford corrected the design in 2019 production. A federal class action (Nelson et al. v. Ford, E.D. California) and the federal safety agency defect petition DP26008 concern this same defect. The sudden loss of engine power created an unsafe driving condition. My warranty claim was denied based on a 'blown head gasket' finding, which is the symptom of the factory defect, not the cause.

Filed Sep 30, 2026 · Engine · NC

Capital Ford of Wilmington diagnosed my vehicle with coolant intrusion into cylinder 2, accompanied by diagnostic trouble codes P0302 and P0316, after check engine light came on. I have been advised that the vehicle requires a complete engine replacement, with an estimated cost of $13,180.89. The vehicle has experienced sputtering and hesitation, creating concern that it could lose power or stall. These symptoms are concerning. After researching this issue, I have learned that coolant intrusion is a documented problem associated with certain Ford vehicles equipped with the 1.5L EcoBoost engine produced during the 2017–2019 period. Ford has addressed this issue through Technical Service Bulletins and Customer Satisfaction Program 21N12. I contacted Ford and was told that my VIN is not covered under the Customer Satisfaction Program. When asked why mine was not covered but other were , Ford stated that even if it is the same issue that is being recalled if my VIN is not flagged it will not be covered for any recall or assistance.I called Ford when I first purchase vehicle and asked about this recall and was told if I didn't have anything wrong with my car and no engine lights that my car was fine and to bring it in if I have any issues.

Filed Sep 25, 2026 · Engine · OH

My 2018 Ford Fusion Titanium FWD (VIN: [XXX]) suffered a catastrophic engine failure while driving, causing sudden vehicle overheating, severe engine misfires, and a dangerous loss of power on the roadway.A certified Ford dealership inspection (Invoice #XXX) confirmed that the vehicle has a textbook manufacturing flaw known as EcoBoost coolant intrusion. A pressure test showed an immediate 5 PSI drop within 10 minutes, and a borescope confirmed that engine coolant is actively leaking across the block interface and pooling directly inside the engine cylinders (cylinders 2 and 3).This is a known, widespread structural engineering defect in Ford's block casting that creates a severe, sudden safety hazard by causing vehicle stalling and clouding exhaust smoke while operating at highway speeds. The vehicle is now entirely unsafe to drive and requires a full engine block replacement. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 20, 2026 · Engine · KY

My engine coolant keeps on overheating, I’ve tried changing the antifreeze tank out for a brand new one and it helped the issue for a while but I have to relieve the pressure myself which is a hazard. I’ve had to change the coolant in the tank more than 5 times and it just seems like it’s leaking somewhere other than going into the engine to cool it. When I go out roundabouts off a highway the engine overheats and makes the car go into a safe mode where it won’t go and I have to stop on the side of the road. When I’m driving with my heat on the heat will go cold when I slow down. If I’m not going over 3x1,000 RPMs it will go cold and fluctuate. This has been going on for months now.

Filed Sep 9, 2026 · Transmission · MN

Got home and vehicle would not go into park. I can get it to drive but its only low range. Upon having it inspected, it was discovered the shift cable bushing at the transmission lever was missing.

Filed Sep 2, 2026 · Engine · 122,000 miles · MI

The contact owns a 2018 Ford Fusion. The contact stated that the check engine warning light was illuminated. Additionally, there was white smoke coming from the exhaust pipes. The vehicle was taken to an independent mechanic several times, and the contact was informed that the engine was consuming antifreeze. The ignition coils and spark plugs were replaced; however, the failure persisted. The mechanic associated the failure with the engine. The vehicle was taken to a dealer, where it was diagnosed and determined that the short block was warped and that the engine needed to be replaced. The vehicle was scheduled to be repaired. The contact researched the failure and stated that it was a known issue that the manufacturer had failed to correct. The manufacturer was notified of the failure via telephone; however, no assistance was provided. The failure mileage was approximately 122,000.

Filed Aug 26, 2026 · Engine · NJ

We have coolant intrusion in cylinder 2 of our engine. This can cause highway failure of engine cuts out, car runs rough and it can become a fire hazard. We paid for a diagnostics through a ford dealer. Who we uses all the time for our warranty needs. We noticed car was starting to run rough and check engine light came on 8/5/26