2020 Ford Edge: backup camera failure

Filed Jul 17, 2026 · Driver assistance · 98,000 miles · OH

The contact owns a 2020 Ford Edge. The contact stated that the rearview camera was inoperable. There was no warning light illuminated. The local dealer was contacted and confirmed that the VIN was not under recall. The vehicle had not been diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 98,000.

Filed Jun 10, 2026 · Fuel system · NC

rear camera keeps going blue and then will go out. But it will come back for a day or so and then go out again. I know this is a known problem on these vehicles and I need mine fixed. As well as the purge valve that has also been a known issue as well

Filed Mar 23, 2026 · Electrical, Engine · NV

Transmission Fluid Leak/Fire Risk (Recall 20S49): Certain 2020 Edge models have missing or loose bolts on the start/stop accumulator endcap, which can cause a leak and increase the risk of fire. Rearview Camera Failure (Recall 20V572000): A common issue where the rear camera may display a blank or distorted image, failing to comply with safety standards. Driveshaft Seizure (Recall 21S43): A potential lack of lubrication in the rear drive unit can cause it to seize, leading to loss of drive and vehicle control. Inoperable HVAC Blower Motor: A potential defect causing the blower motor to fail, which can hinder windshield defrosting. Power train alert not going into park break light issue

Filed Mar 11, 2026 · Driver assistance · 72,000 miles · WI

The contact owns a 2020 Ford Edge. The contact stated that while reversing in a parking lot, the rearview camera image failed to be displayed. The message “Camera not Available” was displayed. The vehicle was taken to the dealer and was diagnosed with the failure of the rearview camera image; however, the vehicle was not repaired. The manufacturer was notified of the failure, where it was confirmed that the VIN was not included in the federal safety agency Campaign Number: 26V123000 (Back Over Prevention). The approximate failure mileage was 72,000.

Filed Mar 6, 2026 · Driver assistance · FL

My backup camera has the same issue as the recall for the 2021-2024 Ford Edge. Why is my year not included in the recall?

Filed Oct 22, 2025 · TX

The back up camera for 2020 Edge model should be added to previous recalls. It is real foggy and sometimes it shows clear.

Filed Sep 16, 2025 · Driver assistance, Visibility · 60,000 miles · AL

The contact owns a 2020 Ford Edge. The contact stated that upon shifting into reverse(R), the rearview camera image displayed a white image on the screen. The contact called a dealer and was informed that the VIN was not under recall. The vehicle was not repaired. Upon investigation, the contact linked the failure to the federal safety agency Campaign Number: 20V575000 (Visibility, Back Over Prevention). The manufacturer was not notified of the failure. The failure mileage was approximately 60,000.

Filed Aug 12, 2025 · Driver assistance, Electrical · CA

The contact owns a 2020 Ford Edge. The contact received notification of the federal safety agency Campaign Number: 25V442000 (BACK OVER PREVENTION); however, the part to do the recall repair was not yet available. The contact stated that while his wife was operating the vehicle, the rearview camera displayed a distorted image while in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. In addition, the touch-screen icons failed to function as intended. The contact stated that the failure occurred every 4 hours. Most recently, the controls to open the sunroof failed to function as intended. The contact stated that the failure was intermittent. The contact stated that while operating the sunroof, there was an abnormal sound coming from the sunroof. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was unknown.

Filed Jun 20, 2025 · Electrical · KY

For last 3+ years Rear reverse camera remains blank and screen becomes unresponsive Unable to use steering wheel buttons to change radio station or volume. Can get working again by performing a system reset (press seek and volume knob) Took to Ford dealer for the camera recall 20C19 when recall first came out. As parts were not available, dealer stated they could not apply fix Due to work schedule, finally able to reschedule in Dec 2024. After fix had been applied, reverse camera continues to stay blank and inoperable. Took back to Ford dealership. Dealership stated this was not under the recall as it is caused by a bad apim module. Warranty had expired by this time so that did not cover this either. The end failure symptom is the same as the recall but not caused by the same component therefore is not covered. Cost to replace is >$1000 so not affordable to repair. Had a few close accidents caused by the lack of reverse camera function. Vehicle is available for inspection. If the end failure is the same as that caused lack of safety requiring a recall, why would the apim module also not be replaced under recall?

Filed Jun 3, 2025 · Driver assistance, Visibility · FL

The rear view camera glitches and the display is either blacked out or scattered. The motion sensor does not always work when this happens. I was not aware of an on coming car while backing up causing a safety risk. The screen will start glitching and become distorted while I am already backing up, making it hard to know where the objects are. There are not any warning lights to indicate a problem. I brought the car to the service center at the dealership from where I purchased it, They said I would have to pay for a new camera. I did not do that because there is a recall in the 2021 model and other Ford vehicles for the same issue .

Filed May 28, 2025 · Driver assistance · 65,000 miles · FL

The contact owns a 2020 Ford Edge. The contact stated that on several occasions while in reverse, the rearview camera image was black with wavy lines, and a distorted image. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 65,000.

Filed Mar 13, 2025 · Engine · TX

This is the results of a malfunctioning that occurred on this vehicle: Cause VERIFY CONCERN FOUND WHINEING NOISE WITH INTERMITTENT NO ENGAGEMENT CONDITION. INTERNAL METAL GRINDING CAN BE HEARD. METAL PARTICLES CONTAMINATING FLUID INDICATING MAJOR INTERNAL FAILURE. RECIEVED DTCS P073D UNABLE TO ENGAGE NEUTRAL, P0761 SHIFT SOLENOID C STUCK OFF, P07E4 UNABLE TO ENGAGE PARK, P07E6 STUCK IN PARK, AND P2707 SHIFT SOLENOID F STUCK OFF. Correction REPLACE TRANSMISSION UNIT, TRANSMISSION COOLER AND FLUSH TRANSMISSION COOLER LINES OF CONTAMINATION. ENTER NEW TRID DATA INTO PCM AND PERFORM TRANSMISSION ADAPTIVE DRIVE CYCLE. RETEST. I contacted the Manufacturer and was given recall program 20B39 to be performed on the vehicle as well. 1: Distorted or inoperative rearview camera, which can reduce rearward visibility and increase the risk of a crash.